Question about 1999 Nissan Altima

Open Question

Trunk latch is broken on 1999 nissan altima - 1999 Nissan Altima

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
ilragatzzo78
  • 241 Answers

SOURCE: Replacing a starter for a 1999 Altima

  1. Disconnect battery ground cable.
  2. Disconnect starter wiring from starter.
  3. Remove starter retaining bolts and the starter.
  4. Reverse procedure to install.
the bolts should be on the drivers side.
you will have to crawl underneath the car to do this task

Posted on May 15, 2008

Ad
  • 200 Answers

SOURCE: Nissan Altima fuel filler release latch broke ... need alternate

Never heard of anything like that.  But those latches are not as secure as most think, just take a flathead screwdriver, put a piece of cloth around it to protect your paint, and pry the door open, just when you think it's about to break something...pop, it opens just like that.  I've done this quite a few times, only broke one so far.  :-P

Posted on Jan 23, 2009

stanley141
  • 124 Answers

SOURCE: The alarm on my 08 Nissan Altima keeps going off.

YOU WILL REQUIRE DIAGNOSTIC TO DO THIS BUT IF YOUR VEHICLE IS LOCK IN A SAFE AREA JUST LEAVE ONE COMPONENT OPEN AND CHECK IF THE ALARM WILL SOUND AGAIN REPEAT THIS TILL YOU FIND THE DEFECTIVE COMPONENT.

Posted on Jul 21, 2009

ZJLimited
  • 17970 Answers

SOURCE: How do you remove a 1999 Nissan Altima starter?

Nissan Car Altima & Sentra 1999-06 StarterRemoval & Installation

  1. Remove or disconnect the following:
    Negative battery cable Air duct Harness protector from the harness Starter wiring at the starter Starter-to-engine bolts Starter from the vehicle


  2. b53bb6c.jpg
    Fig. Starter location and mounting detail-3.0L Maxima with a manual transaxle


    b2eb267.jpg
    Fig. Starter location and mounting detail-3.5L Maxima

To install:
  1. Install or connect the following:
    Starter and torque the long bolt to 57-72 ft. lbs. (77-98 Nm) on Altima and Maxima and 41 ft. lbs. (55 Nm) on 350 Z. torque the short bolt to 22-30 ft. lbs. (30-41 Nm) Starter wiring Harness protector Air duct Negative battery cable
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter

To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

1.6L & 2.0L Engines
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negaative battery cable

1.6L, 1.8L & 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negative battery cable

1.8L & 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negative battery cable

2.4L & 2.5L Engines
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

2.4L Engine
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

2.5L Engine
  1. Remove or disconnect the following:
    Negative battery cable Air cleaner cover and duct Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

3.5L Engines
  1. Remove or disconnect the following:
    Negative battery cable Air cleaner case (upper) and air cleaner to electric throttle control actuator tube. Harness protector from the harness Starter wiring at the starter Starter-to-engine bolts Starter from the vehicle

    42c548c.jpg
    Fig. Starter location and mounting detail-3.5L engine

continue...

Posted on Apr 05, 2010

  • 237 Answers

SOURCE: 2005 NISSAN ALTIMA 2.5S THE TRUNK RELEASE BUTTON

check in your glove box on left hand side.valet switch may have accidentally set.let me know how you make out!

Posted on Feb 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse located in a 2007 Nissan Altima to unlock the trunk


2008 Altima2.5S Trunk wont open GRRRRRR - Nissan Forums : Nissan Forum

www.nissanclub.com/.../2007...nissan-altima.../298533-2008-altima2-5s-...
Dec 26, 2009 - 6 posts - ‎6 authors My trunk wont open from any of the buttons...the remote wont open it , the dash switch wont open it nor will the. ... Is there a fuse blown? ... 2007 Nissan Altima 3.5 SE CVT: 14.540 @ 96.530 MPH <----click here! ... When the cancel switch locatedinside the glove box is OFF, the trunk lid cannot be opened ... Trunk doesn't open
7 posts
Oct 17, 2012
How to disable trunk release in 2009 2.5S Altima?
15 posts
Jun 26, 2011
broken trunk release??
10 posts
Feb 24, 2009
Dead battery = Screwed !
15 posts
Aug 18, 2008
More results from www.nissanclub.com

Nov 03, 2015 | Nissan Cars & Trucks

1 Answer

2004 Altima S 3.5. Why doesn't trunk release lever on driver door open trunk?


emergency release is connected directly to latch release ---the linkage rod may be disconnected ,latch may need lube --spring damaged or disconnected latch simple enough to replace junk yard cheapest --online,auto stores -or dealer most expensive

Aug 02, 2015 | Nissan Cars & Trucks

1 Answer

2000 Nissan Altima trunk latch (self) activates (opens) when ingnition is turned to off.


electrical trunk lid latch more likely broken if keep open release trunk.

Jan 03, 2013 | 2000 Nissan Altima

1 Answer

Lever on driver side floor that opens gas tank & opens trunk is broken off


The cables can be replaced - they are available from the dealer.

Jul 27, 2012 | 1999 Nissan Altima

1 Answer

Is there a fuse for a 02 nissan altima trunk latch


If it doesn't even click, then maybe. My Nissan trunk latch needs lubricating or it doesn't open... Had to crawl into the trunk through the back seat hatch to open the emergency pull-cord. Twice.

Jan 07, 2012 | 2002 Nissan Altima

1 Answer

The trunk latch on my 2003 Nissan Altima will not work. Whenever I try to close it, the latch will not catch so I have it tied down with a rope. How can I fix this?


It sounds like the latch mechanism is in the closed position, which would prevent it from catching when you close the trunk lid. Try using your key to unlock the latch, or activate the trunk opener from inside the car. If neither of those works, you may have to use a screwdriver or similar bladed tool to manually open the latch. Also, check the metal bracket that the latch catches on. It could be out of position, or could have something covering it, preventing the latch from locking onto it.

Apr 08, 2011 | Nissan Altima Cars & Trucks

1 Answer

The trunk is stuck closed on my 1999 nissan maxima. the release clicks, but won't work--and the key will not work as well.


I had a similar problem with my 1988 Toyota. You may have to remove the back seat and climb into the trunk through the cab of the vehicle to access the latch mechanism. Once you do this, you can find the problem and address it. My problem was broken clips on the connecting rods from the key to the actual latch. There may be some broken linkage that keeps the key from moving. I hope this helps. FYI don't do it on a hot day!

Apr 09, 2010 | 1999 Nissan Maxima

1 Answer

Can't open the trunk of my nissan sentra 1999


you have a bad trunk latch, you will need to replace that latch, its not a hard repair though, like three nuts, you will need to get the trunk open from the inside though, toy with the latch until it opens, you will then be able to replace the part.

Sep 04, 2009 | 1999 Nissan Sentra

1 Answer

Trunk wont latch


you must adjust the trunk latch for this to work properly,up or down.

Jul 15, 2009 | 2006 Nissan Sentra

Not finding what you are looking for?
1999 Nissan Altima Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...