Question about Cars & Trucks

Open Question

Installing kenwood DNX 5220 in 2001 mercedes CLK

What accessories do I need to install Kenwood DNX 5220 in 2001 mercedes CLK?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 43 Answers

SOURCE: need to find battery location: 1999 Mercedes CLK 320

Hi, The battery is located in the trunk, under the trunk mat.

Posted on Apr 08, 2009

  • 6 Answers

SOURCE: my mercedes clk 320 99 wont start , i turn the

This is probably your starter.

Posted on Jul 11, 2009

  • 1 Answer

SOURCE: mercedes clk 320 will not start

i have a 2000 clk320. it would not start sometimes, the engine would crank but it wont start. but after an hour or so it would start. sometime i'll get somewhere park, and come out an hour later and the engine would not start. if your having the same problem, take it to autoparts store ex: autozone or kragen. they could check your battery for free. and if its not the battery. than it could either be your fuel pump. or the crank position sensor. good luck. hopefully this help.

Posted on Jul 18, 2009

  • 4102 Answers

SOURCE: Mercedes CLK Exhaust problem

hi, the problem you are having sounds like the exhaust hasnt been ligned up properly when it has been fitted.
Or it could even be that the rubbers the exhaust rests on could be worn and need replacing.

If you hold the end of your exhaust at the back of the car give it a shake and see how tight it is, their should only be slight left to right movement if their is alot of movement then get the rubbers looked at. If their is only slight movement then the chances are the exhaust has not been lined up properly when it was fitted.

If your car had no problem before then the chances are it is the exhaust so i would check its ligned up and also check all the exhaust mounts are in place and that the rubber clamps holding the exhaust to the car are not worn as to much wear can cause the exhaust to vibrate.

One other thing to look at is the heat shield just above the exhaust if this has been bent then this could be touching your exhaust slightly causing the vibration this can be bent back so it is not touching the exhaust.

Let me know how you get on or if you need further assistance ok

Posted on Aug 22, 2009

mx5turbo92
  • 545 Answers

SOURCE: i need the mercedes benz 1999 clk 430 radio code

AR82.60-P-7502-01A Coding Radio
(MODEL all with CODE (750) Radio Becker Europa 2000 with CODE (751) Radio Becker Grand Prix 2000 with RDS)

  1. If the radio is disconnected from the power supply, it is not operational when re-connected. After switching on the ignition and the radio, the readout CODE appears in the display.
  2. The code number for the radio is advised to you on the enclosed CODE CARD.
  3. To enter the first digit of the code number, you have to continue pressing station button 1 until the correct digit appears in the display. Adopt the same procedure for the second, third and fourth digits.
  4. Once you have entered the correct code number with the station buttons 1, 2, 3, 4 and confirmed the entry with the SEEK button (press down), the readout CODE disappears. The radio can now be operated.
  5. If you enter a wrong code three times, you must wait 15 minutes before making a new entry. In addition, if 9 incorrect entries are made, the radio will then not operate for 24 hours. During this time the radio and the ignition (terminal 15) must remain switched on.
AR82.60-P-7502-01B Coding Radio
(MODEL all with CODE (353) Audio 30 APS with CODE (510a) Radio MB Exquisit with traffic news decoder, with RDS (Becker) with CODE (512a) Radio MB Special with traffic news decoder, with RDS.)

  1. If the radio is disconnected from the power supply, it cannot be operated by simply reconnecting. After switching on the ignition and the radio the word "CODE" appears in the display on the radio.
  2. The code number for the radio is given on the enclosed CODE CARD.
  3. Enter the code number with the station button, e.g. number 1, station button 1. After entering the first number the word "CODE" disappears and the number entered appears followed by 4 dashes. The next character to be entered flashes. After entering all five numbers, the first character starts flashing again. In this state the code number can be written over as frequently as desired. A correction can be made only by entering the complete code number again.
  4. Confirm code number: Press TUNE, AUTO/SEEK or SC button. The radio automatically switches on and indicates the radio station or frequency stored with station button 1.
  5. If an incorrect code number is entered and confirmed, the word "CODE" appears again on the display. If an incorrect code is entered three times the word "WAIT" appears on the display and the radio locks up for approx. 10 min. If the code is entered incorrectly three times again the radio locks up again for 10 min. Three more incorrect entries (a total of 9 incorrect attempts) increase the lock-up time to 60 min. Another three incorrect entries lock up the radio for another 60 min. The waiting time runs only when the radio is switched on.

Posted on Dec 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have just bought a Mercedes 240 clk and when parked up the battery go,s completely flat is this a common fault


Battery may have a bad cell or a parasitic drain in the electrical system. Have you had the alternator and battery load tested ?

Sep 17, 2015 | 2005 Mercedes-Benz CLK 240

1 Answer

I need to know which wires go to which on a 2000


Kenwood wiring diagrams are usually on Kenwood website. You just need a jumper harness from the Toyota plugs to your player. A good local ICE shop or car accessories shop could help. Try EBAY?

Oct 20, 2014 | Cars & Trucks

1 Answer

How to replace factory radio in a 99 s70 volvo with a new model store bought radio


I imagine that you installed the code in the radio after installing it. Check that you picked up the correct power wire (accessory [power )

Aug 01, 2014 | 1999 Volvo S70

2 Answers

I need a radio wiring diagram


whats the nake and model of the cd player an the make and model of the car of instalation.

Oct 14, 2012 | 1995 Dodge Dakota

3 Answers

Mercedes Benz CLK 320 1998 Radio Code


try asking here

www.ukbookshelf.co.uk

May 30, 2010 | 1998 Mercedes-Benz CLK

1 Answer

Need to find battery location: 1999 Mercedes CLK 320


Hi, The battery is located in the trunk, under the trunk mat.

Apr 08, 2009 | 1999 Mercedes-Benz CLK

1 Answer

Wireing diergram


I gave up and let the professionals do it for me, But i still have a problom with connecting the electric arial to the kenwood KVT-627DVD

Jun 30, 2008 | 1994 Mercedes-Benz C-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...