Question about 1995 Honda Accord

Open Question

Green light around D3 gear indicator is flashing,whats wrong?

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1991 honda accord auto with 66000 miles

I had a similar problem mine would not shift correctly and the light stayed all the time. I replaced the TCM (transmission control module), its located under the passenger side floor board its not very hard to replace I believe its only four bolts holding it in place. Just pull back the carpet and its visible. But you have to know if its a japanese or an american built honda when you buy your new one.

Posted on Jan 13, 2009

emissionwiz
  • 75077 Answers

SOURCE: Gear Position light D4 is always flashing irrespective of gear.

This issue is caused by a transmission fault or malfunction, most likely a shift solenoid in the trans has failed or the trans control module has a problem, the trans can be tested for codes that will show what circuit or component of the trans controls is causing the light to stay blinking, have it tested.

Posted on Dec 12, 2008

  • 32 Answers

SOURCE: I have a 91 honda accord lx with 4 speed automatic

Larry, you really need to take it to a trasnsmission shop and find out what the trouble codes are, but it seems as though you have a burned up transmission. Thanks and good luck with your repair.

Posted on Jul 10, 2009

philschneide
  • 448 Answers

SOURCE: 2000 accord ex w/ 4 cylinder engine. The light

The D4 indicator light flashing indicates that your car's computer believes that there is something wrong with your transmission.

This is what the manual for your 2000 Accord says:

The "D4" indicator comes on for a few seconds when you turn the ignition switch ON (II). If it flashes while driving (in any shift position), it indicates a possible problem in the transmission. Avoid rapid acceleration and have the transmission checked by an authorized Honda dealer as soon as possible.

Sometimes this will mean that you are simply low on transmission fluid, but you really should have it checked.

Hope this helps you.

Posted on Jan 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

When i use the indicators the neutral light or brake light flash in time with indicators what is wrong


it sounds like there is a bad ground (earth) someplace in the vehicle .

Sep 14, 2015 | Cars & Trucks

1 Answer

The gear shift indicator light flashes green all the time while the engine is on, regardless of what gear it's in. Even if it's in park, the park light indicator is red, but a green light still is fla


Transmission problems. Have the codes read. Could be just a solenoid replacement. Keep driving it like this and it soon will be a transmission rebuild.

Jan 23, 2015 | 2007 Honda Civic 1.8

1 Answer

My 1990 honda accord for some time has had the s(green) light blinking off and on, had it is solid S green and it seems as it won't shift gears, I don't have power like before? what happened?


The flashing s light means a transmission problem. The transmission computer is under the carpet on passenger side under where you put your feet. Pull down the carpet to see the diagnostic light. Turn on the key to count the flashes to get the code. Pulll a list of codes from the internet.
If your trans shifts properly if you manually shift it thru the gears, going from D1, D2 D3 but feels like it is starting in second when in drive at a stop, the computer is probably the issue, and can be repaired or exchanged for a good computer, lots of companies do this ,find 1 on the internet.

Sep 18, 2014 | 1990 Honda Accord

1 Answer

Es lexus 300 p 1705...What is this?


DTC P1705 - NC2 (Direct Clutch Speed Sensor) Revolution Sensor Circuit malfunction or Direct Clutch Speed Sensor Output is 300 RPM or less with Vehicle at 20 MPH or more & with Park/Neutral Position Switch Off

Most probably you have an electrical fault causing the problem and attached is a diagnostic procedure. It could be 2 separate problems and after rectifying the P1705 only would you know it is single or 2. Repair manual shows right on top of transmission, black sensor with single bolt, 2 wire plug. P/N 89413-08020 list price $113.80

NOTE: DTC P1705 is set when PCM receives 2 gear position signals at the same time.

1. Turn ignition on. If any A/T gear position indicator lights remain illuminated when gear selector is moved from that gear, go to next step. If all A/T gear position indicator lights turn off when gear selector is moved from that gear, system is okay at this time.

2. Disconnect A/T gear position switch connector. If all A/T gear position switch indicators go out, replace A/T gear position switch. If all A/T gear position switch indicators do not go out, go to next step.

3. Reconnect A/T gear position switch connector. Shift through all gear positions except Reverse. Using a DVOM, measure voltage between 16-pin PCM harness connector "D", terminal No. 6 (Green/Red wire on 2.3CL or White wire on Accord and Odyssey) and 25-pin PCM harness connector "B" terminals No. 20 or 22 (Brown/Black wires).

If battery voltage is present, go to next step. If battery voltage is not present, check for a short in Green/Red or White wire between 16-pin PCM harness connector "D" and A/T gear position indicator, or A/T gear position switch. Repair as necessary. If Green/Red or White wire is okay, check for loose PCM harness connectors. Replace PCM with a known-good unit if necessary.

4. Shift through all gear positions except Neutral and Park. Measure voltage between 16-pin PCM harness connector "D", terminal No. 13 (Blue/White wire on Accord or Light Green wire on 2.3CL and Odyssey) and 25-pin PCM harness connector "B" terminals No. 20 or 22 (Brown/Black wires). If battery voltage is present, go to next step. If battery voltage is not present, check for a short in Blue/White or Light Green wire between 16-pin PCM harness connector "D" and A/T gear position indicator, or A/T gear position switch. Repair as necessary. If Blue/White or Light Green wire is okay, check for loose PCM harness connectors. Replace PCM with a known-good unit if necessary.

5. Shift through all gear positions except "D4". Measure voltage between 16-pin PCM harness connector "D", terminal No. 9 (Light Green/Black wire on 2.3CL or Yellow wire on Accord and Odyssey) and 25-pin PCM harness connector "B" terminals No. 20 or 22 (Brown/Black wires). If battery voltage is present, go to next step. If battery voltage is not present, check for a short in Light Green/Black or Yellow wire between 16-pin PCM harness connector "D" and A/T gear position switch. Repair as necessary. If Light Green/Black or Yellow wire is okay, check for loose PCM harness connectors. Replace PCM with a known-good unit if necessary.

6. Shift through all gear positions except "D3". Measure voltage between 16-pin PCM harness connector "D", terminal No. 8 (Green/Blue wire on 2.3CL or Pink wire on Accord and Odyssey) and 25-pin PCM harness connector "B" terminals No. 20 or 22 (Brown/Black wires). If battery voltage is present, go to next step. If battery voltage is not present, check for a short in Green/Blue or Pink wire between 16-pin PCM harness connector "D" and A/T gear position indicator, or A/T gear position switch. Repair as necessary. If Green/Blue or Pink wire is okay, check for loose PCM harness connectors. Replace PCM with a known-good unit if necessary.

7. Shift through all gear positions except "2". Measure voltage between 16-pin PCM harness connector "D", terminal No. 14 (Green/Yellow wire on 2.3CL or Blue wire on Accord and Odyssey) and 25-pin PCM harness connector "B" terminals No. 20 or 22 (Brown/Black wires). If battery voltage is present, go to next step. If battery voltage is not present, check for a short in Green/Yellow or Blue wire between 16-pin PCM harness connector "D" and A/T gear position indicator, or A/T gear position switch. Repair as necessary. If Green/Yellow or Blue wire is okay, check for loose PCM harness connectors. Replace PCM with a known-good unit if necessary.

8. Shift through all gear positions except "1". Measure voltage between 16-pin PCM harness connector "D", terminal No. 15 (Light Green/White wire on 2.3CL or Brown wire on Accord and Odyssey) and 25-pin PCM harness connector "B" terminals No. 20 or 22 (Brown/Black wires). If battery voltage is present, check for loose PCM harness connectors. Replace PCM with a known- good unit if necessary. If battery voltage is not present, check for a short in Light Green/White or Brown wire between 16-pin PCM harness connector "D" and A/T gear position indicator, or A/T gear position switch. Repair as necessary. If Light Green/White or Brown wire is okay, check for loose PCM harness connectors. Replace PCM with a known-good unit if necessary.


Hope helps.

May 24, 2011 | Lexus ES 300 Cars & Trucks

1 Answer

92 honda accord lx auto trans has been shifting around 2,500-3,000 rpm each gear and now the D4 gear does not work at all and D3 works but accelerates slowly after a complete stop. i have to shift down...


check transmission fluid level- run/drive for about 10 min. , park car- check with engine running- add fluid if needed- ,if fluid NOT low- transmission filter needs to be changed

May 10, 2011 | 1992 Honda Accord

2 Answers

2000 accord ex w/ 4 cylinder engine. The light around the D4 (indicating gear) flashes and the car accelerates very slowly in cold weather until the engine gets warm. What is wrong? How to fix?''


The D4 indicator light flashing indicates that your car's computer believes that there is something wrong with your transmission.

This is what the manual for your 2000 Accord says:

The "D4" indicator comes on for a few seconds when you turn the ignition switch ON (II). If it flashes while driving (in any shift position), it indicates a possible problem in the transmission. Avoid rapid acceleration and have the transmission checked by an authorized Honda dealer as soon as possible.

Sometimes this will mean that you are simply low on transmission fluid, but you really should have it checked.

Hope this helps you.

Jan 04, 2010 | 2000 Honda Accord

1 Answer

I have a 91 honda accord lx with 4 speed automatic with the sport shift mode. The indicator light on the dash flashes sometimes and when I put the car into gear like D4 or D3 it takes a lot of RPM to get...


Larry, you really need to take it to a trasnsmission shop and find out what the trouble codes are, but it seems as though you have a burned up transmission. Thanks and good luck with your repair.

Jul 10, 2009 | 1991 Honda Accord

1 Answer

1991 honda accord auto with 66000 miles


I had a similar problem mine would not shift correctly and the light stayed all the time. I replaced the TCM (transmission control module), its located under the passenger side floor board its not very hard to replace I believe its only four bolts holding it in place. Just pull back the carpet and its visible. But you have to know if its a japanese or an american built honda when you buy your new one.

Jan 12, 2009 | 1992 Honda Accord

1 Answer

Gear Position light D4 is always flashing irrespective of gear.


This issue is caused by a transmission fault or malfunction, most likely a shift solenoid in the trans has failed or the trans control module has a problem, the trans can be tested for codes that will show what circuit or component of the trans controls is causing the light to stay blinking, have it tested.

Dec 12, 2008 | 1995 Honda Accord

Not finding what you are looking for?
1995 Honda Accord Logo

Related Topics:

237 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...