Question about 1995 Plymouth Voyager

1 Answer

1995 plymouth coolint leak

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Plymouth Master
  • 5,655 Answers

There are some simple tools you can borrow from the major autoparts stores to find this leak. Although the leak can be someplace other than the Radiator, the device is a Radiator Pressure Tester.
You simply use a slightly warmed engine and remove the Radiator cap. Then look at the pressure rating on the old cap. Use the tool and pump some pressure into the radiator, not to exceed the rating on the cap.
If you have a leak at all on the outside of the engine, the pressure will force the water out of the leak and you can find and replace the bad part.
If you use it this way, it is quite simple. But bad things can happen inside motors. Sometimes their gaskets leak inside the motor and the water may go through the cylinders or into the oil. You will see the loss of pressure on the tool but see no fluids on the ground.

Often, the engine will run very rough when cold or may miss continuously from fouled sparkplugs. Do not worry about this worst case senario unless this is what your vehicle is doing. Contact us at Fixya for further advice once you discover your problems.

Posted on Feb 23, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Should i see foam and bubbles in my coolint when i take off the radiator cap?

foam and bubbles indicates head gasket problem
have a compression test done

Jan 20, 2018 | 1990 Ford Thunderbird

1 Answer

1995 plymouth acclaim-hight idle/where and how do I get to the ilde(high) screw? Thank you.

A 1995 Plymouth Acclaim is a fuel injected vehicle which means it does not have an idle screw like the older carbrated cars. Instead your cars idle is controlled by sensors and the cars on board computer. There is a chance you either have a bad sensor or a vacuum leak some where. Both will cause a high idle. I hope this helps you out.

Aug 25, 2011 | 1995 Plymouth Acclaim

1 Answer

I have a 1995 plymouth neon with a 5 speed . it is really getting hard to shift when engine is running. shifts easy with engine off. clutch problums or not code D

You may have drawn air into the hydraulic line. Check the fulid level in the clutch reservoir. If it's low, look for a leak (usually it's the slave cylinder at the transmission that starts leaking. Please get back to me after your visual inspection for further advice.

May 07, 2011 | 1995 Plymouth Neon

1 Answer

My 1995 Plymouth Voyager is leaking oil from right side of motor.there's a pressure seal there.

that is a main (crankshaft) seal. you"ll have to remove serpentine belt, pulleys and timing cover,pry seal out and tap new one in softly with a hammer and socket same diameter as out part of new seal, make sure it goes in straight and reassemble all the way took apart. should be good to go and hope this helps

Dec 30, 2010 | 1995 Plymouth Voyager

1 Answer

I'm leaking coolint from the bottom of my truck and coolint leaked on to my floor inside I need to know how to bypass my heater core thank you for your help and time Oh ya almost for got I have a 2000 gmc...

Purchase a 5/8 to 3/4 hose union and connect the two heater hoses to it. Just remove the two hoses from the heater core to do this. You will not have heat this way although the leak will be fixed
The union can be purchased at most NAPA Auto parts Stores

Aug 07, 2010 | GMC Sierra 1500 Cars & Trucks

1 Answer

Oil in my coolant system

it is likely the head gasket. it's seeping oil into the cooling system.

Jul 18, 2010 | 1995 Plymouth Neon

1 Answer

Im leaking coolint out of bottom of motor. is it an oil cooler?

Oil coolers have oil passing thru them not anti-freese. If its coming out of engine and not radiator it could be a bad frost plug, a leaking head gasket or a leaking intake manifold gasket.

Apr 29, 2010 | 1998 Isuzu Rodeo

1 Answer

Strong smell of coolint and leaks from area around heater core

most common cause of this is the water pump leaking at the shaft seal.

Oct 26, 2009 | 1989 Lincoln Town Car

1 Answer

I have a 1995 plymouth grand voyager le 3.8l no vac leak

Check connections on IAC or AIS motor. Same thing.
If connection is o.k. try pulling IAC off & cleaning it & port it came out of with throttlbody spray cleaner, and re-install & try it again.

Oct 16, 2009 | 1995 Plymouth Grand Voyager

Not finding what you are looking for?
1995 Plymouth Voyager Logo

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides