Question about 2005 Chevrolet Malibu
If the AC fails to provide cold when it is turned on have the AC system checked for a low charge of refrigerant due to a leak in the system. If it islow it is likely the AC compressor front shaft seal is leaking.
Posted on Feb 21, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Air conditioning not cool
The charging port is in the larger of the 2 AC lines from the AC compressor on the engine, it will be near to or in the round cannister (called an Accumulator) that larger AC line goes near the firewall at the back of the engine bay.
Posted on Apr 28, 2009
i think it stands for traction control. most cars with that say ETC which stands for electronic traction control. if you have a manual for the car it should say what it is.
Posted on Sep 27, 2009
SOURCE: 2005 tahoe no air blowing
as long as all the fuses are good.. its probably the blower resistor/module... located next to the blower motor under the pass. side of the dash..
Posted on Oct 13, 2009
The turn and hazard flashers are integrated into one flasher on these models. The flasher is located in the hazard warning switch and the hazard warning switch is located on the trim plate. Replace the flasher by unplugging the old one, removing it from the panel, and plugging in the new one.
Remove the bezel from the ignition switch
Carefully remove the instrument panel accessory trim plate.
To remove the trim plate, use a suitable prytool to carefully apply pressure at the retaining clip points . . .
. . . then gently pull the accessory trim plate away
Detach the electrical connector from the hazard warning switch.
Unplug the electrical connector from the hazard warning switch . . .
Unfasten the screw securing the hazard warning switch and remove the switch.
. . . then unfasten the screw securing the hazard warning switch and remove the switch from the vehicle
Installation is the reverse of removal.
Posted on Dec 01, 2009
Testimonial: "just what I needed, thank you so much."
You will need to have the radio reset or checked out at the dealer.Ther could be a cd stuck in it.Or the radio/CD player may have be on when the battery power got to low.
Posted on Jan 11, 2010
Tips for a great answer:
Jul 16, 2017 | Cars & Trucks
Mar 05, 2015 | 2005 Chevrolet Malibu
Sep 20, 2014 | 2005 Chevrolet Malibu
Sep 14, 2010 | 2005 Chevrolet Malibu
Sep 07, 2010 | 2005 Chevrolet Malibu
Jun 21, 2010 | 2005 Chevrolet Malibu Maxx
Sep 27, 2009 | 2005 Chevrolet Malibu Maxx
Apr 24, 2009 | 2005 Chevrolet Malibu
159 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: