Question about 1997 Cadillac DeVille

Open Question

How to replace a rack and pinion on 1997 cadillac deville

Tools needed

Posted by Anonymous on


5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1990 Answers

SOURCE: 1997 CADILLAC DEVILLE D' ELEGANCE need to replaced air suspension

Try going to a Local Mechanic or Repairing them Yourself. Either way is a LOT Cheaper.

Posted on Jan 21, 2009

  • 76691 Answers

SOURCE: replacing a radiator in cadillac deville northstar 1997

a drain pan, a hose release tool, flare nut wrenches and simple hand tools, such as a set of wrenches (sae and metric) and sockets with a variety of extensions. it would be helpful to have both 1/4" and 3/8 inch drive sockets and ratchet's

Posted on Mar 28, 2009

  • 607 Answers

SOURCE: need to replace turn signal switch 93 cadillac deville

First do you have a sterring wheel puller. Can't remove the steering wheel without one. Quite an involved job including snaking the electrical connector end through the steering column. I wouldn't recommend it to the novice

Posted on Mar 29, 2009

  • 1986 Answers

SOURCE: need directions to remove driver door interior panel 1997 deville

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls

Posted on Sep 23, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to take off rak in pinon on 98 cadillac

Hey Irma.. here is a video.. this is not an easy thing to do... you need to be very mechanically inclined and experienced.. you have outer tie rods, X2, (steering system) that have to be disconnected.. the intermediate shaft has to be disconnected and collapsed... the power steering hoses have to be removed and sealed (put a baggie around them and tape into place - keep dirt out of threads and doesn't contaminate the o-rings or hose careful with those o-rings, they are not "just regular o-rings.. you will need to refill the power steering fluid reservoir after you reinstall everything and start the engine..(PUT some fluid in first!! - so you don't have a dry gear!).. Do you have the tools necessary.. 2 sets of jack stands, - DO NOT attempt this without them.. NEVER trust a jack!!!

Rack Pinion Steering Replacement Cadillac Deville 1997

Jun 19, 2017 | Cadillac Cars & Trucks

1 Answer

How do I replace the rack and pinion on a 2007 Cadillac DTS?

You go to a dealer - this is a MAJOR repair job involving special tools and moving the engine out of the way.

Sep 16, 2014 | 2007 Cadillac DTS Sedan

1 Answer

My 99 cadillac deville wont turn left

Sounds like your rack and pinion is shot replace it

Mar 18, 2014 | 1999 Cadillac DeVille

1 Answer

Power steering pressure hose, I need to find out the location on a 1997 cadillac Deville

Follow the lines from the power steering pump to the rack and pinion. There should be a high pressure hose, and a low pressure return line.

Aug 13, 2010 | 1997 Cadillac DeVille

1 Answer

How do you remove the rack and pinion from a 2002 cadillac deville. there is a rubber boot connected to the steering gear and the steering column, how do you remove this boot?

set steering whell straight. push rubber boot up there is a 12mm/7-16 bolt that connects the steering shaft to the rack and pinion removeboth fron tires remove p/s lines and all other fastners for the rack and pinion

Aug 13, 2010 | 2002 Cadillac Deville

1 Answer

I have a 97 cadallic deville and when I hit small bumps it makes a rattling noise and the stearing shakes a little when I am driving

Most likely your 1997 Cadillac Deville needs the struts replaced and possibly a rack and pinion replacement. Of course, try the easiest answer first by having the alignment checked before you take more extreme measures.

Jun 16, 2010 | 1996 Cadillac DeVille

1 Answer

Steering rack replacement on a 99 cady deville, how difficult ?

Rather difficult. Involves disconnecting the tie rod ends. Steering linkage from steering wheel. Disconnecting the power steering pump lines and unbolting the rack and pinion from the body. Not a lot of room to get at stuff.

Apr 24, 2010 | 1999 Cadillac DeVille

1 Answer

The car is swaying when you get to 60 mph

your off balanced you need to alighn the front train and Rack and Pinion and you will be good to go

Apr 03, 2010 | 1997 Cadillac DeVille

1 Answer

My power sterring pump is full of fluid

You need to replace the rack and pinion.

Mar 24, 2009 | 1997 Cadillac DeVille

Not finding what you are looking for?
1997 Cadillac DeVille Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides