Question about Peugeot 308
Water in fuel filter how can I draain it? Charly
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: car wont start on 206
you must fill the fuel filter housing with diesel to eliminate air pocket. if you don't have diesel, fill it with automatic transmission fluid. it will smoke for a few seconds, but it will run so fuel pump can catch up. don't touch throttle for a few seconds till you know that it is running on diesel and the tranny fluid is all used up.
Posted on May 24, 2009
usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.
Posted on Sep 04, 2009
if it says the diesel filter, then that is what it means,a fuel filter.normal service requirement on any vehicle and can be done for small dollars at any garage
Posted on Dec 04, 2009
SOURCE: timing marks on peugeot 1.9 tdi
there is a few ways of doing thes the easiest way being using locking pins
you bont have to go and buy a set of locking pins you can use 3 m8 (13mm headded) bolts and a 5mm allen key
there is a hole in the cam pully and 2 holes in the injection pump pully and 1 in the fly wheel
i suggest you lock the fly wheel up first
the hole is located under the starter motor on the front of the block
insert the 5mm allen key and get someone to turn the crank pully clockwise until allen key engages into the fly wheel
the hole in the cam should be at about 25 past
(if it is at 10 to then you neet to remove the pin from the fly wheel and turn the crank 1 full turn)
when the hole is inthe right place you can insert a m8 bolt and wind it in to the head
with this now lined up you should be able to fit the other 2 m8 bolts into the injector pump pully
with this now done your 1.9 tdi engine is timed up
Posted on Dec 07, 2009
Tips for a great answer:
Jul 22, 2017 | Peugeot Cars & Trucks
Nov 18, 2016 | Peugeot Cars & Trucks
May 27, 2015 | 2010 Peugeot 308 HDi
Dec 25, 2014 | 2010 Peugeot 308 SW
Sep 11, 2013 | 1998 Jeep Cherokee
Apr 12, 2010 | 2005 Peugeot 405
Mar 29, 2010 | Peugeot 504 Cars & Trucks
Dec 04, 2009 | 2006 Peugeot 604
Apr 15, 2009 | 2005 Peugeot 405
383 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: