Question about 2007 Honda Ridgeline

Open Question

Where is o2 sensor bank 1 sensor 2 located on 2007 honda ridgeline 3.5l

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 10 Answers

SOURCE: where is the o2 sensor located on a 1991 honda accord ex 2.2 engine

Further clarification on the O2 sensor location: It is in the exhaust pipe, under the center of the car, on top of the pipe, just aft of the oil filter.

Posted on Jul 14, 2008

Mustgo
  • 2359 Answers

SOURCE: where is bank 1 sensor 2 located on a 2005 honda

4 or 6 cylinder engine.

It's the rear O2 sensor,the one behind the catalytic converter.

======
Clear the code with OBDII scanner or remove negative cable for 2 minutes.

Wait until the exhaust cool for 1 hours

Disconnect the connector and clean the contacts with CRC electrical contact cleaner the contacts.

reconnect negative battery cable

Start the car and let the motor warm up.

====

If the code keeps coming back then you will need to purchase a O2 sensor socket + O2 to change it out.


Please rate my answer if it's helpful to you.

Cheers,

Mustgo.

I

Posted on Dec 12, 2009

  • 1348 Answers

SOURCE: 1997 Honda Civic did not pass smog due to O2

the best way to reset it is with a scan tool.
disconnecting the battery for one minute will also remove the code.BUT
if your smog test uses an OBD scan as part of the process,then there will be a problem,because the monitors will not have been set,as they are reset if the battery is disconnected..
most tests allow only one monitor missing,and not the catalyst .
A drive cycle will have to be done to set the monitors.
Typically cold start coolant temp less than 50F,idle for 2 minutes no air condition, accelerate at half throttle to 50mph then drive 3 minutes with a/c on at 50mph steady.decelerate to 10mph without using brakes..Accelerate to 60mph and drive for 5 minutes at steady speed without a/c
deccelerate without braking and drive for 1 minute at 40mph.
stop the car ,use braking.
Shut off the car and add 4 gallons of gas.do not shut off the car for more than 5 minutes.
drive in 3rd gear or overdrive off with rpm 3000 for 1 minute.
decelerate to 10mph.without braking
accelerate to 40 mph in 4th gear.,or overdrive on
decelerate without braking to 10mph.
test complete.
this will set the o2 sensor heater ,o2 sensor,catalyst,evap purge.and the other monitors.

Posted on Feb 26, 2010

toneman2121
  • 775 Answers

SOURCE: received code P0138 O2 High Voltage (Bank 1,

bank one will be the cylinders closest to the firewall. sensor two will be located after the catylitic converter,

Posted on Jun 09, 2010

Testimonial: "Thank you!"

  • 67 Answers

SOURCE: in cab air filter

behind the glove compartment, you have to disconnect the box damper and remove the glove box stops, let the glove compartment hang down and the filter is in front of you in the evaporator housing behind a cover.

Posted on Jul 08, 2010

Testimonial: "the best info. keep up the great job no other web site gives out the right information "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the 02 Oxygen Sensor before the cadalic converter on a 2006 Hyundai Santa Fe


Usually these are located on the exhaust manifold or just below the exhaust manifold and you should be able to see it in the engine bay. On V6 engines there will be one sensor on each of the 2 exhaust banks.
You will probably need to remove the engine cover to see the sensors on your exhaust.

If someone told you to replace these because you got a particular fault code I would be wary. A decent scan tool and basic diagnostics can show if the 02 sensor is working or not. Some faults often blamed on an 02 sensor are not due to faulty sensors.

