Question about 2003 Kia Spectra

1 Answer

Brake peddle going to the floor - 2003 Kia Spectra

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Check your fluid level and if its out you might have a line leaking or a hole in the line or one of your calipers went bad hopefully its just low of fluid
hope this helps

Posted on Feb 20, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 GMC Duramax i installed a new master cyclinder my brakes hold untill i start my truck then they go to the floor


Bleed the brake system, You should have bled the master cyl on the bench before installation..

May 12, 2014 | 1991 GMC G3500

1 Answer

Breaks go to the floor


Then you have a massive leak somewhere as the brake peddle should not go all the way to the floor without some low break fluid indication. I would check brakes at each wheel as something isn't right or your not seeing it. Have someone pump the pedal and look to see if after the wheel is removed that the brake actually tightens and loosens. Remember that 4 wheels means 4 brakes, but master brake cylinder (where you add brake fluid) could be bad.
tandem-master-cyl2.gif


May 06, 2014 | Pontiac Grand Prix Cars & Trucks

1 Answer

Brake problem


try adjusting the rear brakes up correctly
the spring that holds the shoes together pushes all the brake fluid back into the reservoir and each application has to move the shoes back into contact with the drum
that is enough to get the pedal close to the floor

Apr 01, 2017 | 1997 Chevrolet S-10 Pickup

1 Answer

How do i bleed the brakes on my 1984 ford mustang never done it before


same as any nother car. take off mastercylinder cap. get a helper set in the drivers seat. apply pressure to the brake peddle. with a box or tube wrench break the fluid *** on the top of the calliper/back of drum loose. foot pressure on peddle should push it to the floor -hold it on the floor! tighten the *** on the caliper/drum tight-ish. not over tight. then let peddle up off floor. pump till you get resistance/tighteness. hold pressure on peddle, loosen *** again and peddle will go to floor again tighten ***, lift up peddle pump for pressure. repeat untill all air is out of line/ or fluid runs out clear. never let the master cylinder get low on fluid. have plenty on hand. repeat for all 4 tires.

Aug 10, 2012 | 1984 Ford Mustang

1 Answer

We replaced pads& callipers, bleed lines/ brake peddle goes to floor.brakes work but peddle still goes to floor.help!!!!!!!!!!!!


Check the vacuum hose going to the brake booster mounted on the firewall in front of the driver in the engine compartment. If that is intact and connected with no holes then the problem is the Master Cylinder.

Jan 08, 2011 | 1999 Toyota Corolla

1 Answer

I HAVE A 95 F250 AND THE BRAKE PEDAL GOES TO THE FLOOR. I HAVE REPLACED THE MASTER CYLINDER TWICE AFTER BENCH BLEEDING, REPLACED THE BRAKE BOOSTER . BLED THE SYSTEM 3 TIMES AND THE BRAKE PEDAL STILL GOES...


You need to check wheel cylinders, the only way that the brake peddle will go to the floor like that is if there is a lose of fluid pressure somewhere .

Dec 29, 2010 | Ford F-250 Cars & Trucks

1 Answer

Brake peddle will stop vehicle, but if I keep pumping, the brake peddle will go to the floor. Is this the booster or master cylinder?


this sounds like the master cylinder check the rear brakes to make sure that they are not leaking break fluid.

Good luck

Dec 02, 2009 | 2003 GMC Envoy

1 Answer

Brake peddle hits the floor when engine turned on


did you set up the brakes make sure that it is set

Aug 08, 2009 | 1997 Ford F350 Crew Cab

Not finding what you are looking for?
2003 Kia Spectra Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76682 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...