Question about 2002 Volkswagen GTI

Open Question

02 vw gti 1.8t code p0332

Car runs fine, but occasionally engine will pop on and off.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
leroyal
  • 2120 Answers

SOURCE: 02 VW GTI Radio says CHECK

There is an in-line fuse on the back of factory radios.

Posted on Nov 22, 2008

Ad
  • 144 Answers

SOURCE: 02 VW Jetta TDI with ALH engine glow plug

this is a common problem for these cars glow plugs go bad like spark plugs however the smoke would lead to bad mass airflow meter. it is not telling ecu corrcet miss. disconnect mass airflow meter. when cold see if this makes it start better. it should would means you need new m.a.f. glow plug issue take a test light place clamp on positive of battery then pull off glow plug connectors place tip of test light on glow plug the bad one will have a dull light unlike the good one which will be brighter. will need new plugs and wire harness four **** connectors and wire striper and crimper will fix concern good luck

Posted on Sep 01, 2009

czaa
  • 4521 Answers

SOURCE: engine lught and idle trouble with 1992 vw passat

hav der auto scanned at ein shopp discount places-probly a 02 sensor is old which ist located on muffler und controls lean/rich-wedersehn

Posted on Sep 02, 2009

Testimonial: "Will try to replace o2 sensor tommorrow and let you know the outcome."

  • 111 Answers

SOURCE: getting ETC p2181 code for vw gti 1.8 t 02

punch one code at a time into google search check related symptoms

Posted on Sep 13, 2009

  • 6 Answers

SOURCE: 1991 vw golf gti- RPM stop working!

judging by the amount of km it has done i would say the rpm drive is faulty, this measures the amount of rotation in the camshaft and shows the "revolutions per minute". when this goes faulty it stops the read out on the dial, so you want to be looking for a device that measures the speed that the engine is turning, if you have, replace it and it should solve the problem

Posted on Sep 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause a 2000 VW GTI VR6 not to hold idle?


Hi. Is this a vr6 or a gti? they have different engines.

Apr 26, 2014 | 2000 Volkswagen GTI

1 Answer

Volkswagen passat wagon 2004 codes p0300 p0302 p0304 p0011 runs fine


You have random misfire codes as well as misfires detected on cylinders #2 and #4. P0011 is likely the root cause of the misfire being detected
P0011 VOLKSWAGEN - 'A' Camshaft Position Timing Over-Advanced Or System Performance problems.

Possible causes- Dirty engine oil
- Low engine oil level
- Camshaft actuator circuit open or shorted
- Camshaft actuator circuit poor electrical connection
- Faulty camshaft actuator

There may be a factory bulletin on this code, check with the VW dealer on that. Possible defective Camshaft actuator.

Oct 08, 2012 | 2006 Volkswagen GTI

1 Answer

What is the warning light on 2005 vw gti


Hello! A thermometer light with two wavy lines underneath the thermometer indicates a problem with the VW's cooling system...When the engine is cold; Check the coolant level in the radiator...If it is full and since the light goes out when the engine reaches normal operating temperature the Low Coolant Level sensor is defective...But I suspect the level is low..
Guru...............saailer

Jan 05, 2012 | 2005 Volkswagen GTI

1 Answer

I have a gti 1.8 turbo and when i plug the airflow meter in it cuts out i have replaced it with one from vw the car is also over fueling its had new throttle body and there are no engine codes


What did you use to call up for DTC's? Just what you did would call up a DTC to be stored (100%) in the ECU. If it cuts out like that with a MAF that was working from the donor car then you have other problems along the intake system track. A possible malfuntion from this parts would certainly cause to run poorly.
  • Coolant temperature sensor
  • Pre 02 Sensor
  • Post 02 Sensor
  • Knock Sensor
  • Vacuum leak
  • Faulty Secondary Auxiliary Air pump
  • A bad ECU
So unless you have a scan tool VAG 1552 or equivalent you won't know for sure you haven't triggered a code to be stored. Just by removing battery connection would surely set a code.

Jan 18, 2010 | 2000 Volkswagen Golf

2 Answers

I have a 2000 vw gti and the check engine light came on. it seems to be running fine..............


take the car to a garage and get them to pug the car in to the pc and they will tell you the prob

Dec 23, 2009 | 2000 Volkswagen GTI

1 Answer

Getting ETC p2181 code for vw gti 1.8 t 02


punch one code at a time into google search check related symptoms

Sep 12, 2009 | 2002 Volkswagen GTI

Not finding what you are looking for?
2002 Volkswagen GTI Logo

Related Topics:

176 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76051 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...