Question about Cars & Trucks

1 Answer

Were is egr vavule on 2005 dodge durango - Cars & Trucks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 17,970 Answers

Hi there:
The electronic EGR valve and solenoid assembly, is attached to the rear of the left cylinder head. An exhaust gas routing tube connects the EGR valve to the intake manifold:
Disconnect and isolate the negative battery cable.
Remove plastic windshield cowl panel.
Remove windshield wiper motor.
Remove electrical connector (5) at top of EGR valve solenoid.
Remove tube mounting bolt (1) at intake manifold

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Posted on Feb 23, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

freetek
  • 5568 Answers

SOURCE: Location of EGR valve on 2005 Dodge Durango

If I had been him, I would have talked you into a Chilton or Haynes manual for your car. They are easily detailed enough to show you the location and  Iwould be surprised if a chain operation like AZ didn't have the right one on hand.

Posted on Dec 15, 2008

  • 116 Answers

SOURCE: egr valve dodge durango

if this is a 4.7l engine, the valve is on the left rear of the intake. loosen the 8mm bolts that hold the egr intake tube to the egr valve, remove the egr bolts, disconnect wiring, remove valve and tube together, attach intake tube loosely to new valve, install new valve, tighten tube bolts to egr using a swivel socket, this is not a 5 minute job, so dont attempt unless you have some time and patience.

Posted on Apr 24, 2009

USfalcon
  • 175 Answers

SOURCE: 2005 Dodge Durango

The p0300 What does that mean? Basically this means that the the car's computer has detected that not all of the engien's cylinders are firing properly.
A P0300 OBD DTC code indicates a random or multiple misfire. If the last digit is a number other than zero, it corresponds to the cylinder number that is misfiring. A P0302 code, for example, would tell you cylinder number two is misfiring. Unfortunately, a P0300 doesn't tell you specifically which cylinder(s) is/are mis-
==================================
The p0430 What does that mean? Basically this means that the O2
downstream of the catalytic converter on bank 2 is detecting that the converter is not working as efficiently as it should be (according to specs). It is part of the vehicle emissions
system.

Posted on Apr 26, 2009

  • 14036 Answers

SOURCE: need to locate EGR valve on dodge durango 2005

EGR VALVE LOCATED ON THE INTAKE.IT HAS A SMALL ROUND LOOKINGIT HAS A METAL FLEXIBLE PIPE THAT CONNECTS TO THE EXHAUST MANIFOLD.

Posted on Feb 01, 2010

  • 14 Answers

SOURCE: How do I install an EGR valve for 2005 dodge

To install the EGR Valve on a 2005 Durango first it is necessary to remove the air intake hoses and palce them to the side. Next, in order to get the EGR valve you will need to remove the windshield wiper motor, which is a pain but necessary to do get to the EGR valve. After removing all of the itemsthat are in the way you will be faced with a task that will try your patience, the EGR valve is located on the right side of the motor, (as if you were facing the motor from the front) just behind and to the rear of the throttle body. After you locate it you will need a rachet with a flexible head because it is fairly difficult to reach otherwise. A mirror and light will also help so you can see what you are doing since the EGR valve is located in such a hard place to see and get to that you will only be able to see part of it while you are removing the screws. After removing the EGR valve, simply reversethe procedure and your done. P.S. I own a 2005 Dodge Durango SLT with a 4.7L engine and I replaced mine this year after a check engine light came on and I checked the code on the OBD. By the way the EGR valve is a pain in the rear to change. Good luck!

Posted on Jul 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Number #3 cylinder not firing


Pcm is very rarely the cause of a misfire. Get another opinion. Check plug and wire, then coil.

Jul 16, 2017 | 2005 Dodge Durango

1 Answer

Where is the egr sensor located on 05 durango


The egr sensor is built onto and is part of the egr valve. Depending on what engine you have depends on where the valve is located. On 5.7 engines its in the front. On 3.7 and 4.7 its in the rear of the engine.

Apr 30, 2011 | 2005 Dodge Durango

1 Answer

How to replace the egr valve on a 2005 dodge durango 5.7 hemi


Dont bother just make a seal off gasket from a coca cola can ,it will run better without the EGR valve and still pass the emmisions test with it blocked off

Apr 25, 2011 | 2005 Dodge Durango

1 Answer

How do I install an EGR valve for 2005 dodge durango?


To install the EGR Valve on a 2005 Durango first it is necessary to remove the air intake hoses and palce them to the side. Next, in order to get the EGR valve you will need to remove the windshield wiper motor, which is a pain but necessary to do get to the EGR valve. After removing all of the itemsthat are in the way you will be faced with a task that will try your patience, the EGR valve is located on the right side of the motor, (as if you were facing the motor from the front) just behind and to the rear of the throttle body. After you locate it you will need a rachet with a flexible head because it is fairly difficult to reach otherwise. A mirror and light will also help so you can see what you are doing since the EGR valve is located in such a hard place to see and get to that you will only be able to see part of it while you are removing the screws. After removing the EGR valve, simply reversethe procedure and your done. P.S. I own a 2005 Dodge Durango SLT with a 4.7L engine and I replaced mine this year after a check engine light came on and I checked the code on the OBD. By the way the EGR valve is a pain in the rear to change. Good luck!

Jun 29, 2010 | 2005 Dodge Durango

1 Answer

EGR Valve 2005 Dodge Durango


Check in the drivers side rear of engine take off the air housing and use 13mm. deep socket w / 3inch ext. and air ratchet to remove 2 bolts, then take tire off inner splash panel then 8mm wobble w / 24inch ext to take 1 tube bolts loosen other one and pull out as ***. Reverse to install.

Hope this help to solve it (remember rated this post).


May 20, 2010 | 2005 Dodge Ram 1500

1 Answer

Need to locate EGR valve on dodge durango 2005


EGR VALVE LOCATED ON THE INTAKE.IT HAS A SMALL ROUND LOOKINGIT HAS A METAL FLEXIBLE PIPE THAT CONNECTS TO THE EXHAUST MANIFOLD.

Feb 01, 2010 | 2005 Dodge Durango

1 Answer

05 Dodge caravan P0406 code


It is most likely that your egr needs to be replaced

Jan 10, 2010 | 2005 Dodge Durango

2 Answers

Egr valve dodge durango


if this is a 4.7l engine, the valve is on the left rear of the intake. loosen the 8mm bolts that hold the egr intake tube to the egr valve, remove the egr bolts, disconnect wiring, remove valve and tube together, attach intake tube loosely to new valve, install new valve, tighten tube bolts to egr using a swivel socket, this is not a 5 minute job, so dont attempt unless you have some time and patience.

Apr 17, 2009 | Dodge Durango Cars & Trucks

1 Answer

Location of EGR valve on 2005 Dodge Durango


If I had been him, I would have talked you into a Chilton or Haynes manual for your car. They are easily detailed enough to show you the location and  Iwould be surprised if a chain operation like AZ didn't have the right one on hand.

Dec 10, 2008 | 2005 Dodge Durango

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75824 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...