Question about 2002 Honda CR-V
Trouble code po661 came up in my 02 honda crv
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I had the same problem with the lights alarm on my 2002 CRV. The alarm is linked in to the door open switch on the drivers side. If you open the door, about half way down on the centre post you'll see a rubber covered push switch. This is held in place by a single phillips screw. Remove the screw and gently pull out the cover. On mine, the wires had become unclipped from behind and just had to be reconnected (push fit).
Apparently this is a fairly common problem caused by the seatbelt being caught in the door and catching the switch.
Posted on Apr 01, 2009
SOURCE: HONDA CR-V
OK, you have a code PO341 which means their is a problem with the signal the ECU is receiving from the cam sensor. It does not necessarily mean the sensor is bad. It can be one of these things.
1. Cam sensor wiring routed too close to spark plug wiring (causing interference) 2. Poor wiring connection at cam sensor 3. Poor wiring connection at PCM 4. Bad cam sensor 5. Damaged reluctor wheel You replaced the cam sensor and the problem is still there so we can assume that a defective cam sensor was not the problem. Do this.
1. Check that the wiring isn't routed too close to any secondary ignition components (coil, spark plug wires, etc.) 2. Visually inspect the wiring at the sensor for any burn marks, discoloration indicative of melting or chafing 3. Visually inspect the reluctor wheel through the cam sensor port (if possible) for any missing teeth or any damage 4. If reluctor isn't visible from outside the engine, visual test can only be done by removing cam shaft or intake manifold (depending on engine design)
Posted on Aug 24, 2009
Posted on Nov 23, 2009
You will need to take the car to a deal and verify you are the rightful owner of the radio as this is the purpose of the code.
Best of it. While at the dealer why not ask about any recalls on your car?
Posted on Mar 17, 2010
there is either a problem with the wiring going to the front oxygen sensor, or with the oxygen sensor itself. good luck!
Posted on Mar 31, 2010
Testimonial: "Thanks - I'll have someone look into it!"
Tips for a great answer:
May 22, 2016 | 2003 Honda CR-V
Mar 02, 2011 | 2005 Honda CR-V
Oct 09, 2009 | 2002 Honda CR-V
Sep 13, 2009 | 2003 Honda CR-V
Jun 21, 2009 | 1999 Honda CR-V
Sep 02, 2016 | 2002 Honda CR-V
468 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: