Question about Mazda 6

Open Question

Mazda 6 shudders in reverse

Shudder in reverse manual

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: My Multitronic gearbox wont go

Hi: Probably the problem is the electronic module of the transmision. the mechanical part of the transmision is working well. but the problem is the electronic part. You need to scan the car and chane the module.

Posted on Nov 23, 2008

Ad
  • 42 Answers

SOURCE: My Multitronic gearbox wont go

Known problem with gearbox control units. High failure rate. Gearbox lights flahing. May not select reverse gear. Take to dealer as may get some goodwill on this.

Posted on Dec 05, 2008

  • 345 Answers

SOURCE: Car shudders when accelerating...

get it put on a code reader and see if there are any codes first,this may lead you in the right direction rather than do a guesstimate

Posted on Feb 19, 2009

  • 1 Answer

SOURCE: Car shudders when accelerating...

My wife's 02 Audi A4 1,8t had the same problem after talking with Audi (coil pack/spark plugs) we replaced them all and the problem still persisted not to say that won't fix your problem but what I found to be the problem was 3/8 vacuum line (shaped like a S) that comes up on the right hand side between the oil filter and the fire wall that comes from the turbo check valve assembly (its hard to locate and should be done with the engine cool) up to a valve assembly that connects to the intake manifold, what was happening was the hose would become spongy at the bottom (you will have to squeeze the hose from top to bottom to notice the difference) and as the engine heats up it would cause the hose to collapse. Once I replaced the hose and the computer reprogrammed the fuel mixture (about 25 miles of driving) the problem seems to have been correct. Good luck.I had also replaced the turbo check valve about three years ago because of a severe hesitation when you first apply gas (turbo check valve may not be the proper name.) Sorry. Wife Still Loves Her Audi

Posted on Mar 19, 2009

dr_greg
  • 192 Answers

SOURCE: My 2004 crv shudders badly when turning

replace the raer differential fluid. make sure to use hondas dual pump fluid...

Posted on Apr 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hyhundai Accent 1.6 shudders in reverse badly. Pressure plate broke and is replaced. Now shudders in reverse replaced mounting still shudders


Have the transmission tested for proper hydraulic pressure. Test the valve body and shift solenoids for proper operation.

Dec 22, 2016 | Hyundai Accent Cars & Trucks

1 Answer

My 2004 Mazda tribute has started shuddering in all gears, not contuously but seems when it drops below the 2 on rpms. Had just had it serviced and oil changed 2 weeks ago


Did you have the motor oil changed or the transmission oil? Your check engine light should be on and you should have it scanned by a professional. Did it start to shudder immediately after the service? Its very hard to tell without seeing the car to diagnose myself.

Mar 09, 2016 | Mazda Cars & Trucks

1 Answer

My 2008 Ford f150 after a long drive shakes and shudders when reversing, what could be the cause?


if it is a manual , check engine mounts, "U" joints, centre bearing support
Shuddering in first or reverse in manuals normally indicates oil or grease on the clutch plate linings but I would check the rest first as you did not mention any problem when taking off
I would start with the engine mounts as reversing places strain on the opposite mount

Jun 08, 2015 | 2008 Ford F-150

1 Answer

Shudder in reverse and seems to be slipping forward gears good


It is an auto I take it and the problem will be a reverse band/clutch pack solenoid servo. It it is a manual then the clutch works the same way in forward and reverse so if it was slipping in reverse ,it would also be slipping in forward gears as well. Run the fault codes to check for TCM and servo/solenoid faults.

Aug 18, 2014 | Cars & Trucks

1 Answer

2006 mazda 6 bad idle and shuts off no power


have the fault codes read have a pressure test done on the fuel manifold to check for pump/ regulator and filter. Check the injectors for blocked tips.

Feb 05, 2014 | 2006 Mazda 6

1 Answer

Shudder in mazda tribute


Sounds like the torque converter is chattering and likely will have to be replaced. Have a trans shop verify that. The other problem is a separate question and should be posted that way.

Aug 17, 2013 | Mazda Cars & Trucks

1 Answer

2003 Mazda 6 TS2 Sometimes when I accelerate from a stopped position my car will really shudder and ****. This does not happen all the time and it is usually just while I am accelerating in 1st gear. ...


Yes you need to replace the clutch,pressure plate and the throw out bearing and take the fly wheel and have it resurfaced it has burnt spots in it and that is your shudder.

Jan 21, 2011 | Mazda MAZDA6 Cars & Trucks

1 Answer

My 2002 mazda tribute gets a severe shudder. moisture intrusion?


The shudder comes from ignition malfunctions. Replace the spark plugs and plug wires.
Check coolant level for the white smoke concern.

Feb 24, 2010 | 2002 Mazda Tribute

1 Answer

Clutch going out


Clutch problems are common with the Mazda 6...usually a shudder starts then slippage occurs. Many owners have had theirs replaced under warranty. Recommend you get an aftermarket complete clutch kit, when you replace it...the OEM clutch is not dependable.
Good luck...i hope this helps.

Jul 18, 2009 | 2004 Mazda 6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...