Question about 2003 Kia Sorento

Open Question

Where is the vacuum canister located in akia sorento 2003

Posted by Anonymous on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3640 Answers

SOURCE: I have a 2003 Kia sorento 3.5 liter engine 2 wheel

possible causes--- p0453-- - Rubber hose to EVAP control system pressure is clogged, vent, kinked, disconnected or improper connection.
- EVAP control system pressure sensor may be faulty
- EVAP posible solutions, - Retight gas cap - Replaced EVAP Control System Pressure Sensor. have a good day !!

Posted on May 19, 2011

Ad
johnjohn2
  • 5763 Answers

SOURCE: where is the fuel pump relay on a 2003 kia sorento?

The fuel pump relay for this 2003 Kia Sorento is located insdie the engine compartment fuse box, open the hood locate fuse box and the relay is there, the fuse box cover should have listing of the location of the relay.

Posted on Oct 06, 2012

Testimonial: "Thank you for your answer!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 KIA Sorrento 2.4 were is the fuel pressure regulator located. put on adjustable fuel reg .need to disconnect stock one


fuel pressure regulators are normally located in the fuel manifold. They are either vacuum controlled or electronic controlled to maintain the right fuel pressure for engine requirements and to shut off the fuel pump when the ignition is turned off
If your manually adjusted unit will not do all that then you are asking for fault codes to appear and all sorts of problems to occur

Jan 18, 2016 | Kia Cars & Trucks

1 Answer

Code po441 03 serento evaporative emission system incorrect


could be a bad purge valve on the vapor canister under the car by the fuel tank.

Dec 02, 2012 | 2003 Kia Sorento

2 Answers

Where is the fuel pump relay on a 2003 kia sorento?


The fuel pump relay for this 2003 Kia Sorento is located insdie the engine compartment fuse box, open the hood locate fuse box and the relay is there, the fuse box cover should have listing of the location of the relay.

Oct 06, 2012 | 2003 Kia Sorento

1 Answer

Vapor canister 2003 cadillac cts


it will look something like this:
1_10_2012_5_20_27_pm.jpgand is usually located on the fender well on the engine side toward the front corner of the car (it may be inside the fender itself)
there would be 2-3 large vacuum hoses going to it which will help in finding it.

Dec 26, 2011 | 2003 Cadillac CTS

1 Answer

Check engine light on codes p0442 p0456 p0513


P0442 and P0456 are both evaporative emission error codes due to a small leak. The most common cause is a leaking gas cap or hose leak on that system. I did not list a code for your 0513. I am sending you a little information about your problem.. Best of Luck to you..


2003 Lexus RX300 3.0L 2003 Toyota Sienna 3.0L 2003 Toyota Highlander 3.0L, Eng Cfg V6, Eng Des 1MZFE, USA/Canada 2004 Toyota Avalon XL 3.0L
Check engine light is on with trouble codes P0442 and P0456. The codes are evaporative system small leak codes.
1. Verify that the gas cap is a factory Toyota gas cap and visually inspect that all hoses and lines are tight and connected.

2. Locate the canister closed solenoid and the vacuum switching valve on the canister. Manually ground them and verify that they operate and function. The canister closed solenoid is normally open and should close when grounded. The vacuum switching valve on the canister is normally closed and needs to open when grounded.

3. Verify that the hoses are not loose or pulled off the canister closed valve on the air cleaner housing. This has been a common problem on some models.

4. If no problem is found, the next step is to ground the canister closed solenoid and the vacuum switching valve under the vehicle and simulate an evaporative test and verify that the system holds a vacuum and functions normally. When the solenoids are grounded, back probe the Blue/Black (L/B) wire on the pressure sensor, and with no vacuum or pressure, the voltage should read around 3.3 volts. Start up the vehicle and turn on the purge vacuum switching valve and use engine vacuum to draw down the system to around 2 volts on the pressure sensor. If the voltage does not increase rapidly, there is no problem. If the voltage increases quickly, look for the leak in the evaporative system. Potential Causes: Canister Closed Valve
Disconnected Canister Closed Valve (CCV) Hose
Gas Cap
Harness
Vacuum Switching Valve - For the pressure sensor.

Aug 21, 2011 | 2002 Lexus ES 300

1 Answer

I have a 2003 Kia sorento 3.5 liter engine 2 wheel drive. Check engine light on reading code P0453 Evaporative Emission system pressure sensor / switch high input. Any idea what is the cause of this...


possible causes--- p0453-- - Rubber hose to EVAP control system pressure is clogged, vent, kinked, disconnected or improper connection.
- EVAP control system pressure sensor may be faulty
- EVAP posible solutions, - Retight gas cap - Replaced EVAP Control System Pressure Sensor. have a good day !!

May 19, 2011 | 2003 Kia Sorento

1 Answer

The air only blows out the defrost


this is caused by a loss of vacuum from the engine vacuum canister to the AC control switch, the canister is located under the hood, check the under hood vacuum diagram for exact location

Jul 21, 2010 | 2003 GMC Yukon XL

3 Answers

Unable to locate the position of the fuel filter


Follow the (usually steel) fuel lines from the engine bay underneath the vehicle all the way back to the fuel tank. fuel lines may resemble brake lines, they usually look very much alike. Find your fuel rail, it connects to fuel injectors, and then follow it to find the fuel lines that go to the fuel tank.

You may have to remove plastic covers from underneath the vehicle, one kia I worked on the fuel filter was halfway up the side of the fuel tank and we had to remove the whole undercarriage cover from underneath the vehicle to follow the fuel lines to it.

I assume you have the new fuel filter, so you know what you are looking for, if you don't it looks like a can with a fuel line coming out of either side of it. Similar to what an engine oil filter looks like, usually quite a bit smaller though.

Hope this helps :)

May 10, 2009 | 2003 Kia Sorento

Not finding what you are looking for?
2003 Kia Sorento Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...