Question about Chevrolet 2500

Open Question

1997 chevy silverado passanger seat belt stuck

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 35 Answers

SOURCE: Passanger side seat belt well not work.

check youtube...there is a video about it

Posted on Sep 24, 2008

Ad
  • 184 Answers

SOURCE: I have a 1997 Ford Escort. The rear seat belt is stuck

make sure that the rear seats are properly locked into rear catches as this can stop your seatbels from working if ok then sounds like your seatbelt is faulty req new seatbelt.

Posted on Mar 08, 2009

  • 129 Answers

SOURCE: Replace rear passanger seat belt mechanism

The mechanism is located behind the plastic cover on the door side. You'll need to remove this trim piece to get at it. It's held on by screws. When you get to the mechanism it is held on by a torx bolt.
Good luck

Posted on May 29, 2009

  • 462 Answers

SOURCE: seat belt retractor stuck, will not come out more than 8 inches

THERE IS A COUNTER WEIGHT INSIDE OF THE RETRACTOR THAT IS CAUSING YOUR PROBLEM. UNFORTUNATELY YOU WILL NOT BE ABLE TO FIX IT, UNLESS OF COURSE THERE IS SOMETHING STUCK INSIDE OF THE RETRACTOR.

Posted on Jun 02, 2009

  • 1382 Answers

SOURCE: Seat belt stuck

Open small plastic access panel located between front and rear doors a few inches above floor. Disconnect the two wire connector (usually attached to car frame) and locate the male pin connector, usually 1 red and 1 blue wires. Run two long wires from a car battery negative post and positive post (battery on the car or separate.) Hold one wire against one pin of the connector and quickly touch the other wire against the remaining pin. This will cause the motor to turn in one direction. If motor turns in wrong direction simply reverse the wires until motor brings belt to desired position then quickly remove the wires. Reattach connectors to resume 'normal' operation after 'CAUSE' has been repaired.

Posted on Aug 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix a stuck retractable seat belt?


You can't it is not designed that way. The seatbelt mechanism is damaged and needs to be replaced.

Feb 21, 2016 | 1999 Chevrolet Blazer

1 Answer

2002 chevy 5.3, silverado egr valve. WHERE IS IT


It is on passanger side of engine, in front of the oil filler tube. Round looking thing, five wire connector plugged in !

Dec 15, 2014 | 2002 Chevrolet Silverado

1 Answer

How to replace seat belt on 10 chevy silverado


Buy the GM Seat Belt Driver tool from
Snap-On & remove the bolts

Mar 02, 2013 | 2010 Chevrolet Silverado 1500

1 Answer

INSTRUMENT CLUSTER


It is probably where the seat belt plugs in (Stalk) This will cause both lights as it is part of the SRS (Suplimental Restraint System). Start by looking under the drivers seat at the wire from the seat belt stalk & look for any damage to the wireing. Then check passanger side. It is normaly drivers side cause that is the seat that gets mved most. All SRS plugs should be yellow for identification

Jul 02, 2012 | 1997 Chevrolet Cavalier

2 Answers

My drive side seat belt is stuck on my 2001 chevy tracker, any suggestions?


Unfortunately the seat belt must be replaced the mechanism that control it is stuck and cannot be release.

Mar 28, 2012 | 2001 Chevrolet Tracker

1 Answer

THE PASSANGER SIDE SEAT BELT IS STUCK AND WONT UNLOCK. ANY SUGGESTIONS?


you need to take off the center pillar trim to remove the seat belt assembly for inspection and unbolt it using a no. 14 mm. socket wrench from the flooring to the pillar.

Apr 07, 2010 | 2005 Nissan Pathfinder

1 Answer

Seat belt retractor stuck, will not come out more than 8 inches


THERE IS A COUNTER WEIGHT INSIDE OF THE RETRACTOR THAT IS CAUSING YOUR PROBLEM. UNFORTUNATELY YOU WILL NOT BE ABLE TO FIX IT, UNLESS OF COURSE THERE IS SOMETHING STUCK INSIDE OF THE RETRACTOR.

Jun 02, 2009 | 1997 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

293 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...