Question about Cars & Trucks

Open Question

How to remove rear bumper of peugot 307 sw 2003

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 12 Answers

SOURCE: How to Remove the Rear Bumper - BA Fairmont/Falcon

Firstly, you need to remove the rear splash shields from within the rear wheel arches and also the tail lights. Then remove the scrivets from the lover edge of the bar. Next remove the scuff plate at the boot opening and fold the carpet back. There are four nuts which hold the bar on, undo these and then lift the sides of the bar up and pull out. The bar has large clips on the side which hold it in place.

Posted on Aug 22, 2009

shaggyrat
  • 1224 Answers

SOURCE: Remove rear bumper from 2003 Porche Cayenne

removing takes about 5 minute refiting the back bumper will take about an our to refit the rear bumper if your using power tools

the easiest way to do this is tank some white nail polish mark 3 lines on the mounts on both sides this will give you a guide to placen back the bumper to vehicle

Posted on Jun 10, 2008

  • 99 Answers

SOURCE: Remove rear plastic bumper cover

please email me at meanness628@aim.com with any other info or questions if you have already gone to a body shop

Posted on Sep 29, 2008

  • 205 Answers

SOURCE: "when do i change the cam belt on a peugeot 307 sw diesel"

usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.

Posted on Sep 04, 2009

MNfisherman
  • 11896 Answers

SOURCE: how to remove the rear bumper cover on a town and

From underneath the vehicle. The bumper is held on by 4 bolts and nuts. (2 on each end) Remove the nuts and bumper will pull off. Then you can pry off bumper cover to once entire bumper is off.

Posted on Nov 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel cut off switch on a peugot 307 52 plate 1.6


To the best of my knowledge Peugeot doesn't use a fuel inertia activated fuel pump switch. The switch is only activated and pump cut off in the event of a rear end collision to your car that exceeds 3 times the force of gravity.

May 19, 2016 | Cars & Trucks

1 Answer

How to take out rear bumper of peugot 307 cc 2003


open bootlid (trunk) remove boot rubber and inside plastic panel on the body not bootlid there should be fasteners then trace fasteners at both fender linings and remove all fasteners under the bumper next gently pull both sides of the bumper away from the fender it only moves about 10-20mm then slide bumper off the vehicle remember as the bumper comes off you still need to disconnect number plate light and parking distance sensors if your vehicle has also if it has disconnect reverse camera

Jan 28, 2016 | Peugeot 307 Cars & Trucks

2 Answers

What is the big ends torque for peugot 307


please find the right term for "big ends" or no one can help you

Mar 19, 2015 | Peugeot 307 Cars & Trucks

1 Answer

Hi. Peugot 307 hdi sw (05). its running rough at idle, sounds a little rough when driving, power down, especially at low revs. Thanks


run the fault codes . Check injector for clean and operating correctly. Check fuel pressure at the injectors.

Jan 03, 2015 | Cars & Trucks

1 Answer

How to take out rear bumper from 2003 toyota corolla?


If you follow the same techniques as in this video, you should be fine.....attached video of 2011 which should be very similar to 2003 TOYOTA CAMRY 2011 REAR BUMPER COVER REMOVAL REPAIR

May 26, 2014 | 2003 Toyota Corolla

1 Answer

How to remove the rear bumper cover on a town and country 2003


From underneath the vehicle. The bumper is held on by 4 bolts and nuts. (2 on each end) Remove the nuts and bumper will pull off. Then you can pry off bumper cover to once entire bumper is off.

Nov 23, 2009 | 2003 Chrysler Town & Country

2 Answers

"when do i change the cam belt on a peugeot 307 sw diesel"


usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.

Apr 15, 2009 | 2005 Peugeot 405

1 Answer

Remove rear bumper from 2003 Porche Cayenne


removing takes about 5 minute refiting the back bumper will take about an our to refit the rear bumper if your using power tools

the easiest way to do this is tank some white nail polish mark 3 lines on the mounts on both sides this will give you a guide to placen back the bumper to vehicle

Jun 09, 2008 | 2003 Porsche Cayenne

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...