SOURCE: specs for a 1997 Ford Ka 1297 cc
If the vehicle is fitted with a Rocam engine, the valve clearance is not adjustable, hydraulic lifters.
The camshaft caps are torqued in two stages, first 10Nm and than 90 degrees
SOURCE: Head gasket torque specs
Here you go, I hope this is what you were looking for:
For 1987-94 models, the cylinder head bolts are tightened in 3 progressive steps. Tighten them in the proper sequence as follows:
Step 1: 50-55 ft. lbs. (68-75 Nm)
Step 2: 60-65 ft. lbs. (81-88 Nm)
Step 3: 70-85 ft. lbs. (95-115 Nm)
Let me know if I can assist you with anything else.
SOURCE: head bolt torque spec
STARTING OUT YOU HAVE TO REPLACE THE OLD BOLTS DUE TO STRETCHING.BESURE TO USE NEW BOLTS LUBRICATE NEW BOLTS IN OIL.BESURE TO USE TORQUE SEQUENCE GUIDE OR PHOTO.YOU GOING TO MAKE THREE PASSES * FIRST* PASS YOU TORQUE ALL HEAD BOLTS TO 12 TO 18 FT LBS * SECOND *PASS YOU TORQUE ALL BOLTS TO 26 TO 33 FT LBS.*THIRD PASS YOU TORQUE IT TO 44 FT LBS.THATS THE FINAL TORQUE.
SOURCE: what are the torque specs for head bolts on a
YOU HAVE TO MAKE 2 PASS. ON FIRST PASS TORQUE HEAD BOLTS TO 37 TO 50 FT LBS. ON SECOND PASS TORQUE 62 - 68 FT LBS.
629 views
Usually answered in minutes!
×