Question about 2005 Mazda MPV
Didn't help any dont look at this site not useful
Posted on Oct 16, 2014
The blower motor is located under the dash on the passenger side of the van, remove any lower dash panels covering the underside of the dash to access the motor. It may be easier to remove the glove box liner for access.
Posted on Feb 21, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Yes, that and the oil of course. Just to be 100% clear on this, i'll explain every step in am automatic transmission service. First, drain the oil from the transmission by removing the drain plug. Second, remove the oil pan from the tranny. Then comes the removal of the filter. Then, replace the filter with the new one. Then clean the oil pan of excess dirt and gasket residue if any, and put the new gasket on the pan. Then you just put the oil pan back on the tranny and top off the oil. For the exact amount of oil needed, call your local dealer, or local garage or parts store. Then just verify the oil level just to be sure everything is OK, and note that most transmissions require the engine to be hot to have the correct level on the oil gauge. It should say if it is needed in your owners manual, or on most oil gauges it says ajust when hot, or hot level and cold level. If in doubt, ask the local dealer, garage or parts store again.
Posted on Jul 08, 2009
go to the link, the engine is the right one, the model is different but the procedures are the sam, there are good photo's of the job in progress.
Posted on Nov 12, 2009
I just changed plugs on my 05' you have to remove the intake plentum to gain acsess to the rear plugs. First remove plastic cover from top of engine, remove intake hose to throtle body, unplug electrical connections to sensors on plentum, unhook vaccum lines, there are two coolant lines that need to unhooked from underneth throttle body, remove plentum support bolts, one on back and one on right side towards rear, a flash light and a mirror is useful for locating these bolts, there is also two vaccumn lines on the very back off plentum that have to be removed. remove clip on back off plentum that secures the hose that goes across the side of the plentum. Remove the six hold down bolts on plentum, and remove plentum. Spark plugs are acsessed by removing the coil packs for each cylinder, simply remove each coil pack hold down bolt and remove coil, plugs are underneth coil packs, you will need a long extension and a 5/8 spark plug socket to remove plugs.
Posted on Jun 11, 2010
Tips for a great answer:
May 14, 2015 | 2005 Mazda MPV LX
May 01, 2012 | 2005 Mazda MPV LX
Sep 23, 2010 | 2005 Mazda MPV
Feb 19, 2010 | 2000 Mazda MPV
Jul 19, 2009 | 2004 Mazda MPV
418 people viewed this question
Usually answered in minutes!