Question about 2008 Dodge Charger

Open Question

How to replace dodge charger 2006 side mirror bracket

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76848 Answers

SOURCE: 2006 Dodge Charger

this is not normal if you are not an aggressive driver, if you really drive the car hard then yes it is normal, since it is an R/T I will assume you are the latter. Rotors get damaged from heat of hard braking and warp making the brake pedal pulsate or the front end shake or both when the brakes are applied, is this your issue? if so take it easy on the brakes, make less aggressive stops. You could go to aftermarket HD brakes (rotors, pads), check on line for these kinds of parts, many companies sell them.

Posted on Oct 08, 2008

Ad
  • 840 Answers

SOURCE: passanger side mirror replacement on 04 dodge ram 1500?

very easy take the mirror inside cap off if you can not get to the 3 bolts then you will have to take trim panel off to take trim panel off look for plastic caps take them out and unscrew them then pop out the bottom of the door and pop the sides out then lift up and out should be loose enough for the bolts now/ 10mm bolts 3 Please rate my response thank you very much

Posted on Feb 02, 2009

  • 1 Answer

SOURCE: Replacing passenger side-view mirror on 1999 Dodge Stratus

Watched my dad do it this afternoon. There is an exposed screw on the left side of the door panel and one at the bottom of the panel. There are also two hidden screws, one behind the door handle and one inside the little hole in the armrest (pop off the plastic plugs). There are also three recessed screws behind the speaker cover. You can pop the speaker cover off with a flathead screwdriver. I'm pretty sure thats all of them. You can pop the panel off then, but watch the wires connecting stuff inside. The hardest part is getting it over the door lock. .

Once the panel is loose you have to pop off the black plastic cover hiding the back of the mirror. There are three recessed bolts holding the mirror. My dad had to get a special wrench to get those off and he dropped one inside the door, so be careful (we fastened a magnet to a coat hanger and got it back). Mine had some remote gizmos, so he had to had to unplug the little square thing and then popped off what was left of the old mirror. If your new mirror has a wire with a little box, feed it through the hole and plug it in. Once you have it positioned correctly, you can screw on the bolts and put eveything back together. It helps to have another person there while you are trying to position the mirror correctly. Hope I didn't miss anything. Good luck!

Posted on Apr 23, 2009

  • 398 Answers

SOURCE: Passenger side mirror replacement

you should be able to take it off from the inside of the car directly behind were the mirror is. usually ther eis a molding cover ing the mounting screws . take off the molding , mabey a few screw then some body clips that just snap off. now you should unplug the harness if necessary and remove the three or four bolts that hold the mirror on, and that should be it. hope this helps

Posted on May 17, 2009

  • 10 Answers

SOURCE: How to tighten side mirror. 1996 dodge ram 1500 manual mirrors

take door pannal off there should be 3 bolts in the inside of the door where mirror sits unless its the reflection peace where you have to just get a new mirror

Posted on Jul 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Driver rearview mirror detached from its holder


Dismantle the mirror bracket. You probably wont be able to get this back in without doing this.

Mar 02, 2014 | 2006 Subaru Forester

1 Answer

How to replace a side mirror on a 2007 charger


how do you change side rear view mirror on drivers door

Jul 05, 2012 | 2007 Dodge Charger SE

1 Answer

There's a clucking noise coming from the front driver side of my 2006 Dodge Charger R/T. What could possibly need replacing if I already changed the tie rods and brake pads?


Stabalizer links. To check them you will need to have both front tires off the ground at the same time. Grab the stabilizer bar where it attaches to the link. Push up and pull down on the bar. If you feel any movement replace them. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Jan 20, 2012 | 2006 Dodge Charger

1 Answer

How To Replace A Side Mirror On A 2008 Charger


Check this procedure about 2006-2009 Charger.

Hope helps (remember rated this).

