Question about Chevrolet Cavalier

Open Question

Where is evap canister on 2002 cavalier - Cavalier Chevrolet Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
maklean
  • 1665 Answers

SOURCE: location of Charcol Canister and

The evaporative emission canister purge solenoid valve is a duty control type, which controls the flow of purge air from the evaporative emission canister.
4a6acf4.gif Inspection 1. Look for loose connections, sharp bends or damage to the fuel vapor lines. 2. Look for distortion, cracks or fuel leakage. 3. After removing the EVAP canister, inspect for cracks or damage. 0e0e1be.gif

Posted on Sep 04, 2008

Ad
  • 1861 Answers

SOURCE: 1996 Toyota Previa code p0441

P0441 is Evap Emission Incorrect Purge Flow; the repair you are describing is easy, and should correct the P0441 restricition...I would anticipate no large problems.

Posted on Oct 07, 2008

  • 37 Answers

SOURCE: 2004 Chevy Cavalier 2.2 eco Automatic 94,000 miles

in my experience the usual culprit is the evap cannister. the problem is it gets moisture in it and freezes during winter thus cracking the plastic. if you lay under the car and look at the evap box it black plastic and if you see a loose or cracked hose or the box itself is cracked that is most likely it. as a side note you can check the gas cap and buy a new one to see if that rectifies the situation. lastly i don't think the gas tank should be suspect as you would probably notice if gas was leaking out of the tank. if you take the car to a dealer or shop they can do a smoke test and determine where the leak is.

Posted on Oct 19, 2010

jturcotte
  • 8572 Answers

SOURCE: need to locate the evap

look in the left side rear bumper.

jturcotte_14.gif

Posted on Nov 02, 2010

johnjohn2
  • 5763 Answers

SOURCE: my 2002 toyota sienna has evap system malfunction

You are on the right track, you replaced the vent valve and replaced the vsv valve in the engine compartment that should of solved the problem as long as the correct valves were replaced, i would check for a leak in a hose for the evap system, a smoke test would be a good way, the canister may not be the problem but the valves on the canister, there are a few vsv valves on the canister and also the pressure sensor, the switching valve is very common also, there are so many valves thats why the dealer replacing the canister as an asm, hope this helps also make sure gas cap is good.

Posted on Jan 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What are the probable causes of DTC P1448?


Possible causes
- EVAP canister vent control valve
- EVAP canister is saturated with water
- EVAP control system pressure sensor and the circuit
- Blocked rubber tube to EVAP canister vent control valve
- Water separator

Dec 16, 2015 | 2002 Nissan Altima

1 Answer

Toyota echo won't start code 440 441 446


Error Code: P0440
Fault Location:
Evaporative Emission (EVAP) System - Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) active.
Soution:
Check Evaporative Emission (EVAP) System Sealing.
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve .

Error Code: P0441
Fault Location:
Evaporative Emission (EVAP) System - Incorrect Flow Detected
Possible Solutions:
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Perform Output Test.
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve .
Check Evaporative Emission (EVAP) Canister.
Perform Basic Setting.
Check Pipes between Tank Breathing and Throttle Body.

Error Code: P0446
Fault Location:
Evaporative Emission (EVAP) System, Vent Control - Circuit Malfunction
Possible Cause:
Wiring harness.
Evaporative emission (EVAP) canister purge valve.
Engine control module (ECM).

Feb 25, 2013 | 2002 Toyota ECHO

1 Answer

Feul will burp mout of the filler cap no mater how slow I fill the car and the service engine soon light is on, how do I change the feul tank filler vent check valve?


Hi, your EVAP vent valve is likely stuck closed. The valve is under the car near the fuel tank. Remove the valve and check to see if it's stuck. You may be able to restore operation by cleaning the valve with carb cleaner. The valve should be open when no voltage is applied. I have pasted instructions below from autozone.com. Please let me know if you have any questions, and thanks for using FixYa.
jturcotte_1546.gif Vent Solenoid Valve
2.2L & 2.4L Engines

  1. Raise the vehicle
  2. Loosen the EVAP canister vent valve hose clamp and slide the clamp down the hose away from the EVAP vent valve hose connection.
  3. Remove the hose from the EVAP canister vent valve.
  4. Remove the EVAP canister vent valve by placing a pry bar between the valve and mounting surface, and moving the valve forward.
  5. Remove the clip from the EVAP canister vent valve harness connector
  6. Disconnect the EVAP canister vent valve harness connector.

To install:
  1. Connect the EVAP canister vent valve harness connector
  2. Install the clip into the EVAP canister vent valve harness connector.
  3. Install the EVAP canister vent valve by pushing the mounts into the original holes.
  4. Lubricate the hose end with lubricant.
  5. Install the hose to the EVAP canister vent valve.
  6. Slide the EVAP canister vent valve hose clamp down on to the hose connection at the EVAP canister vent valve.
  7. Lower the vehicle.

Apr 18, 2011 | 2004 Chevrolet Cavalier

1 Answer

Check engine code 1441 came on my '03 cavalier what is it?


