Question about 2007 GMC Acadia SLE

Open Question

Car has hard time cranking after fueling. after it runs it will crank after fine. it only has the problem when fueling

Posted by on

  • mmmlifer
    mmmlifer Mar 11, 2014

    i replaced the purge valve solenoid. $37 from o'reillys, refueled my acadia and seems to taken care of problem.

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 90 Answers

SOURCE: hard cold start 96 safari

Check fuel presure.I believe its 61 to 65 psi, with little or no drop off in ten minutes.V-6 access port for fuel presure is at left rear of engine,(remove dog house to access). Fuel pump is in fuel tank.Use AC Delco only, there is a updated wire harness conector for these.

Posted on Jan 17, 2009

  • 14036 Answers

SOURCE: Hard start 1997 Gmc 4.3 Safari

take a fuel pressure tester pressurise fuel system dont crank .look at gauge at fuel pressure if it drops from 41 psi to 30 psi in .10 mins. you have a leaking fuel injector or injectors.flooding out engine

Posted on May 01, 2009

motor1258
  • 6674 Answers

SOURCE: My GMC yukon XL 2001 engine runs after 4 times of cranking.

Try turning key to on only, not start, 2 or 3 times first then try to start. If it starts good first try, then I'd change my fuel filter & then have fuel pressure tested if fuel filter didn't help. You may be looking at a new pump, but lets do filter & test fuel pressure first.

Posted on Jul 06, 2009

  • 148 Answers

SOURCE: 96 gmc sierra hard to crank after 12-14 hours

that has a votec engine in it the fuel pressure is droping at knight and it takes 60 psi before the injectors will fire most likely cause fuel pump ,leaking injector ,or a feul pressure regulator

Posted on Jul 14, 2009

alicantecoli
  • 22095 Answers

SOURCE: Van will not start. It Cranks and the fuel pump

wont turn over??sounds like the timing belt has broke and pistons hitting the valves

Posted on Nov 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hard start cold, fine rest of day


I would be checking to see why there is power to the pump with the ignition off as this is a source to flat battery overnight.. May be a relay is still activated by a power source other than the ignition.

Jan 25, 2014 | 2000 Chevrolet Blazer

1 Answer

Cranks fine engine runs fine but you turn off. it is hard to crank keeps turning over finally cranks


CLEAN FUEL INJECTORS.THEY ARE FLOODING THE ENGINE.WHEN YOU TURN OFF ENGINE DIRTY CLOGGED FUEL INJECTORS WILL KEEP LEAKING FUEL FLOODING ENGINE.ALSO REPLACE AIR FILTER.

Oct 25, 2010 | 1995 GMC Yukon

3 Answers

Hard starting. cranks several times before starting. runs fine.


Sounds like low fuel pressure or a stopped up fuel filter. If the vehical has two tanks does it act the same on both tanks? there are fuel pumps in both tanks and one one on the frame. if the one on the frame is slow or not working the tank pumps can still run the car sometimes but it has troble getting started

Oct 12, 2009 | 1992 Ford F250

1 Answer

96 Honda Passport hard starting


Air cleaner, fuel filter, plugs, bad gas

Sep 21, 2009 | 1996 Honda Passport

1 Answer

Chrysler cirrus hard to start


have the fuel pressure check valve tested, if the pressure bleeds down due to a defective check valve in the pump then you get the symptom u are discribing.

Sep 03, 2009 | 2000 Oldsmobile Intrigue

2 Answers

Hard start 1997 Gmc 4.3 Safari


POSS FUEL PRESSURE LEAKING INTO INTAKE VIA FUEL PRESSURE REGULATOR

May 01, 2009 | 1997 GMC Safari

1 Answer

Hard starting, excessive crank time


try changing the fuel filter and turn the key on and off several times before starting engine. once running check the vaccum line on the fuel pressure regulator.the regulator can leak fuel from that connection.

Feb 27, 2009 | 1996 Chevrolet Blazer

3 Answers

Starting problems with my 2003 Hyundai Santa Fe


I have an 03 Santa Fe as well and just had the exact thing happen to me. One day, it just wouldn't turn over at all and I had to have it towed to the dealer. They replaced the "crank shaft position sensor" and now the car is fine. I am not sure if this is your problem but it might be worthwhile asking someone to check it out.

Dec 29, 2008 | 2003 Hyundai Santa Fe

1 Answer

Starting problems with 2003 Hyundai Santa Fe


i tkae it u have checked ur battery for a leak, and you have also chnged ur spark plugs

Dec 29, 2008 | 1993 Hyundai Elantra

1 Answer

1992 Buick Park Avenue - car runs great..when it runs.


The crank sensor is located on the side of crankshaft damper/pulley it mounted on a bracket. However it think that you may have a map-sensor problem that's very common with this vehicle. The crank sensor is not hard to change at all. Good Luck get back in contact if you need more help

Dec 18, 2008 | 1992 Buick Park Avenue

Not finding what you are looking for?
2007 GMC Acadia SLE Logo

Related Topics:

342 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...