Question about 1993 Volkswagen Eurovan

Open Question

Sliding window lock

Sliding window on sliding door lock fell off. how put back?

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 15 Answers

SOURCE: 2001 vw beetle window and door lock will not work

Hi Rachel . It sounds like the plug on the drivers window motor (Which is also the ecu for that door) has come off or is loose . This will stop the cdl working as well . Regards VW Audi tech

Posted on Jan 20, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i prevent the door lock from falling inside the door?


normally there is a clip that holds it in place .remove inner panel and using a magnet see if it fell to the bottom of door .

Mar 21, 2016 | Cars & Trucks

1 Answer

How do I put the driver side power window back on track and the door panel for my 2003 Nissan Altima 3.5SE?


R/R the inner door panel, slide the window back on track, reconnect the window transmission to the window, (or reinstall the trans) bolt everything back together (window motor, window trans to door etc.) Make sure the window is in the UP position. use the switch to raise the window & keep it up if all is back together before finally installing the door panel ( make sure the switch & other plugs are plugged in before the door panel is reinstalled.) Lights etc. Good luck

Sep 14, 2014 | 2003 Nissan Altima

1 Answer

What do i do if the window falls into the door and off track


pull door panel of and pull the window up ask some one to help u to hold it then raise up and down your track and slide window on ,then tighten up the bolts that holds it on track but make sur before you completly tighten the bolts to c if it properly set where the door can open and shut then tighten bolts on the rail and put the door panel back on : )

Jan 17, 2013 | 1997 Ford Expedition

1 Answer

Passenger side window came off trac and is sitting in door


you have to remove the door panel..unbolt the tracking from inside the door..slide the windows back inside the track rails....push window all the way up..tape the window so that id does not fall back down or have someone hold window up while you rebolt the track to the door.replace door panel....the tracks move over time and that it why the window fell.

Jan 26, 2011 | 2004 Cadillac Deville

1 Answer

Window slide fell to bottom of door


Start by taking the door panel apart, the cable window regulators are not too complex and can be purchased aftermarket. More than likely a cable is broken.

Sep 18, 2009 | 2001 Oldsmobile Alero

2 Answers

Door lock assembly fell inside door


The same thing happened to my 2006 Aveo. Once you do the above find the lock and the screw that holds it in (they will both be in the bottom of the door). Put the lock back in place, put blue Loctite on the screw and screw it back in place and this problem will not repeat itself.

Aug 11, 2009 | 2005 Chevrolet Aveo

1 Answer

I was rolling up one of my rear power windows and it made a terrible noise and then fell back down. It now will not roll up and it slides freely when I pull up on the glass.


You will have to remove the screws of the door panel, than take flat-tip screwdriver and pry off door panel. Than you will have to put window back on the track.

Jun 22, 2009 | 2006 Acura MDX

1 Answer

Subaru impreza/ manual side window stuck


You are having a problem with the "window regulator" remove the door panel, see if the window regulator bolts fell out. they are usually in between the plastic door covering and the door or inside the door on the bottom. they are four bolts that a 10 mm wrench fit, they are short about 1/4 of an inch long, if they fell out you can simply put them back in (I recommend using lock tite on them) These bolts are located in the middle of the door a little towards the front. If your bolts are still in place you probably need a window regulator.

Mar 22, 2009 | 1996 Subaru Impreza

1 Answer

2001 vw beetle window and door lock will not work


Hi Rachel . It sounds like the plug on the drivers window motor (Which is also the ecu for that door) has come off or is loose . This will stop the cdl working as well . Regards VW Audi tech

Jan 18, 2009 | 2001 Volkswagen Beetle

1 Answer

Driver side door window slowly fell down into the door of my 1997 dodge dakota. The glass did not break.


Power or crank? Either case the rails that hold the window on probably broke. there are slides inside the door that keep the window in place, if a slide broke, or if one of the brackets broke, the window will come down. I cant really recomend doing this yourself as ive had the same issue on other vehicles and pulling apart the door and messing with the slides and stuff in there is a real pain. Hopefully it only fell off the track and you can put it back in place. If not, if your not very handly i would suggest taking to someone.

Dec 03, 2008 | 1997 Dodge Dakota

Not finding what you are looking for?
1993 Volkswagen Eurovan Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76848 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...