Question about 2003 Pontiac Sunfire

1 Answer

Do you know where the sensor is for the remote door locks and truck release on a 2003 pontiac sunfire

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Pontiac Master
  • 76,164 Answers

The signal comes in over the radio antenna.

Posted on Feb 21, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 393 Answers

SOURCE: Installation (wire diagram) for remote starter on a 2001 Pontiac Sunfire

try going to diy rattler.com

Posted on Nov 15, 2008

firemanb0b
  • 5 Answers

SOURCE: theft system - battery drain

Take it back to the guy that installed the alarm system cos mine runs 3 LEDs & its fine

Posted on May 03, 2009

  • 701 Answers

SOURCE: need location of crank angle sensor on 1997 pontiac sunfire 2.2 liter

Hello oldiro: My name is Roger and I can help. From under the vehicle look up between the transmission and the side of the block. Mid motor above the pan rail there is a bolted in sensor. This should be the crank sensor.It will have two wires plugged in to it. Please rate this answer as this lets us know you received the information you asked for. Should you need further help please just ask. Thank You for using FixYa. Roger

Posted on May 06, 2009

  • 272 Answers

SOURCE: locked my keys inside, can't find a door diagram online

A slim Jim is a fishing expedition. What you need to do is not worry about diagrams. Realize that the locking mechanism has just a very few parts that interconnect. The key hole where you insert your key, and the lock button that go up and down (or in some cases forward and back) are mechanically connected. It's that connection your fishing for and trying to move. You need to 'fish' between the lock and the button and try and 'hook' that linkage and move it in the dirction that moves your lock button to the unlocked position. If you really need a diagram many of the car part web sites will display a diagram for car parts. I've unlocked alot of doors with the method described and have never seen a diagram for what I'm doing. Good luck!

Posted on May 10, 2009

  • 355 Answers

SOURCE: PASS LOCK ON 1999 PONTIAC SUNFIRE

you need to get rid of passlock or spend a lot of money in the new cylinder and key that only a dealer would make. There is a detailed write-up for bypassing passlock here: http://newrockies.ca . The guy is great, and this was the only way I was able to save my Park Avenue.

Posted on May 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2003 Pontiac sunfire it is stuck in park-is there a reset button---there have been no fluid leaks


Usually the problem is the brake switch or the shift lock solenoid. You may be able to take the shifter out of park by trying it before you turn the key to the on position.
Check your owners manual to see if there is an emergency release.

Aug 30, 2013 | 2003 Pontiac Sunfire

1 Answer

Where is th MAF sensor located on a 2003 Pontiac Sunfire


I don't list one used on a 2003 Sunfire with a 2.2 engine.

Jan 12, 2013 | 2003 Pontiac Sunfire

1 Answer

Programming 2006 pontiac pursuit fob


Gm and Chevy fob can be programmed at home. I have done it my self for a 01 chevy a 03 sunfire.
The steps on
 Step 1 of 5
Get in your Pontiac G6 and make sure all the doors and the trunk are closed.

 Step 2 of 5
Put your key in the ignition and hold the "Lock" button on the driver's car door.

 Step 3 of 5
Turn the G6 key in your ignition from "On" to "Off" while holding the "Lock" button, and do two more cycles of "On" and "Off" in quick succession.

 Step 4 of 5
Release the "Lock" switch on your door and press and hold the "Lock" button on your keyless remote for 10 to 15 seconds.

 Step 5 of 5
Remove the key from the ignition of your G6, and test the programming.

Or

Or

 Step 1 of 9
Enter your vehicle and close all of the doors behind you besides the driver's door. Be sure to have your keyless remote and ignition key in hand.

 Step 2 of 9
Insert and remove the key from the ignition twice in a row and then close and open the door twice in a row.

 Step 3 of 9
Insert and remove the key from the ignition again and close and open the driver's door two more times.

 Step 4 of 9
Insert the key into the ignition and close the driver's door.

 Step 5 of 9
Cycle the key in the ignition "On" and then "Off" and then remove the key from the ignition.

 Step 6 of 9
Wait for the locks to cycle to indicate the beginning of the programming sequence.

 Step 7 of 9
Press and hold the unlock and lock buttons on your remote for two seconds and then release.

 Step 8 of 9
Press and hold just the
lock button on the remote for three seconds and wait for the locks to cycle to indicate successful programming.

 Step 9 of 9
Repeat steps seven and eight to program any additional remotes and open the driver's door to end the programming sequence once you are finished.
Hope this helps

Feb 04, 2012 | Cars & Trucks

2 Answers

Does my 2003 pontiac sunfire ecotec motor have a cam sensor? Where is it? If it starts as soon as u give it gas it cuts out. I've replaced: fuel pump, fuel filter, coil pk, spark plugs, crank sensor,...


there is still more to check. like the mass air flow sensor, the whole fuel line cleanout, and if its an auto it does have a camshaft sensor. its located into the transmission.

Jan 04, 2010 | 2003 Pontiac Sunfire

2 Answers

I have a 1997 pontiac sunfire and the anti theft light blinks as I try to start the car and the car will not start. I have to wait 20-30 minutes before the anti theft lifht goes out and then the car will...


Pass Lock sensor is preventing the car from starting. You need to override it. I used a remote start module. Having this installed bypasses the pass lock sensor.

Nov 25, 2009 | 1997 Pontiac Sunfire

1 Answer

PROGRAMMING A REMOTE FOR A 97 SUNFIRE GT


I might be able to help this one is testing my memory, There may be a small clip on the inside of the glove box on the right hand side this is holding the connector that has to be jumped . connect the 2 leads with a jumper wire and the door locks should cycle up and down ..without letting the wires go push one of the remote buttons and they will cycle again, do the same with the other remote and then release the jumper wire and they should work..the other popular spot for therse connectors is under the side trunk carpet beside the radio antenna hope I was a help and hope the connector locations were right..also some remotes require what they call syncronization ..Hold both lock and unlock buttons on the remote at the same time untill door locks cycle up and down..this could take as long as 20 seconds..do this on both remotes.. good luck..

Nov 05, 2009 | 1997 Pontiac Sunfire

1 Answer

Theft system - battery drain


Take it back to the guy that installed the alarm system cos mine runs 3 LEDs & its fine

May 03, 2009 | Pontiac Sunfire Cars & Trucks

1 Answer

Theft sensor


Hi,,,
Theft sensor is Part of the Ignition Lock cylinder. On your Sunfire.

If you have problem with the theft system on your car.
First check the proper funtionallity of the Ignition lock cylinder.

if you Can explain me a little bit of your problem I can help you.

Thank you for use fixya...

Aug 23, 2008 | 2003 Pontiac Sunfire

Not finding what you are looking for?
2003 Pontiac Sunfire Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...