Question about 1992 Oldsmobile Ninety Eight Regency

1 Answer

How to replace fuel pump

How do you replace a fuel pump? Do you have to drop the tank?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Yes its called a sending unit and it is in the tank

Posted on Dec 11, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I replace fuel pump for 2007 ford expedition


Disconnect the battery, Drain the fuel tank completely and drop the tank. The fuel pump is going to be on top of the tank.

Sep 01, 2014 | Cars & Trucks

2 Answers

My fuel pump on my 1996 ford explorer is not working. how do i fix this issue?


the fuel pump is in the fuel tank you have to drop the tank to replace it

Sep 03, 2012 | 1996 Ford Explorer

3 Answers

Do I have to drop the fuel tank to replace the fuel pump on a 94 Buick le saber


Yes ,,instructions are below, Use eye protection for this procedure
Remove or Disconnect:

  1. Relieve Fuel Pressure
  2. Disconnect negative battery cable
  3. Raise vehicle on hoist
  4. Remove Fuel Tank
  5. Remove Fuel Gage sending and pump assembly by turning cam lock ring counterclockwise. Lift assembly from fuel tank and remove fuel pump from fuel gage sender unit.
  6. Disconnect pump wires, hose clamps, and clamp around pump body
  7. Pull pump assembly out of rubber connectors
  8. Inspect fuel pump attaching hose for any signs of deterioration. Replace as necessary.
Install or Connect:

  1. Push fuel pump assembly into attaching hose
  2. Connect pump wires, hose clamps at attaching hose and around pump body
  3. Place Fuel tank sending unit and pump assembly into tank using new O-ring
  4. Place cam lock over assembly and lock by turning clockwise
  5. Install Fuel Tank
  6. Start engine and check fuel pipe connector for visual leaks

Oct 20, 2010 | 1994 Buick LeSabre

1 Answer

How to replace fuel pump


Empty fuel tank, support fuel tank, remove straps from tank (you'll probably have to replace those). Remove fuel filler neck from inside fuel door or at tank, drop tank, remove wire clips and fuel lines as necessary, remove fuel pump, put new pump in. Installation is reverse.

Jun 27, 2010 | 1997 Plymouth Breeze

2 Answers

I think the fuel pump is not working, do I have to drop the gas tank to replace?


Yes the fuel tank has to come out to replace the fuel pump.Easier if tank is 1/4 tank or lower.Before doing this make sure that your getting power to the fuel pump.If not check the fuses and the connector for the fuel pump.You can check for power with a test light.It will be the gray wire.Light should come on when the key is turned on.Will only stay on for 2 or 3 seconds unless you crank it.Hope this helps.Good luck.

Dec 25, 2009 | 2002 Chevrolet Astro

4 Answers

1999 Cadillac Deville - How to replace fuel pump? Fuse is OK and fuel pump does not run. Is fuel pump accessible through trunk or must you drop tank? Thanks in advance for your help.


Hello,

Unfortunetly Cadillac does not have an access panel for fuel pump access until the newer years. You will need to drop the tank. Also, don't let the tank come slamming to the ground, make sure you take it slow so you dont dammage the lines to the sending unit.

Good Luck!

Dec 15, 2009 | Cadillac DeVille Cars & Trucks

2 Answers

Back fuel pump is running all the time and is pumping fuel into front tank on a 1990 ford f150


I would drop the tank and replace the pump. These types of problems are fire hazard.

Oct 26, 2009 | 1990 Ford F150

2 Answers

Where is the fuel pump in a 3.8L 2000 Chevy Impala? Is there an access panel to get to it without dropping the tank


the fuel pump is located inthe gas tank, there is no access panel the fuel tank must be dropped to replace the fuel pump module.
AIRTEX Part # E3542M {Fuel Pump Module}
Wiring Harness Included $223.79

Sep 17, 2009 | 2000 Chevrolet Impala

2 Answers

Need to install fuel pump in 1991 pontiac firebird


Sorry. Got to drop the tank. Just break the gas tank bolts and replace them with new ones. If the straps are badly rusted, replace them, too. Look for tank leaks on the top of the tank. Replace the sock on the fuel pump.

Jun 02, 2009 | 1991 Pontiac Firebird

5 Answers

1996 Ford Bronco Fuel Pump Replacement


A 1996 Bronco fuel pump is in the tank. The tank will have to be dropped. After that, it's quick & easy. The filter is on the rail, not so easy even with the line removal tools. Wear safety glasses in case of any pressure.

Jan 16, 2009 | 1996 Ford Bronco

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...