Location of map sensor on mb 2001 e320 - 1999 Mercedes-Benz E-Class

Oldsmobile Alero MAP Sensor - PartsGeek.com

www.partsgeek.com > ... > Oldsmobile MAP Sensor > Alero Parts

Oct 29, 2008 - 04 2004 Oldsmobile Alero GL MAP Sensor 3.4L V6 VIN: E Delphi · Click to Enlarge ... Vehicle, Engine. • 2002 (02) Oldsmobile Alero, 3.4L V6. 04 2004 Oldsmobile Alero MAP Sensor 2.2L 4 Cyl Standard Motor Products.

Part 1 -How to Test the MAP Sensor (GM 2.4L Quad 4)

troubleshootmyvehicle.com > GM > 2.4L

Jun 7, 2011 - GM 2.4L MAP Sensor Test with a Multimeter. ... 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002. Malibu 2.4L. 1997, 1998 ... Alero 2.4L. 1999 .

most MAP sensors, are located right after the air filter it's probably a silver box with an electrical sensor to it

I REPLACED CRARK SENSOR HAS NO SPARK 02 E320

Honda's do not use a mass air flow (MAF) sensor. They use a manifold air pressure (MAP) sensor. The MAP sensor measures vacuum vs the MAF sensor measuring air flow/temperature. No real reason to clean a Honda MAP sensor. Are you having engine performance/idle problems? --------------------------------------------------------------------------------
Digimaster 3

They have both. If you have a 3.1/3.4L, the map sensor is located at the rear of the engine compartment directly beside the ignition coils. If you have a 3.8L, I believe it is located at the front of the engine (right side of engine bay).

Here you go.

ITS INTHE INTAKE MANIFOLD MAP STANDS FOR MANIFOLD ABSOLITE PRESSURE THE SERVICE CODE SHOULD BE PO1106 HIGH VOLTAGE OR PO1107 LOW VOLTAGE IF YOU DON;T HAVE THESE CODES THEN ITS PROBELY NOT THE MAP SENSOR REPLACING COMPOUNETS SHOULD BE THE LAST STEP FORM A PLAIN IM NOT SAYING MAP IS NOT THE PROBLEM BUT BLINDLY REPLACEING SENSORS CAN BE A COSELY MISTAKE GET CODES

VERY SIMPLE!!!!!

4.7L The MAP sensor is located on the front of the intake manifold. An O-ring seals the sensor to the intake manifold.

1. Disconnect electrical connector at sensor.
   
2. Clean area around MAP sensor.
   
3. Remove 2 sensor mounting bolts.
   
4. Remove MAP sensor from intake manifold.
   

To Install:

1. Clean MAP sensor mounting hole at intake manifold.
   
2. Check MAP sensor O-ring seal for cuts or tears.
   
3. Position sensor into manifold.
   
4. Install MAP sensor mounting bolts (screws). Tighten screws to 3 Nm (25 inch lbs..) torque.
   
5. Connect electrical connector.
   

Located on the MASS air flow attatched to the air box

could be your starter failing but that would not explain the shut off..could be a sensor within the engine i would have the alternator tested too..