Question about Cars & Trucks

Open Question

While going over a bump sound comes like left front wheel is touching some thing. Vehicle Toyota VIOS 2002

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pippall
  • 1486 Answers

SOURCE: front left wheel area makes weird sound over bumps

Have the bottom ball joint checked

Posted on Jul 06, 2009

  • 333 Answers

SOURCE: 99 camery solara...ratlingnoise front left wheel,

Strut tops are a common failure on the 97-01 era Camry/Solaras.

They will make a hollow rattle sound whenever you hit bumps or uneven pavement.

They can be replaced one at a time, and do not require strut replacement if your old struts are still in good shape.
Replacement does require a strut compressor and an alignment afterwards, placing it outside the scope of most do-it-yourselfers.

It is labeled "suspension support" in the following diagram. The bearing below it is typically replaced at the same time.
2d7f803.gif

Posted on Sep 14, 2009

Testimonial: "i think you are right on. when the car was new i had these replaced once but warrenty covered it. thanks for your response."

  • 1 Answer

SOURCE: Steering Wheel Vibration

Front shocks are week

Posted on Nov 23, 2009

RonPark
  • 855 Answers

SOURCE: front suspension rattles

It could be, but check shock bushings, control arm bushings, sway bar and brackets. There are anumber of things that can cause a rattle. The first thing to be done is jack the truck up mput it on stands and start checking before replaceing parts. Pay close attention to shocks bushings and anything rubber.

Posted on Nov 25, 2009

  • 541 Answers

SOURCE: replace front left wheel berring on 2002 GMC Yukon

do not replace only the bearing. replace hub assembly. remove rim/tire , remove caliper, mounting plate, rotor. . un bolt hub assembly, unplug abs. remove front axle nut if 4x4. you may need to rent the axle nut remove kit and hub puller. pull out hub. drive axle reward out of hub. install new part. do not torque hub over 90lbs. check with parts sell for spec

Posted on Jan 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace the front wheel bearings on my 2002 kia sportage 2 wheel drive


I looked at it but there is a lot of little things to do soooooooo
go to auto zone site and log in (its all free ) go to (my vehicle) then to (repair help) then to (vehicle repair guide ) then to (suspention) then on left of page move down to wheel bearings . and you have it.
Woody

Oct 12, 2014 | 2002 Kia Sportage

1 Answer

Where is toyota constant velocity u-joint located


Like all front-drive cars using CV joints, there are 4 CV joints on the car near the engine. The vehicle has 2 axles (left and right, driving the corresponding front wheel). Each axle has 2 joints, one on each end. Typically the outer CV joints fail first, as their range of movement is greater due to steering the vehicle.

In modern practice the entire left or right axle is replaced when a CV joint goes bad.

Constant Velocity joints and U-joints perform a similar function, but are not really the same thing. U-joints are more typically used on rear-drive or truck-based 4WD vehicles.

Apr 27, 2014 | 2002 Toyota ECHO

1 Answer

Knocking Noise from Front End Toyota Corolla 2004


Ensure the wheel nuts and Axle nuts are properly torqued to the specification. Lift up the front wheels, place supports under the car and do the following:
- Sit if front of right wheel, slightly move it right and left and feel any abnormal noise if coming out of it. If click-click or Tuck-Tuck sound is observed it could be due to the excessive play in the tie rod end, rack end, ball joint wheel bearing or U joint. Next hold the Tire with your one hand at the top and with other hand at the bottom. Shake the Tire inside out and feel any noise or play. If play is observed, it could be the worn out ball joint or the wheel bearing. Now hit the Tire at the top with rubber hammer and observe any rattling noise coming from near the center of the wheel. If you could listen to the extra noise it could be due to the dried up caliper pins. Grease the pins with graphite grease. If all is found fine, similarly check the left wheel and repair as necessary.

Sep 15, 2013 | Toyota Corolla Cars & Trucks

1 Answer

Front left wheel periodicly causes front vibration


The brake pad/shoe on the left front wheel may be coming off gradually. When it touches the drum/disk it causes friction and thus heats up the left wheel rim. With this heat the tyre pressure goes up, naturally. Please have the brakes checked and adjusted.

Mar 09, 2010 | 2002 Oldsmobile Alero

2 Answers

Oscilating humming coming from left front wheel


SOUNDS LIKE YOU HAVE BAD LF WHEEL BEARING..JACK UP FRONT OF VEHICLE..BLOCK REAR WHEELS..PUT TRANSFER CASE IN NEUTRAL,SPIN EACH FRONT WHEEL BY HAND WITH OTHER HAND ON COIL SPRING..YOU SHOULD FEEL ROUGHNESS IN SPRING ON SIDE THAT HAS BAD BEARING..IT IS A HUB/BEARING ASSEMBLY

Jul 23, 2009 | 2002 Jeep Grand Cherokee

2 Answers

Front shocks


it can be many thing shock,top plate ,stabilisator link , good luck pierre

Sep 16, 2008 | 1998 Toyota Camry

4 Answers

I hit a bump on the right front side and it makes a roaring type noise and shimmies a bit .. can feel it under my left foot. also at times it will make that soud when i make a right hand turn... it is ...


Sounds like your left front wheel bearing is going bad. When you make a right turn, or compress the right front suspension over a bump, it forces the car to roll to the left. This loads the suspension on the left side, which will exaggerate a wheel bearing problem. Are you hearing the noise at all when travelling on the highway in a straight line? If so, it'd be either a grinding sound or a hollow humming noise. If you aren't, it may be that the bearing is just starting to go bad.

A quick test to see if the bearing is bad is to jack the car up at that corner, grab the wheel at the top and bottom, and shake it hard - if there is any movement or looseness, your bearing is shot. If there is none, it doesn't mean the bearing is fine, but it could be that it's just starting to go bad (which would be why you only hear it in turns and bumps, but not straight-line yet).

Aug 01, 2008 | Chevrolet Avalanche Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...