Question about 1992 Ford F350

Open Question

No presure on clutch petal

Desiel

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How done reset tyre persure light on vw cc 4 motion


i would check all the tyre pressures and then vw says to press the "SET" button to store the new pressure and the light should go out, if light stays on will have to be inspected by VW dealer

May 10, 2014 | Volkswagen Passat Cars & Trucks

1 Answer

I have a chevy s10 and the clutch petal is very hard to push


Most likely clutch is worn out, increases pedal height and pedal resistance, recommend replace if around 100,000 miles old. Also good idea to replace clutch master and slave, and service trans fluid.

Jan 05, 2014 | 1998 Chevrolet S-10 Pickup

1 Answer

Bleeding clutch


Are you sure the clutch disc and fork are connected to the slave cylinder ?

Apr 29, 2013 | 1997 Isuzu Rodeo

1 Answer

Why is there clutch fluid dripping inside the cab?


most likely the master clutch cylinder rod seal is leaking through the fire wall where it is bolted to, when appling pressure to the clutch petal, it runs down the clutch rod that is connected to the petal, replace the clutch master cylinder.

Jul 23, 2012 | 1994 Chevrolet Silverado 2500

1 Answer

Need help bleeding brakes 2004 ford explorer


To bleed the brakes 1st make sure the fuild level is full ,and you will need a assistant . have your assistant pump the brake petal three to four times then hold presure on petal (pushing down ) then open the bleeder valve on the left rear caliper ,have assistant push petal towards the floor until it stops and then hold it there until you close the bleeder valve ,then repeat process four to five time recheck brake fulid level then repeat same process on right rear caliper next go to right front and end on left front ,keep a eye on the fuild level so that it is not allowed to run out or you will have to start over again ,there is no speical procedure ,any other questions just ask

Dec 29, 2010 | 2004 Ford Explorer

1 Answer

New master and slave still have no petal pressure or clutch


Was the slave cylinder bled correctly? If that's all set then that would leave the throw-out bearing and/or clutch assembly.

May 31, 2009 | 1991 Nissan Pickup

1 Answer

Knockes when clutch petal is released but goes away when pushed in


Does it drive fine. Does it do it in all gears? Or does it go away in 4th?

May 27, 2009 | 1997 Honda Civic

Not finding what you are looking for?
1992 Ford F350 Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...