Question about 2009 Mitsubishi Galant

1 Answer

Lost reverse in 2009 mitsubishi galant

The D stays lit even in park, nuetral and reverse. The car will back up for an instant before reverse fails and it feels like it's in nuetral.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Mitsubishi Master
  • 75,051 Answers

This indicates that the transmission has failed.

Posted on Feb 22, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Rear Speakers

it not necaserry to remove rear speakers just change setting of ur music system only use a front speaker

Posted on Jan 07, 2009

  • 1 Answer

SOURCE: 2001 mitsubishi galant, gear selector all the way

I had a similar problem the reverse gear works fine but when i shift to drive the transmission runs
as if its stuck on third.
My problem was a burnt fuse located in the interior fusebox

Posted on May 17, 2009

  • 1 Answer

SOURCE: Can't shift from park, button is hard to push in.

press the brakes down hard and leave it there for a while and keep pressing the gear button and eventually you'll be driving

Posted on May 29, 2009

  • 1 Answer

SOURCE: Hi,

I didn't solve the problem yet but im not ready to pay in order to solve it

Posted on Oct 20, 2009

HansPP
  • 2510 Answers

SOURCE: Mitsubishi 2000 Galant GLS Inadvertently refuses

Check the gear linkages for wear at all the joints and connections. Check for worn or missing rubber or nylon bushes or loose connector ends. Have someone hold the gear shift input into the box and move the gear lever, there should be minimal movement except in the neutral position and then only left to right.

Posted on Mar 06, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My reverse lights stay on all the time. Mitsubishi galant 2002


Get a wiring diagram and work through it. Be mindful of the grounds as well.

Jan 12, 2015 | 2002 Mitsubishi Galant

1 Answer

Starter stays engaged park or nuetral


Powssible that there is always power to the inhibitor switch. It is the switch that only allows current to flow thru it when in park or neutral. Could be power is always present at the switch when it is in park or neutral. Check the ignition switch first and see if it is powering the start circuit all the time.

Dec 05, 2013 | 2006 Chevrolet Cobalt

1 Answer

GMC 07 Serria backup sensor will not work. I had a new bumper installed. At first it beeper all the time. Now it will not come on. The DIC shows park assist off.


#PIT4878: Service Park Assist Message / LEDs Stay On Or Inop - keywords B0968 inoperative lamp led light lit module reverse urpa - (Jun 12, 2009) 999999995.gif Subject: Service Park Assist Message/ LED's Stay On or Inop Models: 2007-2009 Chevrolet Silverado 2007-2009 GMC Sierra With RPO UD7

The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.
Condition/Concern: Some customers my comment of a Service Park Assist Message on the DIC and/or the LED indicators at the right rear pillar staying on or inoperative. This concern could be caused by the wiring harness to the LED indicators being pinched under a ground eyelet at the right rear pillar, as shown below.

2290161.gif
other issues could be the problem such as poor connections at each sensor or damaged sensors. to clear URPA codes,place ignition in run,(engine OFF),shift into reverse and turn key OFF.place shift lever into park and retest operation of URPA. if still inop URPA code(s) need to be retrieved before further diagnosis can be accurately done.

Sep 15, 2011 | 2007 GMC Sierra 1500

1 Answer

While driving my Mitsubishi Diamante 2002 I just felt the car don't respond to the shift changes and lost power. Now the car can't respond to drive, reverse, etc...


my 02 mitsubishi diamate transmission is in a fail/safe mode how do i get it out of that mode?transmission only works n 2nd,3rd ,park,nuetral,&reverse

Dec 21, 2010 | 2002 Mitsubishi Diamante

1 Answer

Is there a way too unlock stickshift from park too nuetral when car battery dies


Not without a jumper battery, or other 12 volt supply. Sorry!
Regards,David

Nov 29, 2010 | 2000 Mitsubishi Galant

1 Answer

2001 Galant..Shut off while parked and not it won't start!


That sound you hear, does it sound like it is coming from the back of the car, fuel tank? This is most likely the fuel pump starting up. I would still have your fuel pressure checked, if too low you'll have issues. If fuel pressure is good it most likely has to do with the electronics; does it have spark? Remove a spark plug lead and check while cranking the engine over. Also it is possible the timing belt failed, remove a dust cover off the cam, crank over and be certain it rotates. My gut says you have an electrical issue, such as cam or crank sensor. You'll need to check cseveral items to confirm.
If I may be of further service, please ley me know.
Thanks,
Tom

Apr 30, 2010 | 2001 Mitsubishi Galant

1 Answer

GEARBOX


Check the oil level in your gearbox, and check your clutch, for the right setting, it needs adjustment. Did this solve your problem, give us some feedback thru
fix ya or your vote for the solution.

Sep 26, 2009 | 1996 Mitsubishi Galant

2 Answers

2001 mitsubishi galant shaking while in idle


if the light is on it needs a good sevice, also may need a cleaner through the fuel, for the cleaner to work give her a lil service

Jun 04, 2009 | 1997 Mitsubishi Galant

1 Answer

2001 mitsubishi galant, gear selector all the way to the tranny will go into gear but it's like none of the gears are working. the nuetral safety switch recognizes when it's in park or nuetral


I had a similar problem the reverse gear works fine but when i shift to drive the transmission runs
as if its stuck on third.
My problem was a burnt fuse located in the interior fusebox

May 15, 2009 | 2001 Mitsubishi Galant

Not finding what you are looking for?
2009 Mitsubishi Galant Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...