Jul 14, 2010 | 2008 Dodge Charger

1 Answer

2006 Grand Caravan: Is it hard to replace passenger side mirror (whole...


It's not that hard to replace the passenger side mirror. You will be able to do it yourself. I will tell you how. Remove the screw holding the molding to the base of the mirror and remove the molding. Remove the screws and detach the mirror. (if it is electric mirror just unplug the electrical connector. Installation is the reverse of removal. Hope this will help you.

May 18, 2010 | 2006 Dodge Grand Caravan

1 Answer

I have Toyota Rav D4D . The bracket holding electric mirror on passenger side snapped. (The screws holding mirror have been removed but need to disconnect the wiring from mirror and get a new or repair...


did you sort this out cause im having the same problem? need to replace only the mirror mount, not the glass, motor or housing. have a feeling im going to have to buy the whole shabang

May 19, 2010 | 2006 Toyota RAV4

1 Answer

The right side mirror on my dodger charger has been knocked loose. How do I reattach it?


The mounting bolts are most likely stripped if it was knocked loose however, to access them you are going to have to remove the inside door cover and if there is a small triangular cover over the area of the mirror you will need to remove that cover as well. In the door cover there should be 4 to 6 screws that must be removed then the cover is pryed off. Be careful as you move a little at a time till you find each push pin. these pins are cheap and may need replaced after removed depending on how damaged they are during the removal.

May 11, 2010 | 2006 Dodge Charger

2 Answers

2006 dodge charger 3.5 change spark plugs


Normal 0 MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman";} INSTALLINGS SPARKPLUGS ON 2006 DODGE CHARGER 2.7 / 3.5

Step 1: Disconnect the negative wire to the battery. I did this to be safe.

Step 2: Disconnect the oxygen sensor from the air intake. Do not pull from the wires only pull from the boot. Be careful not to break the sensor either


Step 3: Pull the tube connected to the left side of the air intake off then remove the air intake.


Step 4: Disconnect the map sensor and all other electric components that are attached to the manifold


Step 5: Disconnect the cable that is connected to the throttle body (you do not have to take the throttle body off of the manifold to do this).


Step 6: On the left hand side of the manifold there are 2 manifold support brackets loosen them up but do not take them off. When they are loose just pull the top part of the bracket that is connected to the manifold back and off the screws. .


Step 7: On the right hand side of the manifold there is another support bracket that is connected to the throttle body. First take off the screws then where the support bracket connects to the cylinder bellow the manifold loosen the two bolts until you are able to slide the bracket out of the way.


Step 8: On top of the manifold there are six bolts unscrew them.


Step 9: Important! Before you remove the manifold to get to the spark plugs be very careful and remove the manifold by lifting it straight up and then pull it towards you slow. The reason for this is because there is a valve connected to the manifold directly in the back that you do not want to break. The tubes that are connected are long enough so you can take the whole manifold and place it to the right just out of the way so you can get to the spark plugs. (before changing the spark plug it is recommended that you take compressed air and blow away the dirt surrounding the spark plug area. This is done so that no dirt gets into the combustion chamber when you remove the spark plug.)


Step 10: Once the manifold is out of the way disconnect the electric connectors that are attached to every spark plug. Pull them from the boot of the connector.


Step 11: Unbolt the spark plug tube then pull it straight out and then with the spark plug socket unscrew the spark plug and replace it with a new one (repeat 6 times).


Step 12: After the spark plugs are in on the left hand side of the engine in the back you will see a tube that says pcv. Remove the tube from the engine and unscrew the valve and replace it with a new one.


Step 13: Put everything back and you are good to go.
Once again thank you and I hope this was helpful.

Feb 17, 2010 | 2006 Dodge Charger

2 Answers

Where is EGR Valve located on a 2006 dodge charger 3.5L pic would be helpful


to find the egr valve you will have to remove the purge soleniod from the bracket.

1. EGR tube
2. EGR Valve



8cd5dac.jpg

Oct 04, 2009 | 2006 Dodge Charger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...