Question about 2000 Nissan Sentra

Open Question

2000 sentra no power to horn relay fuse is good

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2000 Sentra - horn problem

The horn fuse had power to it and the fuse was ok. The problem was a wire - from the fuse location - had a break.

Posted on Oct 09, 2009

  • 30 Answers

SOURCE: I have 2006 Sentra the

test the horn when disconnected from the wiring loom

Posted on Jun 09, 2010

tunde007
  • 2382 Answers

SOURCE: The horn on my 2000

Hi, start by removing the steering wheel but before you can expose the 19mm nut that holds the steering wheel remove the air bag if you have one. If you do have one, it has (2) T-30 screws on each side of the steering wheel. If not, remove the center emblem with a small flat tip screwdriver gently. That should have exposed the 19mm nut. Pull the steering wheel off this should give you more access to the horn relay assembly. Don't rip anything apart from itself.

Posted on Feb 12, 2011

Mustgo
  • 2359 Answers

SOURCE: 2006 armada. Horn and interior

Do you has an after market (non-factory) alarm system?
==
Locate and check the alarm module's inline fuse(s) and relay(s)
Open covers and check every dome light bulbs.
Clean the door and rear hatch electrical contacts.
Some interior lighting system has a "slow dim" or "theater" lighting module. Check for loose connection at the module.

Posted on Jul 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Horn wont blow


Check for blown fuse first. If fuse ok, you will have to check for a power and ground supply directly at the horn itself. Possible causes are... defective horn...blown fuse.... defective horn relay....defective horn pad.... defective clock spring..... broken wiring. There is a lot of electrical diagnostics that need to be performed to make this simple horn operate

Sep 05, 2015 | 2001 Nissan Sentra

3 Answers

2000 VW Jetta TDI my Horn just stopped! I don't know which relay to start by, The fuse is good but no V at horns Is there a wiring diagram to be had?


There is a "clockspring" wiring spiral in the steering wheel to accommodate the rotating steering wheel with controls on it. If this breaks, you may lose some or all functions controlled by stuff on the s-wheel.

Sep 11, 2014 | 2000 Volkswagen Jetta TDI

1 Answer

Horn do not work what is the problem in honda civic ex 2000


if the fuse and relay is fine then check the horn itself. with someone pushing on the horn button check for power at the wire on the horn you should have power if not it could be a broken wire from the horn back to the relay. also check to make sure the horn has a good ground. if you do have power chances are the horn itself needs replacing. sometimes the horn pad goes bad, but that rarely happens.

Aug 16, 2014 | Cars & Trucks

1 Answer

2000 VW golf horn won't work, fuse is good , relay 53 is good but changed it anyway. No voltage reading at horns. Tested horn off car and it is fine


Did you check the power to the relay? and then the signal wire (ground) at the relay to see if it's being signaled? Otherwise you may have a clockspring or module problem not allowing the signal to pass through to the relay.

Dec 15, 2012 | 2000 Volkswagen Golf

1 Answer

Replaced horn and now it wont work. Where is the fuse for the horn on a 2000 Merc Mountaineer


The fuse for the horn would be in the power distribution box located under the hood in the engine compartment (see picture below). Also below is a diagram of the fuse layout. The fuse you want to check will be the fuse in the number 10 position and should be a 15 amp fuse. There is a horn relay as well and the is the relay in that same box in the number 7 position. I hope this helps and good luck.


clifford224_408.jpg

clifford224_409.jpg

Aug 30, 2011 | 2000 Mercury Mountaineer

3 Answers

I have a toyota camry 2000 and since I bought it the only horn that would work was the high tone one. All of the sudden none of them are working now. I realized that a relay on the fuse box that is under...


The click you here is the horn relay, You need to find the horns and check for power at the wire connectors. But you probably have a bad low and now a bad high not horn. since the relay clicks your fuse is good so that eliminates the fuse.

Feb 17, 2011 | 2000 Toyota Camry

1 Answer

2000 Sentra - horn problem


The horn fuse had power to it and the fuse was ok. The problem was a wire - from the fuse location - had a break.

Oct 08, 2009 | 2000 Nissan Sentra

Not finding what you are looking for?
2000 Nissan Sentra Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...