Question about GMC Jimmy

1 Answer

Have no 1st. gear only 2nd 3rd and dr. will not down shift no kickdown. recently changed ****** filter and fluid

Had autozone check the check engine light and said it was code po758

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

Probably lookin at gettin a new transmission

Posted on Feb 20, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

raycrazek
  • 106 Answers

SOURCE: 96 plymouth voyager no shift

you say the fluid looks good... that's great.
now next time your out drive for about ten good minuetes long enough for the transmission to get nice and warm and then pull over to nice level ground and with the vehicle in park check the fluid again. it's kind of hard to read because it always has a lot of bubbles on it and stuff. but it may be low on fluid.. good-luck ray

Posted on Jan 16, 2009

emissionwiz
  • 74945 Answers

SOURCE: the engine rpms rev when shifting

Your trans is slipping, u are going to need to have it checked out at a trans shop, they will test drive it in most cases for free and report what they think is wrong or recommend more diagnostic work if they are unsure..

Posted on May 21, 2009

RamTek
  • 377 Answers

SOURCE: Transmission problem in E230 Benz

What you need to check is the transmission release bearing because if there is a clearance on the release bearing you will encounter this problem and also check the transmission oil.

Posted on Jun 08, 2009

  • 1 Answer

SOURCE: 96 chevy blazer 3rd gear and overdrive slipping

i got a 1996 chev. blazer s-s10 4.3 engine 4x4.problem i got is i got 1st 2nd & overdrive & reverse but no 3rd gear what should i do

Posted on Jan 19, 2010

shark2th667
  • 343 Answers

SOURCE: my 93 chevy truck wont shift into 3rd gear. goes

I say band adjustment in transmission, have done by shop. might be just a vacuum hose or modulator, but I don't think so

Posted on Oct 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

3 speed box in drive 1st and 2nd gear takes 3rd gear dont


How to adjust 3 speed column shifter - YouTube

? 9:53
https://www.youtube.com/watch?v=2TCHzIvAvRQ
Mar 6, 2014 - Uploaded by luke Fugate
This is a video to show you how to adjust a Three speed on the column to ... It's great not having to wind the engine and transmission just to take off in 2nd or 3rd gear. ... It was ALWAYS getting stuck between 1st and 2nd gear. .... 1977 c10 3 On The Tree ' How to Drive a 3 Speed Column Shift - Duration: ...

Diagnose Automatic Transmission

www.aa1car.com/library/2002/bf90222.htm
All they know is that they put their gear selector in "D" for Drive and their vehicle ... But when internal problems cause the transmission to act up, it takes a fair amount .... In Chrysler three-speed automatics, changing the fluid to ATF+3 can also help ...kickdowns to get the transmission to downshift to 1st from 2nd or 3rd gear.

Manual transmission - Wikipedia, the free encyclopedia

https://en.wikipedia.org/wiki/Manual_transmission

Wikipedia1 Overview; 2 Unsynchronized transmission; 3 Synchronized transmission; 4 Internals.... gear speeds by blipping the throttle when shifting from 2nd into 1st. ... In a synchromesh gearbox, to correctly match the speed of the gear to that of the ... Even in transmissions that do not feature direct drive, it's an advantage for the ...

When do you use the 1,2,3 gears on an automatic car ...

https://www.reddit.com/.../when_do_you_use_the_123_gears_on_..

Jan 10, 2016 | Cars & Trucks

1 Answer

Shifts hard from 2nd to 3rd recently changed fluid and filter also down-shifting


Transmission Harsh shifting - YouTube

? 3:59
https://www.youtube.com/watch?v=aAoiL4vR8Qw
Jan 13, 2013 - Uploaded by James Burns
hi i have a 2004/05 misubishi lancer just recently the neutral light keeps ... Should I just change the fluid and ...

Why is My Transmission Shifting Hard? - BlueDevil Products

gobdp.com/blog/why-is-my-transmission-shifting-hard/
Jan 2, 2014 - Is your automatic transmission giving you trouble or shifting too hard? ... It was a great idea to get your transmission fluid and filter changed and to keep .... I have 2014 chevy traverse, when you down shift and at the end of a gear ...... It mayalso be due to the 3rd gear shift solenoid going bad so that may be ...

Transmission Will Not Shift Properly : Volvo S80 Common ...

repairpal.com > Problems > Volvo > S80

Jan 01, 2016 | Cars & Trucks

1 Answer

The Pacifica will not shift past 4th gear. It shifts normally through 1st, 2nd, 3rd, and 4th gear. Their is no high reeving RPS, no clunking, no lurching. It will just not shift past 4th gear.


is there an OD button that might have been pressed .if it has lots of miles on it it could be needing a flush job . last one I got done was around 100.00 at jiffy lube.

Nov 12, 2015 | 2005 Chrysler Pacifica

2 Answers

When hot trany will not work in all gears have just replaced filter gasket


Hello and welcome to FixYa!

If you haven't replaced the transmission fluid recently then now is the time. If the fluid is burnt, the transmission tends to fail specially on hot temp. Please do check the transmission fluid first as a first course of action.

Hope this helps and thank you for using FixYa!

Apr 11, 2011 | 1990 Dodge Caravan

2 Answers

I recently performed a transmission fluid flush (pan and torque converter) and swapped out the filter due to some problems I was having shifting from 1st to 2nd. After changing the fluid, the problem was...


One thing that is rarely posted is any repairs and or instructions on doing so. For instance the Solenoid pack is often suggested as a replacement, and you can buy them on e-bay, but no instruction on how to replace one. Amazing. I can fix anything! Just take it to the Tranny Shop..... Makes me think that the only answers put on here are by Tranny Shops.

Dec 20, 2010 | 1999 Mazda Millenia

4 Answers

96 chevy blazer 3rd gear and overdrive slipping


i got a 1996 chev. blazer s-s10 4.3 engine 4x4.problem i got is i got 1st 2nd & overdrive & reverse but no 3rd gear what should i do

Jun 30, 2009 | 1996 Chevrolet Blazer

1 Answer

Used transmission installed and doesnt shift at the right rpms


Ck your trans modulator., and if not already done, you pan filter and fluids

Jun 06, 2009 | 1992 Chevrolet C1500

1 Answer

Transmisson problems


it can be the shift solenoid in the trans there is one for 1st and 2nd then there is one for 3rd and fourth easy to change drop pan they are right there.about 40 to 60 at dealer for solenoid and of course fluid and filter about 60.00

May 23, 2009 | 2005 Chevrolet Silverado 1500 2WD

1 Answer

95 gran marchis trany; shifting


The transmission needs to have the filter and fluid replaced.

May 02, 2009 | 1995 Mercury Grand Marquis

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

198 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...