An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: dodge caravan sliding doors
First, keep in mind that as you begin to remove these doors you run the risk of causing serious scratches to the paint and glass, so put some masking tape and/or plastic sheeting around both sides of the door (rear quarter panel and rear glass, front door and front door glass) I would get a Haynes repair guide since that's what I have to work from and it will tell you step by step with pictures, what to do. It's not hard, but you need to get all of the attach points unhooked to be successful. Suggest you have a helper working with you to keep the door steady.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
This is listed several times, My 2005 Town & Country had the same problem until I found on this website a solution. Turn the key on, open the door from the seated position in the van and SLAM the door with button pushed 1-6 times. Mine worked the first time.
deactivate the alsrm with remote or lock then unlock door with the key try another door if drivers door wont disarm it. that is for factory alrm
after market alarm needs remote or some button somewere under dash
best way to fix an after market alarm is to remove it
Remove Negitive battery cable. Remove 2nd row seat on the side to be replaced or remove bench. You have to do this from the inside of the van with the door closed. Remove the upper trim aroud the window by lifting from the bottom & pull up and out to pop the clips free. Starting on the bottom of the side door panel lift the panel out and up do not brake the upper part around the lock pin. Remove sound proofing sheet. The door motor is at the bottom. Remove the U-Clip holding the drive flex to the motor use neddle nose pillers. Use a trim tool or pillers to reve the plastic push fasterners. If using pillers use the pillers only on the flat side. ##Note have seen motors attached with bolts. Remove motor. Instalation is reverse of removal. Note## When installing sound proof sheet aplly spray tact.
Sounds like the Body Control Module is having issues. You can try pulling the negative battery cable for 10 mins to reset it. But most likely you will need to go to a dealer and have it either flashed (reprogramed) or replaced.
i have replaced many sliding door lock actuators on these vehicles..dealer part..mostly on passenger side sliding door..also possible you have a broken wire in door track harness..follow wiring from door into what looks like a plastic chain in door track at door opening
The air filter for the cabin is located inside the van, look under the glove box door there should be a plastic holder that slides to the rearward of the van pull this back and a flat plastic door will come off, the door is two parts.
Some base vans do not have this filter if you look at the bottom of this and see a 1/2 long plastic stud sticking out of the bottom there is no filter in this.