Question about 1999 Chevrolet Venture

Open Question

I have problem with the power window of driver side - chevy venture 2003. Motor has been replaced by a new one but still window does not go up. Please help me. Send me solutions. Thank you.

Window goes down but it won't go up. The power motor is new. Passenger side window works perfectly well.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Thermostat in a 2003 chevy venture van

the bottom boult is hard but can be done need to use a 10 or 12 stubby wrench and take a pry bar and lighty pry heat shild away to get bottom bolt dont need to take it out all the way just loosen and slide down

Posted on Aug 17, 2008

Ad
  • 1 Answer

SOURCE: Thermostat in a 2003 chevy venture van

no you dont need a special tool you have to take the throttle body off it makes it sooooooo much more simple.

Posted on Jan 27, 2009

  • 1118 Answers

SOURCE: Driver Side Window won't work- Chevy Blazer 2003

If it does not make any noise, or sound like its getting any power, most likely its the switch.

Posted on Feb 20, 2009

  • 10 Answers

SOURCE: passenger side power window won't go up on my 2000

it is probably the window module.

Posted on Jan 07, 2010

  • 1 Answer

SOURCE: Replacing Passenger Window Motor

Just replaced 2004 passenger side motor. Bought motor/gearbox for 31 dollars, free shiping on line, removed motor and regulator , looks like a guide with cables, leaving it all together. We taped window at top and used a pair of small vice grips to clamp the small cable to the frame so it wouldn't move . As we removed the 3 small screws holding the motor/gearbox in place , it slips out showing it has a large plastic spline gear slightly visible . We used a small screw driver to seperate the gear/motor from what looks like a barrell with that cable wrapped around it. We were careful
not to let this cable drum get loose, so we made sure one person held it inside the housing. Slipped the new drive in and done with that. No one mentioned there was a bracket holding the door panel and I had to pop out the manual lock button to access a small screw, don't drop that screw down insde the door, would be hard to get out. I didn't have to make any adjustment and it works great.

Posted on Feb 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 Chevy Venture. My passenger side window quit going up about a month ago, but I could still roll it up from the drivers side. Today my drivers window would not go up. I took the panel off the...


Had same problem and replaced switch on drivers door and now works fine. Not saying thats your problem but i went through the same stuff and that fixed it for me.

Aug 12, 2012 | 2003 Chevrolet Venture Passanger

1 Answer

2004 chevy venture: driver's electric window hesitates when trying to lower or raise it. Do I need to replace a switch, motor, etc.?


if you have fully charged battery and you are having this problem well i would take the door panel off and watch it operate make sure every thing is moving smoothly and lubed if you can switch the switches from passenger to drivers test both see if the drivers window operates normal same with other side if no change then yes find new motor on craigs list .com hope this helps you out

Jul 24, 2011 | 2004 Chevrolet Venture Passanger

1 Answer

Driver's side power window was inop. Window failed to go back up. Chevy dealer replaced the regulator motor and now working. Now the power dood lock switch on drivers side won't unlock doors.. Is the...


Hi, that wire is disconnected when the door panel is removed to work on the window motor. Take the car back and ask them to reconnect your door locks. If you want to fix it yourself, you may be able to access the connector by removing only the control panel where the door lock switch is installed. Remove any visible screws and then pry gently to pull up the panel. Odds are, however, that the whole door panel will need to be pulled loose to find the cable. You can possibly just pull the bottom of the panel loose, but do it carefully. Feed the wire back up to the control panel and reconnect to the switch. Thanks for using Fixya.

Jan 24, 2011 | 2003 Chevrolet Venture Passanger

1 Answer

I have a 2003 chevy venture and the winow on


No more fuses,General Motors had alot fo problems with power window motors I personally have replaced hundreds of these in all there models over the years.Sometimes if you tap on the motor with the door panel off while depressing the switch the motor will move again for a while but it will need to be replaced. Just make sure you have switching voltage and ground at the motor connector with the switch depressed.Good luck

Oct 03, 2009 | 1999 Chevrolet Venture

2 Answers

Power window not working


window motor or window regulator. glass could also be off track.

Apr 26, 2009 | 1999 Chevrolet Venture

1 Answer

Driver side power window doesn't work


remove the switch and make sure there is power going to it .. then if there is, check with a tester light. if there is power going to the switch then there should be power leaving it .. If there is prepare to replace the window regulator motor ... holler if you need more.. Jerry

Apr 22, 2009 | Chevrolet Venture Cars & Trucks

1 Answer

Chevrolet Venture 2003 passenger window will not work


Take the soft rubber tube out of the door post and check the conection there. Mine was caroded. Clean it and try it again.

Apr 20, 2009 | 2003 Chevrolet Venture Passanger

2 Answers

Chevy Venture power windows- 2003


It is possible that it is the fuse but if so something caused the fuse to blow. It may be in the wiring which if you pull up the carpet by removing the door floor trim and lifting the carpet you will see the wiring underneath. Probably laying in water. Look for splices in the wiring which will have corroded. Repair the wiring then replace the fuse.
Another problem may be in the motors found inside the doors. The brushes may have worn out. If so you need to replace the motors. Unlikely that both motors failed at the same time though.
Usually the drivers door first since it is the most used.

Dec 17, 2008 | 2003 Chevrolet Venture Passanger

Not finding what you are looking for?
1999 Chevrolet Venture Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...