Jan 09, 2016 | 2006 Hyundai Santa Fe

1 Answer

What is a bank sensor for a honda civic ls 04


O2 sensor bank 1 sensor 1 should actually be read as: O2 sensor, bank 1, sensor 1. Meaning the first oxygen sensor (O2 sensor #1) on cylinder bank #1 (it's a Honda inline 4 -cylinder engine, so it only has one bank of cylinders; a V6 or V8 engine would have tow banks arranged in a V shape) needs to be replaced. The oxygen sensor will be threaded into the exhaust near where the manifold (or possibly threaded in at the manifold itself) with some wires coming out of it. In the photo, the O2 sensor is labelled as the air/fuel ratio sensor. 5478b94e-7fcc-4726-9bba-653a172e5a92.jpg

Jun 23, 2014 | 2000 Nissan Frontier

1 Answer

I have a 2006 Honda Ridgeline and the check engine light came on, so i went out and bought a OBDII scanner. It gave me a code for PO42O, catalyst system efficiency below threshold bank 1 left side. I'm...


this sensor is located on the side of the engine that cylinder 1 is on,assuming this is a v6 or v8.you will have to check the 02 wave form to make sure the 02 is switching properly,if it is then you will have to check the effiecency of the catalytic convertor on the same side.it may be the problem and not the convertor.

Nov 04, 2013 | 2006 Honda Ridgeline

1 Answer

Need 07 Pilot P0430 error code troubleshooting tips


code p430 catalyst system below threshold bank 2 that is the front bank O2 sensor located bottom of exhaust manifold which is the top sensor.

Dec 31, 2012 | 2007 Honda Pilot

1 Answer

Honda ridgeline 2007 check engine light on


The check engine light is because all check engine light codes are caused by components that affect emissions. It's not actually an engine problem, it's a problem with either your O2 sensor, MAF sensor, fuel/air ratio, pyrometer, or exhaust.

I would start with an OBDII scan, this will tell you what component is malfunctioning.

Oct 09, 2012 | 2007 Honda Ridgeline

1 Answer

Where's the bank 1 sensor 1 located at my toyota sienna 2007, i know there are 3 sensors in bank 1 and 1 sensor in bank 2 if you can give me the image or view where they are located i really appreciate...


O2 sensors location is broken down like this. The bank refers to which side of the motor the sensor is on. Bank 1 is the same side of the engine as the number one cylinder. Bank 2 is the other side of the motor. Sensor refers to either before the cat or after the cat.

Bank 1 sensor 1 would be the O2 on the side of the motor that the number one cylinder is on and before the cat.

The number one cylinder is on the back side of the motor (the side closest to the firewall). The O2 sensor will be in the exhaust pipe near the exhaust manifold.

Apr 29, 2011 | 2002 Toyota Sienna

1 Answer

ON A 03 6 CLY ACCORD, WHICH SENSOR IS BANK 1 SENSOR 2 ? is there a diagram I can locate on line for the location?


Bank 1 refers to which side the O2 sensor is on and Bank 2 refers to the actual sensor. Bank one is always on which ever side cyclinder #1 is on. In your case it will be on the back side towards the fire wall, and will be the O2 sensor that is past the catalylic converter (otherwise none as a downstream O2 sensor).

1--2--3
======
4--5--6
Front of car

Jan 22, 2011 | 2006 Honda Accord

1 Answer

Were is the o2 sensor located in bank 1 sensor 2


is it a 4 cylender, or 6. if its a 4 cylender the bank 1 sensor 2 is the sensor closest to the cadalatic converter, on the exhaust. if its a 6 cylender you will need to contact honda, and see which bank is one, and which bank is 2... The banks refer to the side of the engine they are talking about. a v6 will have 2 banks, drivers bank and passengers bank, sensor 1 is always the sensor on the exhaust closest to the engine, sometimes even on the manifold, and sensor 2 is the one slosest to the cadalatic converter.. hope this helps, o2 sensor explaining can be a little difficult

Dec 04, 2010 | 2006 Honda Accord

1 Answer

Honda civic 1.8v m/t error code b1169 gauge control module lost


P1169 HO2S11 Label Circuit High Voltage Fault (Bank 1 Sensor 1) for this i would try replacing the o2 sensor bank one sensor one will be the o2 sensor before the catalytic converter and this should clear the problem up

May 30, 2010 | 2007 Honda Civic GX NGV Sedan

Not finding what you are looking for?
2007 Honda Ridgeline Logo

Related Topics:

778 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...