Question about 1999 Pontiac Grand Prix

Open Question

Replace a cv axle on 1999 grand prix - 1999 Pontiac Grand Prix

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 174 Answers

SOURCE: trouble removing cv axle from 1999 pontiac grand prix

you will need to take the two bolts out of the strut that connects to the spindle backing plate.this will let the backing plate pull out enough to pull the cv axle out.

Posted on Jun 12, 2009

Ad
duane_wong
  • 6826 Answers

SOURCE: How to Replace the Starter in a 1999 Pontiac Grand

starter is located on the engine block down below.

Removal & Installation To Remove:
Before servicing the vehicle, refer to the precautions in the beginning of this section.

  1. Remove or disconnect the following:
    • Negative battery cable
    • Radiator lower air deflector
    • Torque converter cover
    • Electrical connections from the starter
    • Starter motor
To Install:
  1. Install or connect the following:
    • Starter motor and torque the bolts to 32 ft. lbs. (43 Nm)
    • Starter solenoid BAT terminal
    • Starter solenoid S terminal
    • Torque converter cover and torque the bolts to 89 inch lbs. (10 Nm)
    • Radiator lower air deflector and torque the bolts to 15 ft. lbs. (20 Nm)
    • Negative battery cable
Starter removal/installation – 3.1L & 3.4L engines 9306zg15.gif

Starter removal/installation -3.8L engine 9306zg17.gif

Posted on Jul 15, 2010

  • 15973 Answers

SOURCE: I have a 2000 Grand

To test the CV joints make a hard right circle and then a hard left one. You dont have to do this at a high speed and you can do it in a parking area. IF you hear clunking then it is the CV joint.

Posted on Aug 20, 2010

  • 5341 Answers

SOURCE: pontiac grand prix passenger side cv axle

ello, ello. You just push hard till you hear the little circlip on the end of your axle shaft "click", meaning it has seated inside the transmission.

Posted on Nov 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 grand prix front tires are wearing out on the inside tread ?


It could be either the ball joints or the tie rod ends are worn out. With it being a front wheel drive car also check your drive axles. Make sure that the axle boots are not torn or cracked which if they are cracked or torn replace them and repack the cv joints.

Jun 28, 2012 | 2000 Pontiac Grand Prix

1 Answer

Pontiac grand prix passenger side cv axle replacement how do i get the axle to lock into the transmission


ello, ello. You just push hard till you hear the little circlip on the end of your axle shaft "click", meaning it has seated inside the transmission.

Oct 09, 2011 | 1994 Pontiac Grand Prix

1 Answer

How to know if a universal joint is going bad on a 2000 Grand Prix?


You have cv joints,they are in the cv axle on each side of the car,two axles,there are two in each axle,if you turn the car sharp either way,you can hear the click click ,click in witch ever side it is on,that will be the axle that needs to be replaced,the axle for this car at napa auto parts is only about 53.00 exchange.

May 26, 2010 | 2000 Pontiac Grand Am GT

1 Answer

Need help removing Cv axles front 1999 Jeep Grand Cherokee 4x4


I'd like to take the time to walk you through it , but sounds like you might prefer pictures as well so go to (autozone.com) and sign up for free, & get parts prices, as well as access to repair manuals with pictures & step by step instructions.

Jul 28, 2009 | 1999 Jeep Grand Cherokee

1 Answer

Trouble removing cv axle from 1999 pontiac grand prix


you will need to take the two bolts out of the strut that connects to the spindle backing plate.this will let the backing plate pull out enough to pull the cv axle out.

Jun 10, 2009 | 1999 Pontiac Grand Prix

1 Answer

Need to know a parts name


If you are referring to the metal part the axle slides into,It's cold the transmission,If it is leaking around the shaft it is called the inner cv axle seal,But if something blew up,I'd let a mechanic physically look at it.

May 16, 2009 | 1995 Pontiac Grand Prix

2 Answers

Front end vibration


this is most often caused by worn out drive axle constant velocity joints or CV joints as we tech's call them, have them checked for torn boots or excessive wear, I am sure one or both will be found.

Jan 06, 2009 | 2000 Pontiac Grand Prix

Not finding what you are looking for?
1999 Pontiac Grand Prix Logo

Related Topics:

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...