Question about 2002 Ford Explorer

1 Answer

My ford explorer wont start

Battery is new as well as the cables. Lights and windows are working. When I turn the key nothing happens, not even a cranking sound. I do hear a humming sound when I turn the ignition

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

So your fuel pump is working, it could be that your starter is not. Check your starter.

Posted on Feb 22, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 14 Answers

SOURCE: FORD EXPLORER IGNITION IS STUCK

just replace the ignition it is only about 25 dollars or so and it should not have a pats system for that year you must have the key to get the ignition out though do you have another key ... the key must be turned to get it out and back in you can drill the lock and then turn it so you can remove it but if you are not comfortable doing this call a locksmith.. much cheaper than a dealer

Posted on Jan 13, 2009

  • 62 Answers

SOURCE: starter location on 91 ford explorer xlt and is replacing easy?

2 things
1 starter is bad its located on the driver side of the engine beside the oil pan. 3 bolts and 2 electrical connections

2 bad battery cables. i have replaced a lot of battery cables on these they let enough power through to get a click but not enough to start the engine. this cable is a special cable only available through ford or you can make 1 yourself

Posted on May 14, 2009

  • 104 Answers

SOURCE: removal and replacement of key tumbler 1994 Ford explorer

look at the steering column below the ign lock and tumbler there should be a small hole turn key to on pos and push a small rod up the holethis then should release the lock and tumbler,no hole then wheel and coumn has to be stripped to get to lock retainer

Posted on Oct 05, 2009

caroldon
  • 17130 Answers

SOURCE: My Ford five hundred won...t turn over

Possible that the solenoid is faulty if the sound is a click without any cranking. If not this can also be the starter motor not able to turn but trying to move. It can be poor brushes, poor contacts or even if the starter is jammed at the pinion and flywheel.
Try to engage the car in 2nd gear and push to disengage or try to push and start to confirm if this is a low battery problem.

Posted on Apr 12, 2011

  • 869 Answers

SOURCE: 1998 Ford Explorer: My mother lost both keys. I

the keys and locks are not only specific to a particular ford explorer year model but they are also specific to a particular model.

Posted on May 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car wont start and my windows dont work


Check battery connections and cables. Ground may be broken. Remove cables and clean battery posts then reconnect cables.
Check ignition switch, replace as needed.

Jan 21, 2013 | 1998 Chevrolet Camaro

2 Answers

2002 ford explorer wont start even after new battery...


Before you go changing out the starter check for a burnt out fusible link going to the starter it will look like a wire but acts as a fuse and they burn in two just like a fuse. The symptoms you just describe are those of a burnt fusible link.

Mar 26, 2010 | 2002 Ford Explorer

1 Answer

My 2000 ford explorer suddenly wont start... the battery was relpaced less than 6 months ago. the key turns but nothing happens, no dash lights or any starting sounds, and at the same time my hood does not...


does the battery have a full charge to it? If so clean battery terminals and chck battery cable at starter make sure its getting good contact. Make sure battery ground is making good contact at engine. Can you jump the car off? If so take off positive battery terminal while the car is running if the car dies altenaters bad replace it.

Oct 18, 2009 | 2000 Ford Explorer

2 Answers

2004 Ford explorer will not start


Sounds like connections or cables. They may appear to look good but if they are aftermarket terminal ends they get corrosion under the bolt down clamp that holds the wires in. If they are factory cables that are molded on to the ends of the wires the same thing can happen. The easiest and cheapest thing to try is to put aftermarket terminal ends on the cables. Make sure you wirebrush the ends of the cables after you strip them and tighten them evenly and securely. Also clean the battery side thoroughly. If this doesn't work check the starter relay. Its the first place the red cable bolts to after the battery. Check the connections and try putting a jumper wire between the battery positive cable and the small terminal marked with an "S". One of these solutions should take care of this.

Nov 26, 2008 | 2004 Ford Explorer

Not finding what you are looking for?
2002 Ford Explorer Logo

261 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...