Question about 2002 Ford Explorer Sport

Open Question

Where is the RCM or airbag monitor located on 2002 Ford Explorer Sport

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 92 Answers

SOURCE: 1998 Ford Explorer sport 4.0L 4x2 PCV Valve Location

the pcv is located on the rear(firewall) of the drivers side valve cover.turn counterclockwise and pull to remove be careful there are 2 small tabs inside the pcv hole in the valve cover(can feel with small finger) this is to hold valve in place so it wont leak.if you have a oil leak at the pcv a quick fix is to put a small amount of silicone around the pcv o-ring and install.wait hours for silicone to set up.

Posted on Oct 21, 2008

Ad
  • 1596 Answers

SOURCE: pcv valve :where is it located on a 1999 ford explorer sport 2wd

Look For A 3/8 th's Vacuum Hose Coming from The Base of Throtle Body Fallow it to the 2 Line PCV At Valve cover

Posted on Feb 10, 2009

chuck943
  • 783 Answers

SOURCE: Airbag light flashes then stays on in our 2002 Ford Explorer.

Safety Belt pre-tensioner Status (Driver pre-tensioner Circuit Fault).
On the seat belt buckle there is a pre-tensioner that when vehicle is involved in an accident it will deploy and pull the belt tighter.

If the vehicle has never been involved in an accident it could be what we call terminal fretting which is just a build up on the terminals which cause a open circuit. Usually just unplugging and reconnecting the connector a couple of times will fix this.

If this doesn't correct it I would recommend having your local dealer look at it.

Posted on Apr 01, 2009

  • 129 Answers

SOURCE: ABS fuse locations

The Location of this fuse is under your hood in the relay box.

Posted on Jun 01, 2009

  • 3600 Answers

SOURCE: 2002 Ford Explorer Sport, diagram to add freon

there is a port and it takes r123a and it has a green port on it but if it's leaked out you mave have to have it vachumed out, if you charge it be sure to get R134a with oil so that you don't burn up the pump, when the thing leaks it loses oil.

Posted on Jun 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location door jamb switch 02 explorer sport


If it has power locks. In the latch assembly

Dec 14, 2012 | 2002 Ford Explorer

1 Answer

2002 ford explorer xlt, airbag light


anytime a air bag is deployed,the air bag control module needs to be replaced. it is cheaper and easier to get a used one from the junk yard just make sure the explorer was not in a accident. it is located under the dash in the middle just where the ash tray is

Dec 11, 2012 | 2002 Ford Explorer

1 Answer

I have a code that show on CARMD about the srs light (airbag) on my dash , how do I reset or shut it off without changing an airbag


Hi there:The Restraints Control Module (RCM / located behind right side of the instrument panel) monitors the resistance of the driver side air bag circuit loop and the air bag module igniter at RCM, if the resistance is greater than 3.6 ohms, the RCM will store diagnostic trouble code B1994 and flash lamp fault code.
About the possible causes, pay attention that a high resistance on the driver side air bag circuit can be caused by:
  • - damaged wiring on circuit 1257 (WH/LB).
  • - damaged wiring on circuit 1258 (BN/LB)
  • - damaged driver side air bag module.
  • - damaged RCM.


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Aug 23, 2012 | 1999 Ford Explorer

1 Answer

Where is the computer located on a 2001 ford explorer sport


the module is behind passenger side airbag lower glove box remove bolts and airbag will slide out and its a yellowish colour module. MAKE SURE YOU DISCONNECT BATTERY BEFORE ANY WORK ON AIRBAG

Nov 25, 2011 | Ford Explorer Cars & Trucks

1 Answer

How to I disable the airbag on my 2004 Ford Explorer Sport Trac so I can change out the cruise control buttons?


Remove RCM fuse from dash panel fuse box. Fuse F2.10 10 amps. Turn key onfor 30 seconds and see that Air Bag light is lit. Now disconnect battery negative cable for 1 minute, leave disconnected while service is done. now the air bag is disabled. To repower the system turn key on, insert fuse. connect battery, now turn key off for 10 seconds, then turn key on and watch the air bag light. it should go on then after the air bag module is happy that everything is ok, it will turn off.

Dec 06, 2010 | 2004 Ford Explorer Sport Trac

2 Answers

Location of fuses for airbags


Check the Passenger Compartment Fuse Panel (Page 188 from Owners Manual), is located below and to the left of the steering wheel by the brake pedal. Remove the panel cover to access the fuses. Check Position 26, 10AMP*...

311c99c.jpg

Also here you can download 2002-Ford-Excursion. Hope helps, (remember rated this).

Jun 03, 2010 | 2002 Ford Excursion

1 Answer

2002 explorer horn inop


In most cases this problem is caused by the rotating ribbon circuit contact under the steering wheel having a broken filament, the part is known as a clock spring contact, u will need to properly disarm the airbag and remove the steering wheel to access the part. WARNING: Failure to disarm the airbag system can result in an unexpected Airbag deployment and possible serious personnel injury disconnect the battery 30 minutes prior to start of work.

Mar 29, 2010 | 2002 Ford Explorer

1 Answer

Cheaply replace steering wheel w/out airbag module


Lisa,

I don't know what state you are in... but in Massachusetts your truck will not pass inspection if the air bag is tampered with. A missing airbag will report to the OBD (your computer) and will cause a fail for your safety inspection. Sorry!

Dec 10, 2008 | 2001 Ford Explorer Sport

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...