Question about 1999 Mitsubishi Montero Sport

Open Question

How do I override the remote alarm to get the car started

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 crown Victoria. viper alarm kill switch has turned all power to car. How do I reset


there is no override. Otherwise it would defeat the point of an immobilizer. I would find out why the alarm went off and deal with the rot cause rather than trying to bypass something made to be un-bypassable.

You may be able to reset the alarm by unplugging the battery from the car for a minute or 2 but I would start with the alarm manual to be safe. Possibly even remote the alarm and put the wiring back to stock.

Oct 16, 2016 | 1997 Ford Crown Victoria

1 Answer

My car won't start due to my alarm went off when I stuck my key in the door


You have to disarm the alarm first. The alarm has an immobilizer that will prevent the car from running if the alarm has been tripped. Usually there is an override button under the dash somewhere. The key usually has to be in the ignition and turned on while holding the button. Otherwise, unlocking it with the FOB (key-less remote) will usually reset it too.

Feb 02, 2016 | Cars & Trucks

1 Answer

I lost the remote to my Hyundai Accent 2006 model car. The alarm has not been activated for a while, which was fine, but yesterday it had somehow been reactivated and now i can't switch it off (no remote)...


contact a hyundai dealership as there is a procedure you can carry out and i cant quite remember it exactly it involves turning ign on but not starting engine and pressing a button ,thats the part i can't quite remember fully but a hyundai dealership will know

Apr 27, 2014 | Hyundai Accent Cars & Trucks

1 Answer

2001 mitsubishi eclispse gs wont start how do you bypass the security system


  • 1 Turn the ignition key counter clockwise in the driver's side door to unlock the caricon1.png. This deactivates the alarm long enough for you to gain access to the vehicle. Then, place the key in the ignition and turn the key until it clicks once. This starts the car's battery, but doesn't ignite the engine. The LED light on the dashboard should stop blinking, indicating the alarm is temporarily disabled.
  • 2 Locateicon1.png the box for the alarm under the dashboard on the driver's side of the car. Then, look for the override button on the box. Typically, the small button is either red or black. With the ignition key in the "on" position, press the override button and hold it in until the alarm chirps once. This disables the alarm until you manually reactivate it.
  • 3 To reactivate the alarm, turn the key to the "on" position and press the override button once. The alarm chirps twice, indicating the alarm is active.

  • Hope this helps!

    Mar 15, 2014 | 2001 Mitsubishi Eclipse

    1 Answer

    How do I reset alarm 2001 honda civic


    Have you tried using the valet override, [disarm without remote] switch?

    Have you checked to make sure remote start switch is on?

    Oct 26, 2012 | 2001 Honda Civic

    1 Answer

    Alarm is armed, and I dont have a remote.I need to manually dissarm the alarm or my car will not start


    Open the door, the alarm will sound , go under your dash, normally installation techs will install a kill switch or alarm override button either in the drivers side kick panel to the left of were your left foot rests or inside the fuse box panel, under the steering column or by the center column somewhere but most likely the drivers kick is the spot. So open the door and find the kill switch or override button and put the key in the ignition turn it to the on position without cranking and press or toggle the switch after you turn the key, this should override the alarm and let you start the vehicle, otherwise you have to remove the alarm main fuse from the brain and rewire your starter kill to factory so that you can start your vehicle normally again until an alarm tech corrects the alarm wiring.

    Good luck my friend, hope it is helpful.

    Jun 12, 2010 | 2002 Oldsmobile Alero

    1 Answer

    Imobiliser problem


    If im not mistaken,your car should have an alarm reset/override.Below the steering column,on the dash should be a slot where you put your remote transmitter to deactivate the alarm.If that works,you then need to have your remote checked and coded by a vw dealer.Good luck.

    Jun 16, 2009 | 1997 Volkswagen Golf

    1 Answer

    Alarm haywire, can't override anti-theft system or turn on car


    The Alarm on my Mercedes ML320 sounded every night, then it started doing it more often, Showed it to the dealer he says it's the 'Tow Sensor', that needs to be repaced. $700, down the drain. I have already started hating this car, it eats $500-600, every 6 months...

    Dec 25, 2008 | 1998 Volvo S70

    1 Answer

    Can you override and start the 2002 chevy blazer without remote?


    a factory keyless entry will not have an override but it does not disable starter.if you are have security issues it is problem with passlock system. if it is aftermarket alarm system then there is a button somewhere but varies where installer put it

    Dec 10, 2008 | 2002 Chevrolet TrailBlazer

    Not finding what you are looking for?
    1999 Mitsubishi Montero Sport Logo

    Related Topics:

    90 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Mitsubishi Experts

    yadayada
    yadayada

    Level 3 Expert

    75807 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22133 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8172 Answers

    Are you a Mitsubishi Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...