Question about Chevrolet Cobalt

Open Question

All dash lights flickering on and off car will not accelerate when you push on gas pedal

All dash lights flickering on and off no acceloration when pushing gas pedal

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: sticky gas pedal

it is a dirty throttle plate. $280 is an absolute ripoff for a cleaning, it is about 10-15 minutes of work. They are probably quoting replacing the throttle body which about a $150 part.

Got to Autozone and get "CRC Throttle Body Cleaner". Remove aire inlet hose at throttle body with a screwdriver. Spray a *small* bit onto throttle plate, use clean rag or qtips to remove gum/varnish. Spray pivots and also clean around perimeter of the plate. Take it to an independent mechanic if you are unsure of the procedure.

Posted on Jan 13, 2009

  • 14 Answers

SOURCE: 2002 Camry won't accelerate

check throttle position sensor wire chewed up, broken wire or unplugged? check with volt meter mesure the voltage @ throttle positon sensor see if there's voltage goes up/down when u apply/release gas.

Posted on Aug 21, 2009

  • 743 Answers

SOURCE: check engine light flashing. car jumps and laggs

Flashing has to do with spark. I would guess that you haven't changed your plugs and wires lately.

Posted on Oct 12, 2009

iambanshee74
  • 3489 Answers

SOURCE: check engine light p0411 code what must i do

this has to do with your secondary air injection incorrect flow. start looking for a vacuum leak especially around the air duct from the mass air flow sensor to the throttle body.

Posted on Jan 25, 2010

  • 3 Answers

SOURCE: hesitation on acceleration engine runs fine otherwise

My 99 Audi A4 2.8 Quattro was havinga problem starting at times. It would idle poor upon start and then it would come up in rpm where it should be. I had hesitation from a start and after coasting for more than 5-8 seconds, the car would shake violently upon acceleration at about 1/3 throttle. I cleaned the Mass Air Flow Sensor. This helped but did not solve all my problems. I then replaced the Mass Air Flor Sensor. Little to no change there ($108.00). Lastly, I replaced the spark plugs. I bought Bosch plugs ($4.82 ea.). This got rid of all the symptoms. I had bad lugs and possibily a dirty MAF!

Posted on Aug 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2003 lincoln town car battery dash light stays on , will not start


Theres a power/ground problem somewhere in harness or instrument panel..send issue to majicmech@aol.com

Nov 27, 2016 | Lincoln Cars & Trucks

1 Answer

Hodo I fix a sticking accelorater on a 1995 ford aerostat


check the throttle cable for binding or fraying, then check the movement of the throttle shaft with the cable unhooked as they can wear and cause binding. if the cable is worn replace if the throttle shaft is binding replace assembly. check to make sure the gas pedal is not binding as well.

Sep 24, 2014 | 1995 Ford Aerostar

1 Answer

1998 mercury cougar rx8 155000m Hi the few problems my car is having is when I first push in the pedal it has a hesitation and won't immedieatly accelerate. It'll finally **** and take off after...


ENGINE HESITATES WHILE ACCELERATION

LOSS OF ACCELERATION


It can be fuel pressure issue or it's the problem with accelerator pedal or its clogged filters causing there.

There are many other possibilities. I suggest you to go through the list of help links mentioned below, these will help you to confirm where the actual fault lies: -------

Jerks and Hesitates During Acceleration?

http://technoanswers.blogspot.in/2012/07/2004-dodge-town-country-jerks-and.html

-----------

Loss of acceleration?

http://technoanswers.blogspot.in/2012/02/loss-of-acceleration.html

---------

Headlights flickering and car hesitates to start?

http://howtobyme.blogspot.in/2012/02/headlights-flickering-and-car-hesitates.html

--------

How exactly the Vehicles Accelerator Cable works?

http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-accelerator-cable.html

-------------

How exactly Vehicles Accelerator Pump Diaphragm Works?

http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-accelerator-pump.html

--------

2000 Toyota Avalon: Engine Lean Codes and Knock Sound on Acceleration?

http://whatisbyme.blogspot.in/2012/05/2000-toyota-avalon-engine-lean-codes.html

---------

2004 Toyota Avensis: Acceleration And Deceleration makes noise on Front End?

http://whatisbyme.blogspot.in/2012/05/2004-toyota-avensis-acceleration-and.html

---------

Wheel hop under hard acceleration?

http://technoanswers.blogspot.in/2012/04/wheel-hop-under-hard-acceleration.html

--------

2009 Chevy impala accelerator pedal sensor?

http://technoanswers.blogspot.in/2012/02/2009-chevy-impala-accelerator-pedal.html

---------

Nissan Pathfinder stalls and bucks on Acceleration?

http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-stalls-and-bucks-on.html

--------

Acceleration lag problem?

http://repairhelpcenter.blogspot.com/2012/01/acceleration-lag-problem.html

-------------

These details will help.

Thanks.

Nov 28, 2012 | Cars & Trucks

1 Answer

When i change oil i need to know how to reset oil light on the dash


-Turn the key to the run position (where all the dash lights come on)
-Immediately push the accelerator pedal to the floor 3 times, taking about 1 second for each push
-The pedal has to go all the way to the floor and all the way back up.
-After the third pump, turn the key to the off position

It may take a couple of tries to get it right. It's basically a rhythm: key on...push...push...push... key off.

Hope this helps!

Oct 29, 2010 | 2008 Dodge Avenger

2 Answers

NO POWER WHEN PUSHING GAS PEDAL


Only way to know whats going on is to retrieve the trouble code for the check engine light by using a OBD II diagnostic's tool, it's likely the poor hesitation in the vehicle's acceleration is causing the check engine light to appear, the OBD II diagnostic tool plugs into a data link connector under the driver's side dash, you can buy one at most auto parts store's, or if you don't want to buy one some auto parts store's will do a autoscan of your vehicle at no cost.

Apr 01, 2009 | 1998 Mazda B-Series

1 Answer

Engine makes noise as I accelerate, and also just as I let off the accelorator pedal


try a higher octane gasoline or maybe a timing adjustment.try higher octane gas first

Mar 20, 2009 | 2003 Toyota Matrix

1 Answer

The stop light on my peugeot 306 keeps coming on on my display


try to adjust the brake switch, bring it closer to the pedal, i think it is to far away from the pedal, i think you just push it hard in rubber grommit, not sure come to think.

Jan 17, 2009 | 1991 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...