Question about 2008 Acura Mdx

Open Question

Tailgate will not open on acura mdx

Tailgate will not open, autolock fails and windows will not roll down. what is the reason?

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1348 Answers

SOURCE: acura mdx 2005

30000 miles.the owners manual will tell you exactly.most honda are 48000 km,exception is the cvt type transmission which there is no service done.

Posted on May 26, 2009

co7196
  • 3433 Answers

SOURCE: 2006 Acura MDX bluetooth stopped

Bluetooths have batteries, Rechargeable. If it won't hold a charge replace the batt.

Posted on Oct 16, 2009

  • 1 Answer

SOURCE: 2004 Acura MDX Water Leak

The 2002 MDX I worked on turned out to be a drainage problem . Seems the factory installed foam in the bottom of the hinge pillar post which blocked the drain holes . Take off the mud flap , remove enough of the splash shield to access the bottom of the hinge pillar and drill a half inch hole at the front lower corner aiming the drill slightly upward ( be sure to protect the bare metal) .Water gushed out when I did this. For extra ins. remove the kick panels and check for two holes a few inchs from the floor, plug and chaulk these holes. Hope this worksfor you too

Posted on Jan 07, 2010

koflach79
  • 35 Answers

SOURCE: i have a honda mdx and the tailgate door does not

Take off the trim panel and see if you can see the servo that controls the locks push rod. It may have been disconeted, or broken, the ends are usually made of plastic. Also you will be able to see if it is even actuating when you press the lock/ unlock. Good luck!

Posted on Feb 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

85 s10 Chevy blazer: back window and tailgate won't open


Very typical for the window motor to fail. The tailgate will not open when the window isn't rolled down. If there is voltage to the terminals of the window motor when you actuate the switch but the motor does not turn, replace the motor. Once you are able to roll the window down, the tailgate should open again.

Apr 08, 2014 | Cars & Trucks

1 Answer

1996 bronco tailgate window not working


If you have power,there is a safety switch on the bottom of the tailgate.It's so you cant operate the window when its not closed.jump it and see if that works.

Apr 02, 2013 | 1996 Ford Bronco

1 Answer

How do I replace back door lock cyl. on 92 4runner?


not really. it is best done with two people. remove the inside paneling, roll the window down and open the tailgate. then use a phillips screwdriver and push down the side tabs so the tailgate thinks it closed and roll the window up, have the second person hold the glass. You now have access to change the key cylinder.

Feb 05, 2012 | 1992 Toyota 4Runner

1 Answer

Cant open "swing out part of tailgate drop down


it will not do both at same time and for some reason its not senson it is closed properly

Dec 29, 2010 | 2004 GMC Envoy

2 Answers

1987 toyota 4runner tailgate window stopped working


REMOVE THE REAR TRIM PANEL ON THE TAILGATE AND SEE IF THE MOTOR IS GETTING 12 VOLTS AND A GOOD CHASSIS GROUND CONNECTION, MANY TIMES THE WIRING HARNESS THAT GOES IN TO THE TAILGATE DEVELOPES A OPEN/BROKEN WIRE FROM THE REPEATED OPENING AND CLOSING OF THE TAILGATE, THE WIRE BREAKS INSIDE THE PLASTIC INSULATOR AROUND THE WIRE, SO IT IS NOT APPARENT ON VISUAL INSPECTION, REQUIRES THE USE OF AN OHM METER AND A VOLT METER.

Mar 30, 2009 | 1987 Toyota 4Runner

2 Answers

Bronco rear window was being rolled up with a key when spare tire bracket was closed. It stopped halfway up and now won't move. I suspect the tailgate open switch. Where is this switch?


The electric key switch is next to the key cylinder on the rear door. You can see it easily with the window down and weatherstripping pulled out. The wiring may have become chaffed with the window over the years or the switch corroded in the contact points inside.

Mar 25, 2009 | 1996 Ford Bronco

1 Answer

Replace motor on tailgate window on a 1987 ford bronco


You will likely have to remove the panel from the inside with the window up. Once you have the panel off I would try to have some one hold down on the switch while you tap the motor with a hammer. Of course make sure the latches are all the way closed as if the door is not closed all the way the window will not roll down as it has safety switches to keep this from happening.

If you still can not get it down then you will need to unbolt the regulator and let it down that way.

Jan 14, 2009 | 1987 Ford Bronco

1 Answer

'94 4runner 4dr. Inop. r/rear window & rt. frt. window will go down not up.


There is a saftey built into the tailgate that will interupt the ground to the switch in the center console with the tailgate open. This keeps the operator from trying to roll the window up with the tailgate open. If you have no ground to the rear window switch it is most likely the tailgate safety switch. If it is like my '88 it is built into the drvers side tailgate latch.

Nov 06, 2008 | 1995 Toyota 4Runner

2 Answers

Rear window on 1986 ford bronco


I had the same problem with mine and I drilled out the rivets holding the motor in. Have someone hold the window up when you do this so it don't fall. after you get it drilled and you can let it down you should be able to remove the window from the track through the panel. It has been a while since i had done it but the window motor was very reasonable.... make sure you are getting power to the motor before going through all of this because you might be able to put power to it and make it roll down.

Jun 15, 2008 | 1986 Ford Bronco

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

432 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7712 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...