Question about Cars & Trucks

1 Answer

How activate herman kardon TD5 Discovery audio system after disconnecting battery

System seems to hang after entering code?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 76,846 Answers

I am sorry but you need to contact the dealer on this problem.

Posted on Feb 22, 2012

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 149 Answers

SOURCE: how to adjust rocker shaft on discovery td5

There are adjustment screws on the rockets according to RAVE.
The procedure is as follows:
1) Rotate the engine clockwise until No 1 injector lobe is at full lift.
2) Rotate rocker adjusting screw clockwise until the injector plunger is felt to bottom out.
3) Rotate rocket adjusting screw anti-clockwise one complete turn to give plunger the required bump clearance and tighten rocker arm adjusting screw locknut to 16Nm. Ensure the screw does not turn as the locknut is tightened.
4) Carry out the procedure for the remaining 4 rocker arms.
5) After completion of rocker arm adjustment slowly rotate engine clockwise 2 complete turns by hand to ensure that no injectors are bottoming out on their plungers.

Posted on Feb 24, 2010

emissionwiz
  • 76846 Answers

SOURCE: brakes binding on when driving

has the ABS Hydraulic control valve been replaced? that is what causes this most times, also a defective ABS control module can do it, but the module comes with the valve so it is of no matter..

Posted on May 21, 2010

  • 1 Answer

SOURCE: Land Rover Discovery TD5 1999. Where is the Fuel Relay Switch

In the engine fuse box under the bonnet ,relay is the closest one to the front of the vehicle ,about £7 to replkace

Posted on Jun 09, 2010

  • 1011 Answers

SOURCE: having difficulties bleeding the clutch

hve someone pump it for you ,and nice slow long ,movements of pedal and keep reservoir topped up should get it to bleed

Posted on Mar 27, 2011

Testimonial: "your solution is ok I tried it many times but still doesn't work"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need radio code for 2006 suzuki FORENZA


A local dealer can help. They will have a code based on your VIN. Also, you can try this: The audio security system is activated whenever the audio system circuit is disconnected from the battery. A four-digit security code must be entered in order for the audio system to resume functioning. The security code is stamped on a card located in the vehicle (usually in the glove box). The following security code entering procedure must be used to deactivate the audio security system:
After connecting the audio security system to the battery, "CODE" will flash on the display.
Enter the proper security number into the unit, using the preset buttons No. 1 through 8.
For example, if the security number is "1234":
Press the preset button No. 1. "CODE" will disappear and "1 --- " will appear on the display.
Press the preset button No. 2, and "12 -- " will appear.
Press the preset button No. 3, and "123- " will appear.
Press the preset button No. 4, and "1234" will appear and flash three times.
The audio system will function and will transfer to the radio. If the incorrect security number is XXXXX into the unit, "Err" will appear followed by "CODE" and there will be several audible beeps. If this happens, repeat the security entering procedure beginning with Step 2.
If, after repeated entry of the wrong code, unit will enter "lockup" & will need to be repaired

Oct 07, 2015 | Suzuki Cars & Trucks

1 Answer

How do I reset/restart my Audio system in a 2010 Hyundai ix35


You have to call dealer and give them the Vin number of your vehicle and they can look up the code and explain how to enter it using the radio keypad.

Jan 23, 2015 | Hyundai Cars & Trucks

1 Answer

Having difficulties bleeding the clutch system of my discovery td5


hve someone pump it for you ,and nice slow long ,movements of pedal and keep reservoir topped up should get it to bleed

Mar 27, 2011 | 1999 Land Rover Discovery

1 Answer

Doors will not open using remote or disarm alarm. unlocking with key and as soon as door is opened alarm is activated , have replaced batteries in keys


You must enter the system using the EKA code, it will written in the service book how to activate the EKA. If you dont have the EKA code, you will have to take the car to the dealer to reset the system and give you the code. hope that helps

Mar 15, 2010 | 1999 Land Rover Discovery

1 Answer

Clonking noise from front and rear when driving and rocking stearing on discovery 2 td5 with ace


First of all check your drive shaft universal joints.If they are ok then you have trouble with the active suspension.Have it checked with a dealer.

Dec 28, 2009 | 2001 Land Rover Discovery Series II

2 Answers

I entered the code wrong now i cant get the dashes back to type code in again any ideas


Entering the codes too many times may lock this system.You may need to contact a dealer to help you further in this occassion.

Dec 15, 2009 | 1996 Land Rover Discovery

1 Answer

How can I program my 2006/7 Honda accord radio, lost memory after removing the battery and replacing new one.


Your car’s audio system will disable itself if it is disconnected from electrical power for any reason. To make it work again, you must enter a specific five-digit code in the Preset buttons. Because there are hundreds of number combinations possible from five digits, making the system work without knowing the exact code is nearly impossible.
You should have received a card with your manual (if you have one) that lists your audio system’s code number and serial number. If you don't have the card, you can get the code number from your Honda dealer, but to do this, you will need the system’s serial number.
If your car’s battery is disconnected or goes dead, or the radio fuse is removed, the audio system will disable itself. If this happens, you will see ‘‘Code’’ in the frequency display the next time you turn on the system. Use the Preset buttons to enter the five-digit code. If it is entered correctly, the radio will start playing.
Hope this is helpful.

Nov 03, 2009 | 2006 Honda Accord

1 Answer

Unlock code for radio 98 honda accord


Your battery must have gone dead or you replaced it.
Your car’s audio system will disable itself if it is disconnected from electrical power for any reason. To make it work again, you must enter a specific five-digit code in the Preset buttons. Because there are hundreds of number combinations possible from five digits, making the system work without knowing the exact code is nearly impossible.
You should have received a card with your manual(if you have one) that lists your audio system’s code number and serial number. If you don't have the card, you can get the code number from your Honda dealer, but to do this, you will need the system’s serial number, or maybe the accord's vin number.
If your car’s battery is disconnected or goes dead, or the radio fuse is removed, the audio system will disable itself. If this happens, you will see ‘‘Code’’ in the frequency display the next time you turn on the system. Use the Preset buttons to enter the five-digit code. If it is entered correctly, the radio will start playing.
Hope this is helpful.

Oct 25, 2009 | 1999 Honda Accord

1 Answer

Discovery td5 want start when cold


If the engine was starting ok before you changed the pump, then it must be something you have done or disturbed, retrace you steps, make sure all pipes are tight connections are good etc

Oct 08, 2009 | 2002 Land Rover Discovery Series II

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...