Question about 2004 Toyota Sequoia
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
This is for tire pressure. Tires on the truck must have dropped below 30 PSI. Air them up and check the spare tire pressure and the light should go out. :)
Posted on Jul 05, 2009
Slide the plastic cover off the tailgate ******** the passenger side to reveal a 10mm bolt.
Remove the bolt and the strap/
Using a flat prying instrument, remove the center trim section one the inside of the tailgate above the window.
Grab the top edges of the side trim sections on the inside of the tailgate and pull down to remove.
Using a flat instrument, pry at the bottom edge of the tailgate main trim panel, it is held on with about 12 plastic pop-in fasteners so it will take several 'pops' before it is released.
Behind that there is a metal access cover the width of the tailgate, held on by ~5x pop in fasteners and ~10x 10 mm bolts. Remove the bolts and pop the panel loose, it will hang by the wiring so support it while you do your camera work :)
The license plate trim panel, should you need to remove it, requires remoaval of the license plate.
Then remove ~3x 10mm bolts from the top of the panel, accessed from the inside.
Using long needle nose pliers compress the pop-fasteners holding the lower corners of the license plate trim panel on, being careful not to let it drop and slide down the vehicle, scratching the paint :)
Posted on Sep 20, 2009
Testimonial: "Very helpful. thanks"
You have a low tire. Toyota Solaras and other Toyotas have tire sensor monitors. Go to a gas station and check the air on all of your tires including the spare. Once you get to the recommended pressure, you should be fine.
Posted on Oct 25, 2009
Hello.I will be glad to help you out.
Choose which of the 3 buttons you wish to use, on the car.
Take the remote transmitter, depress the actuator button, and continue to hold it until advised to release.
Depress the button, on the car, of your choice, and hold it down until advised to release.
Hold the garage door actuator (while holding the actuator button down) above the car's 3 buttons.
Rotate the door transmitter until the red light above the 3 buttons starts to flash slowly.
Stop moving the remote around when the light flashes slow.
Within several seconds, the same light n the car will now flash rapidly.
Release the car's button, release the transmitter button.
Verify that the door now operates..
Posted on Nov 30, 2009
set the mileage when the odometer is showing. put the key to off position. press and hold the reset button then turn the key to on position, do not start. then continue holding the reset button until the reading stops to zero or blank. turn it off, that should reset the light indicator
Posted on Feb 21, 2010
Testimonial: "thanks for the help! it worked like a charm. appreciate it! "
Tips for a great answer:
Aug 28, 2014 | 2005 Toyota Sequoia
May 25, 2014 | 2005 Toyota Sequoia
Feb 16, 2014 | 2005 Toyota Prius
May 11, 2012 | 2005 Toyota Sequoia
Apr 24, 2011 | 2007 Toyota Sequoia
May 12, 2010 | 1999 Saturn SL
Dec 11, 2009 | 2005 Infiniti G35
549 people viewed this question
Usually answered in minutes!