Hope this helps,

Trouble Code: P1441 (2.2L L4 VIN F Auto)
EVAP System Flow During Non-Purge Print this code dataprint_icon_codes.gif
Number of Trips to Set Code: 2
OBD II Monitor Type: CCM Details
Indicators: MIL Details
Trouble Code Conditions:
DTC P0107, P0108, P0112, P0113, P0117, P0118, P0121-P0123, P0125, P0440, P0442, P0443, P0446, P0449, P0452, P0453, P1106, P1107, P1111, P1112, P1114, P1115, P1121 and P1122 not set, engine started, vehicle speed less than 75 mph, system voltage over 10.0v, ECT and IAT sensors from 39-86ºF and within 16ºF at startup, BARO sensor over 75 kPa, fuel level from 15-85%, PCM detected a continuous open purge flow condition with the fuel tank pressure decreasing to less than -11" H2O during the test. The PCM seals the EVAP system by commanding the EVAP Purge valve "off" and the EVAP Canister Vent valve "on". The PCM monitors the fuel tank pressure (FTP) sensor to detect if a vacuum is being drawn on the EVAP system. If vacuum in the EVAP system is more than a set value for a certain time, this code is set.

Possible Causes:
  • An improperly installed or damaged EVAP canister purge valve
  • A temporary blockage in the EVAP canister purge valve, purge pipe, or EVAP canister could cause an intermittent condition
  • FTP sensor is out-of-calibration, damaged or "skewed"
  • Purge solenoid valve is damaged or has failed
  • PCM has failed
  • TSB 02-06-04-046 contains a repair procedure for this code

Jan 19, 2010 | 2003 Chevrolet Cavalier

1 Answer

2002 chevy cavalier p0440 and service light is on


that is fuel tank evap related code.
It can be caused by simply removing the gas cap while the engine is running.
Dont get too concerned with this code if you think you may have opened the cap while car was running, the computer will soon turn the light off if all is well.
Other things Like ta cracked or faulty gas cap, The evap purge canister or hoses loose or cracked, filler neck hoses loose or cracked ,damaged orings on evap sensor. could also cause this code.
They often use a special smoke machine to diagnose leaks in the tank and evap system.
The special machine fills tank with smoke at 2 psi making it posible to spot leaks.
Hope this helps.
If it does dont forget to leave a comment.
(:DK

Oct 25, 2009 | 2002 Chevrolet Blazer

1 Answer

Failure to maintain vacuum in 2002 Chevy Cavalier


Replace the gas cap,(tight don't mean it seals)
check evap hoses coming from the gas tank and the hoses on the evap canister

Jul 30, 2009 | 2000 Chevrolet Cavalier

1 Answer

2002 Cavalier error code 440 and 452 What do they mean?


This indicates that a part of the Evap control system  is no longer functioning correctly. The Evap system consists of many parts, including (but not limited to) the Gas Cap, fuel lines, carbon canister, purge valve, and other hoses. The (EVAP) emission control system prevents the escape of fuel vapors from a cars fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage. Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine.
A code P0440 could mean one or more of the following has happened:
The gas cap is not installed or working properly
The purge solenoid has failed
The canister is plugged and not working properly
TRY this first: Remove and reinstall the gas cap or replace, clear the code, and drive for a day and see if the codes come back.
Inspect the Evap system for cuts/holes in tubes/hoses
Inspect for damaged or disconnected hoses around the Evap purge solenoid
Check and/or replace the sensor
Check and/or replace the purge valve

P0452 Evaporative Emission Control System Pressure Sensor Low Input

Good luck and hope this helps. Recap star with the simple and replace the gas cap with a dealer OEM not a after market. If that does not fix it then change the sensor as indicated with the P0452 code. You can get the sensor from Auto Zone and they can give yo the step by step instruction to get the job done. Good luck and keep me posted. 

Jun 14, 2009 | 2002 Chevrolet Cavalier Coupe

3 Answers

2000 cavalier check engine light code po440


P0440 - Evaporative Emission (EVAP) System


evaporative emission (EVAP) system has a large leak.
Check the gas cap or vent valve. these are the most common problems.


The Powertrain Control Module (PCM) at different times performs various tests on the EVAP system. OBD II Enhanced EVAP systems are in place to keep fuel tank vapors from venting into the atmosphere, and instead purges them into the engine to be burned. Regular pressure tests are conducted by the PCM to monitor the sealed system for leaks. The PCM monitors the EVAP system pressure by watching the Fuel tank pressure sensor (FTP). When the sensor indicates a small leak in the EVAP system, this code is set.


Here are some additional causes.

* A small leak in any of the EVAP hoses or fuel tank hoses
* A small leak in the purge valve or vent valve
* The EVAP Canister may be leaking

Jun 06, 2009 | 2003 Chevrolet Cavalier

1 Answer

Im getting a P0441 EVAP emission control system purge flow fault code on my 2002 dodge neon


Here is what I could find for your code error as potential causes:
After market parts and accessories nonconforming to the EVAP system specifications.
Damaged, missing or improperly installed fuel filler cap.
Blockage in fuel vapor hoses/tubes (EVAP canister tube, EVAP canister purge outlet tube or EVAP return tube) in EVAP system.
Disconnected or cracked fuel vapor hoses/tubes in EVAP system.
EVAP canister purge valve stuck closed.
Canister vent (CV) solenoid stuck open.
Fuel tank pressure (FTP) sensor malfunction.
EVAP canister leaking.
Fuel vapor control valve tube assembly blocked.
Fuel vapor vent valve assembly blocked.

Obviously the gas cap would be the easiest and cheapest thing to fix.  Just make sure it is put on correctly and tight.  If it is not that, I would have to suggest to take it to a mechanic because the other problems on that list are not really DIY material.  Hopefully it is the gas cap and you can take care of it yourself.  Good luck.

May 17, 2009 | 2002 Dodge Neon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

828 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...