Question about 1986 Nissan Pickup 4WD 1986

1 Answer

What's the easiest way to change the starter on a

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

The same way you would change a regular car starter.

Posted on Feb 21, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 1993 Nissan pickup, replacing starter

I have a '95. It's behind the passenger side tire. Remove tire and rock guard if you have one--couple of screws--and you can easily access it. two bolts facing rear of car, two connections up front. Honestly it was the easiest replacement I've ever done. Just disconnect your battery first.

Posted on Jul 29, 2009

old marine
  • 1927 Answers

SOURCE: putting on a starter

According to the manual, it's pretty straightforward. Disconnect the ground cable from the battery. Then remove all wires connected to the starter/solenoid -- one heavy wire from the battery, and one or two smaller wires. Then remove the bolts which attach the starter to the engine. The starter is at the right side of the engine at the rear.

Installation is the reverse of the above. Make sure you have all wires attached and tight before you reconnect the battery ground cable.

Posted on Jul 30, 2008

old marine
  • 1927 Answers

SOURCE: troubleshooting air conditioner thermostat 1995 nissan pickup hardbody

The thermostat is located where the lower radiator hose goes into the engine. I've had to replace mine, and it took a while to find it. I found the easiest way to get at it is to remove the power steering pump (hoses attached) and set it over to the side to get at the bolts on the thermostat housing.

Good luck!

Posted on Jul 25, 2008

  • 3600 Answers

SOURCE: my 1990 nissan hard body d21 short bed truck wont

fuel pump and fuel sock is bad replace them but first replace the fuel filter, it's located driverside on the inside of frame rail under door.

Posted on Aug 14, 2009

  • 56 Answers

SOURCE: 1997 Nissan Pickup Won't Start in very High Humidity

Sounds like there may be water or condensation entering your distributor cap. Cheap fix and might be obvious if you inspect its inside.. look for corrosion or moisture.

Posted on Dec 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1986 Nissan 4x4 hard body pickup truck with 2.4 liter v-6 with throttle body


need to check throttle body and throttle body valve and fuel pressure regulator for damage dirt or stuck open ---fuel pumps at around 50 + psi so if regulator or throttle body is not closing off residual pressure will push fuel throug

Sep 24, 2016 | Nissan Hardbody Cars & Trucks

1 Answer

Where is the starter relay located on a 1997 nissan hard body pickup


Hi Eddie,Here's a link to a Nissan part site,the starter relay is 25224G.If you look at the truck picture,it has letter's,find letter G AND THAT'S WHERE THE STARTER RELAY IS,BY THE WAY,i HAVE A MINT 85 nISSAN 720 4X4,HERE'S A VIDEO OF IT,TAKE CARE. Parts found for 1996 Nissan Hardbody Pickup 1995 1997 Body Electrical Relay CHECK MINE OUT. 85 Nissan 720 4x4 2 4 Weber conversion

Jul 09, 2015 | Nissan Cars & Trucks

1 Answer

Repair manual for 1991 4x4 nissan hard body pickup


Yeah Joe,Nissan's are well known for head gaskets to blow.Here's a link to replace head gasket.

Feb 10, 2013 | 1991 Nissan Pickup

1 Answer

Where is the ECm located on my 96 Nissan Pickup 4x4, 2.4L, also need to locate the mass air flow sensor


ECM LOCATED UNDER PASSENGER SEAT. MASS AIR FLOW SENSOR LOCATION IS ON THE THROTTLE BODY.

Sep 02, 2011 | 1996 Nissan Pickup

1 Answer

Please could i get the correct tyre pressure list from nissan for my 2010 np300 2.4 hard body double cab not the 4x4 model


Read the side of your tires that information is on it along with size, rating, and like and kind safety info. Also the owners manual has it under maintenance section, and look on the glove box door or the right side door jamb all places were the manufacturers put that information.

Sep 29, 2010 | 1995 Nissan Pickup

1 Answer

How to change a starter for a 4x4 sr 5 91 toyota v6


you must remove oil filter and exhaust heat shield.

May 10, 2010 | 1991 Nissan Pickup

1 Answer

1993 Nissan pickup, replacing starter


I have a '95. It's behind the passenger side tire. Remove tire and rock guard if you have one--couple of screws--and you can easily access it. two bolts facing rear of car, two connections up front. Honestly it was the easiest replacement I've ever done. Just disconnect your battery first.

Jan 11, 2009 | 1993 Nissan Pickup

1 Answer

Troubleshooting air conditioner thermostat 1995 nissan pickup hardbody


The thermostat is located where the lower radiator hose goes into the engine. I've had to replace mine, and it took a while to find it. I found the easiest way to get at it is to remove the power steering pump (hoses attached) and set it over to the side to get at the bolts on the thermostat housing.

Good luck!

Jun 25, 2008 | 1995 Nissan Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14251 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...