Question about Cars & Trucks

Open Question

Replacing 120 amp alternator fuse on 2005 toyota camry se

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

projdoc
  • 2236 Answers

SOURCE: replace alternator belt only for 1993 toyota camry

loosen the mounting bolts on the alternator, remove the old belt, replace with the new belt, slightly tighten the top mounting bolt, pull the alternator up until the belt is tight or if there is an adjustment bolt, crank down until tight (shouldn't bow more than 1"), and tigten other hardware.

Posted on Aug 12, 2009

superjorge1
  • 8 Answers

SOURCE: Toyota Avalon 120 amp main fuse removal.

you have to loosen the mounting bolts on the fuse panel and on the bottom side the fuse is held in by 2 8 millimeter bolts.

Posted on Nov 17, 2009

Testimonial: "Very helpful and exactly right. Saved my neighbor a towing charge to the dealer. His car is back up and running. Thank you!!! "

ZJLimited
  • 17970 Answers

SOURCE: how do i replace a 120 amp fuse step by step on a

There are several fuse blocks. They are located in the engine compartment, behind the right side kick panel, under the instrument panel or behind the left side kick panel.

REPLACEMENT
If any light or electrical component in the vehicle does not work, its fuse may be blown. To determine the fuse that is the source of the problem, look on the lid of the fuse box as it will give the name and the circuit serviced by each fuse. To inspect a suspected blown fuse, pull the fuse straight out with the pull-out tool and look at the fuse carefully. If the thin wire that bridges the fuse terminals is broken, the fuse is bad and must be replaced. On a good fuse, the wire will be intact.

Sometimes it is difficult to make an accurate determination. If this is the case, try replacing the fuse with one that you know is good. If the fuse blows repeatedly, then this suggests that a short circuit lies somewhere in the electrical system and you should have the system checked.

544e23d.jpg

Fig. Once the cover is removed from the fuse box, you can identify each fuse and relay

73828f0.jpg

Fig. All circuit breakers and fuses pull out quick easily

When installing a new fuse, use one with the same amperage rating as the one being replaced. To install the a new fuse, first turn off all the electrical components and the ignition switch. Always use the fuse pull-out tool and install the fuse straight. Twisting of the fuse could cause the terminals to separate too much which may result in a bad connection. It may be a good idea to purchase some extra fuses and put them in the box in case of an emergency.

b7627a0.jpg

Fig. Relays can be removed by pulling them from the block

I hope helps with this (remember rated this help) Good luck.

Posted on Dec 28, 2009

ftw1952
  • 10319 Answers

SOURCE: how do you replace the 100 amp alternator fuse in

it pulls out and the new one simply pushes in. they are just like a wall plug in your home

Posted on Feb 13, 2010

  • 1 Answer

SOURCE: We need to replace the 120 amp alternator fuse but

the fuses blot in from the side you have to take the fuse box cover off first then you will see how it works

Posted on Jun 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace 100 amp alternator fuse in 1998 toyota camry


That's because this fuse is bolted on inside the fuse box, you'll need to remove the fuse box and turn it upside down to take the lower cover off and the electrical connectors, then you can access the 8mm bolts that connect the fuse to the main wires

Mar 06, 2014 | 1998 Toyota Camry

2 Answers

How to replace voltage regulator on 1990 Toyota camry.


Assuming the regulator is inside the alternator, as most are,
you have to remove the alternator from the car,remove the
4 long bolts that hold the 2 halves together,then remove the
screws or bolts holding the regulator

I suggest you see if the regulator is avail
You may be better to go to an auto electric shop
that does just that, & you may be able to buy the
regulator there ,or wait while they install it & test
to see if it needs replacing.

May 30, 2012 | 1990 Toyota Camry

1 Answer

I have a 2005 Camry Toyota with 2 cigarette lighters but neither one works. I checked the fuse; it was fine but I still replaced it. I can't use my GPS or charge my phone. If anyone has a solution...


check to see if power is going to the cig, outlets. I believe on the camry there is a 2nd fuse for lighter outlets. it is marked as power point " A" fuse located in fuse box. it should be a 15 amp fuse. good-day !! top row.

Jul 24, 2011 | Toyota Camry Cars & Trucks

2 Answers

HOW DO YOU GET TO THE 100 AMP ALTERNATOR FUSE TO CHANGE IN 1998 TOYOTA CAMRY 2.2 LITER


not taped in harness it is bolted into fuseblock on outside of fuse block are 4 little locks holding in part of fuse block using small screwdriver release locks by prying outwards while pulling up on 100 amp fuse when it has released enough it will expsoe the bolts holding in the 100 amp fuse one side is an 10mm the other is a 8mm MAKE SURE YOU DISSCONECT THE BATTERY 1ST

Apr 21, 2010 | 1998 Toyota Camry

1 Answer

2005 Toyota Camry. Stopped the car; few hours


Have the battery and alternator checked by a mechanic or auto parts store. As it is, it would seem your battery needs to be replaced, but if your alternator is bad then your battery may be good and you would just need to replace the alternator and charge the battery.

Jan 05, 2010 | Toyota Camry Cars & Trucks

1 Answer

2005 camry were is the fuse for the (lighter) 120 outlets


your car only has 12volts, not 120v. 120v. is the power you have in your house. the fuse will be located in the main fuse pannel around and under the left side of the steering wheel. Refer to the owners manuel for its location.

Nov 18, 2009 | 2000 Toyota Camry

1 Answer

07 Camry SE Sun Visor Broken


I had the same thing happen to my Sequoia. They replaced it under warranty when I complained.

Sep 24, 2009 | 2007 Toyota Camry

1 Answer

Alternator fuse replacement


you dont say what type of fuse it is toyota changed the fuse types a couple of times if its a spade type buy a new one and take a good look at it, because the alternator puts a lot of amps the fuse will be 25 to 30 amps.Please note before you attempt to carry out this procedure disconnect the battery,your old fuse is most likly melted so it might neet a bit of TLC to get it out ;look at the new one and see how it fits this will give you a fair idication how to proceed ,if you get it out without breaking it proceed and fit new fuse;lets pause for thought why did it happen in the first place,i think a new or good second hand alternator might be the way forward.adrian

Feb 15, 2009 | 1995 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

968 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...