Question about Honda Accord
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
For the V-6 model, the dipstick is located down low on the transaxle, on the drivers side of the car, if it is low, usually 1 pint of of fluid is needed to raise from low notch to high notch. also if it appears to be dark or burnt, smells burnt, you should replace the tranaxle fluid. Good Luck!
Posted on Sep 07, 2009
yes you can replace it, more than likely I would try getting a replacement window from your local import salvage yard. you will need to remove the door panel screws (normally in the small pull compartment to close the door) and one in the latch, both have a plastic cap that needs to be pried up, it is also connected to the screw or bolt. next, you will need a flat blade screw driver or flat pry bar to take off the panel, start at the bottom. it should just pop out (loud snapping noise). In addition, there is a triangular shaped black plastic cap in the corner, that will also pry off. You will need to unplug the window and door lock connector, carefully remove the lining, you should be able to gain access to the two bolts that hold the window in place. you might have to raise or lower the door till you see them in the removal holes, should be a 10 mm socket. After you loosen remove old glass and install new one and re assemble as you have taken apart, Good Luck!!
Posted on Sep 11, 2009
The part from the dealer is $180.65 ,labor is .5 hours about $50. If you go to a independent shop the cost should be less:)
Posted on Nov 24, 2009
disconnect the cable to the battery........there is 3 bolt holding the starter to the engine/transmission housing. You may need to remove the air intake manifold to gain access to the work area.
Posted on Mar 24, 2010
Tips for a great answer:
Apr 04, 2017 | 2003 Honda Accord
Jul 29, 2014 | 2003 Honda Accord 2.4 LX
Dec 19, 2012 | Cars & Trucks
Jun 07, 2012 | 1996 Honda Accord
May 13, 2010 | 2000 Honda Accord
Dec 26, 2009 | 1998 Honda Accord
Aug 22, 2009 | 2003 Honda Accord
Mar 08, 2009 | 2000 Honda Accord
647 people viewed this question
Usually answered in minutes!