Question about 1998 Buick Park Avenue
For Doors not getting open with remote or key problem,there are help links provided below.Click the link below to go through its procedure and troubleshoot the problem:----drivers side front door will not open from inside or outside? ---------- Car door will not close? -------- All power door locks not working ? ---------- Repairing car Door lock Actuator? ---------- --------- -------- ---------- ---------- --------- -------- -------- How to replace Door Hatch ? ---------
How to Access car door panel?
Vehicle door panel components?
Truck Door will not close? http://schematicsdiagram.blogspot.com/2011/12/ford-truck-door-will-not-close.html
-----------Where is Cars Door control Module located?
Power door locks not working? http://schematicsdiagram.blogspot.com/2011/12/power-door-locks-not-working.html
-----------Door ajar light stays on?
Door locks not working?
Front Door dis-assembly diagram?
Rear Door dis-assembly diagram?
How to test Power door locks?
Doors will not open with Remote? http://schematicsdiagram.blogspot.in/2012/02/lexus-doors-will-not-open-with-remote.html
How to remove Doors?
How to Replace Doors?
--------Remote will not unlock Rear door?
Door locks or windows not working on car?
--------This will help.Thanks.
Car door will not close?
All power door locks not working ?
Repairing car Door lock Actuator?
How to replace Door Hatch ?
Posted on Feb 22, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
sounds like the drivers temp door actuator is not working should be located on the drivers side of the air box down by the gas pedal or center dash area.
Posted on Nov 06, 2008
I just accessed mine. It is under the rear seat. You just lift up on the seat, and it pops right out. If you are having problems with the rear defroster, it could very likely be the control module. This is a combination module which the rear antenna, and the defroster grid plugs in to.
When mine went out I smelled a "burnt wire" smell, then it went out.
To access the module, sit in the back seat, drivers side. There is a trim panel that will be by your left ear as you are looking forward. It is the panel that flares down from the ceiling to the rear deck. Gently pull at the edge of this panel, working around the edges, and the small strip which continues over the top of the door.
The seatbelt goes through this panel, so it will be hanging from the seatbelt at this point. There is a ~3" square, black module with the defroster input and output wires, and the antenna wire plugged into it.
You just unplug the wires, pull the one mounting screw, and voila!
On mine the module was obviously melted, as was the wire going into it. I got the replacement from a salvage yard, as the new one was over $50, and the replacement wire was $18. The salvage yard was unable to look it up, so I had to go out to the yard with them and pull it myself. The final cost was $17 (they tried to charge me $40, and I told them I could get it online for that, and they dropped the price).
You can use a crimp on **** connector to put in the replacement wire, but because of the heat in that area I chose to solder the wires together.
BTW, this module fits a wide range of Buicks, and full size Olds.
Hope this helps.
Posted on Jan 20, 2009
SOURCE: my 1997 buick park avenue
U need to replace the air temperature control blend door actuator motor, this requires removing the dash to access the motor for the blend door.
Posted on Apr 13, 2009
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
Posted on Aug 14, 2009
Tips for a great answer:
Apr 28, 2014 | 1998 Buick Park Avenue
Apr 21, 2014 | 1991 Buick Park Avenue
May 18, 2011 | 1998 Buick Park Avenue
Aug 16, 2010 | 1998 Buick Park Avenue
Nov 07, 2009 | 1998 Buick Park Avenue
Nov 07, 2009 | 1998 Buick Park Avenue
Oct 13, 2009 | 1993 Buick Park Avenue
May 29, 2009 | 1998 Buick Park Avenue
Oct 03, 2008 | 1998 Buick Park Avenue
Jun 04, 2017 | 1998 Buick Park Avenue
983 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: