Question about 2008 GMC Sierra 1500

Open Question

Crew cab rear windows will not go up

When you push down on the button to put the rear windows down, they go down but when you pull it up to put the windows up they won't go up. Can only do it from the drivers side in the front.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 127 Answers

SOURCE: pass. side front and rear power windows stopped working

if they only stoped working on the passengers side I would check the wirring going into passengers side door for a broken wire, or right at the passengers side kick panel.

Posted on Nov 18, 2009

  • 1 Answer

SOURCE: what is speaker size front and rear in 2002 GMC

Fronts are 6.5, rear passenger doors are 5.1/4, and the very rear im still trying to figure out...

Posted on Oct 31, 2010

  • 55 Answers

SOURCE: what is the button under

You most likely locked the child lock. They usually have a release button located lower so that a child can't just slide it back.

Posted on May 28, 2011

GodBlessU
  • 3513 Answers

SOURCE: I Have a 2006 GMC 2500HD 4x4 with a 6 liter gas,

Hi,


Thank you for contacting fixya.com.


The problem is the Freon pressure is low. Get it recharged and the problem should disappear. Also check for stuck heater/water valve.


Please get back to us if you have further query else please accept the suggestion.


Posted on Jun 09, 2011

GodBlessU
  • 3513 Answers

SOURCE: How do you remove the

Hi,


Thank you for contacting fixya.com.


If you have the leather seats, there are clips that prevent them from being extracted easily. On front seats some are released by squeezing the seat back cushion around the base of the head rest posts or when you flip the seat forward the clip is released. Otherwise, remove the carpeted hard back, usually held in with pop clips, to access the head rest post clips. Slide the clips off and remove the head rests.

Also check if there is a little hole in each plastic base of the metal bars. You need a very small screwdriver, allen key or paperclip to insert into the holes while pulling up on the headrest and it will come off.


Please get back to us if you have further query else please accept the suggestion.



Posted on Jun 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Crew Cab driver side power window goes down but not back up again. If I give it a small tap right below the buttons it goes up. Is it the motor?


more then likely a bad connection on the switch or motor. pull out switch and look for signs of corrosion. they get wet from rain while the window is down

Mar 15, 2013 | 2001 Nissan Frontier Crew Cab

1 Answer

Is the fuel reset switch on my 2003 f250 pushed in or out


is the button up if so it has been knocked off and need to reset it to do so you simply push the button on the shutoff down and it should run again

Jan 03, 2012 | 2003 Ford F250 Super Duty Crew Cab

1 Answer

The electric rear sliding window does not work. Where is the fuse located? 2005 Ford F 150 Lariat Crew cab.


If the power windows still work, it is not a fuse issue, they share the same fuse ( F401 form the accessory delay relay )

Either the switch or the motor is the cause.

When you press the button to the close direction ( with the window closed ) do the lights dim ( headlamp / interior lamps ) ?
If they do, the window is getting power in that direction, so it could be the switch for the open direction or the motor, or something in the track.

If you pull down the overhead console ( the non rail one is open the sun glass compartment, and pull down on each rear corner, it is held up with spring clips ) the wires to the slider are Red w/ yellow stripe and yellow w/ light blue stripe.
If you apply power to these wires, one direction is open, the reverse is close. Test direct to the wires to know if the slider motor is the issue or the switch.
sscullys_86.jpg

Check the entire track for obstructions

To get the slider motor, you need to remove the rear seat back
sscullys_87.jpg
sscullys_88.jpg
sscullys_89.jpg

Jan 21, 2011 | 2005 Ford F-150

1 Answer

How to take out rear seats in a 2000 ford f250 lariat


crew cab,use a 50 torx in front bolts ,15mm on a ratchet on back bolts slide seat belt buckles throu seat crack ,fold rear of seat down ,lay seat with hinge toward floor slide out door (note watch brackets ,will scratch door pannals)

Aug 07, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

I rolled my driver's side front window down all the way and it won't come back up. When I push the button, it doesn't make a sound or anything. Don't know if its just stuck or damaged. The truck I have is...


you'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. and disconnect the window switch and you can test that.. if it's not that. then you may have a broken actuator or motor. You can then pull off the weather seal in order to see the inside of the door....

Aug 20, 2009 | 1997 Ford F350 Crew Cab

1 Answer

2003 F250 Power Windows won't work


check fuses 35 & 41 (10 amp, red).
it also shows an accesory delay relay in the fuse panel.
And fuse 601? 30 amp.

make sure you don't have lock-out on driver switch panel activated.

Power Window System
Features and Operation
NOTE: The accessory delay feature will allow power window operation up to 10 minutes after the ignition is off or until a door is opened.
If equipped with power windows, the window control switch (14529):
  • will operate the power windows only when the ignition switch is in the RUN or ACC position.
  • is located on each front door trim panel, and Crew Cab and Excursion rear door trim panel.
  • may be used to raise or lower the driver side, passenger side and rear windows from the LF control on the driver side, or the passenger window from the passenger switch.
  • includes a one-touch down (OTD) feature for the driver door window.
  • can partially lower the driver side window when the LF window control switch is depressed half way (first detent).
  • will completely lower the driver side window when the LF window control switch is fully depressed and then released (second detent).
Power Window System — Modes of Operation
There are two modes of operation for the power window system.
Manual Mode
When the LH window control switch is pressed to the first down position, the window will move down until one of the following conditions are met:
  • The LH window control switch is no longer in the first down position.
  • The LH window control switch is pushed to the OTD position, causing the windows to enter auto mode.
Auto Mode
Auto mode provides the OTD feature. The OTD feature is activated when the LH window control switch, for the LH window, is pressed to the second down position.
Auto mode will be terminated when any of the following conditions are met:
  • The LH window control switch is pushed to the UP position.
  • The LH window control switch is released (OFF position) and then moved to the DOWN position (first detent) or OTD position (second detent).
  • Note: Delayed accessory feature must be active.
The OTD feature is controlled by the window control switch.

---------------------------------------------------------
Condition Possible Sources Action
  • All power windows are inoperative
  • Fuse(s).
  • Circuitry.
  • LF window control switch.
  • Accessory delay relay.

May 23, 2009 | 2003 Ford F250 Super Duty Crew Cab

1 Answer

How do I access the rear inlet fitting to change the fuel filter on a 1997 F350 crew cab with the 460 and dual tanks?


okay let me clarify the fuel filter if its on the frame will have a strap attaching it to the frame usually remove with a 10mm socket and an extension and rachet.on the ends of the filter you will either have a flare fitting(usually 14&16mm) wrench or a black cover with a white clip push hose toward filter pull out clip wiggle off.if its too hard for you to get to remove the shield other wise if your a contortionist it should be easy

Apr 05, 2009 | 1997 Ford F350 Crew Cab

1 Answer

Replacing gear shift handle on column


under the cylnder is a very small hole. put the key in the switch and turn it until all the dash lights come on. then take a very still object like a small punch and push it in the small hole and pull out the ignition switch. sometimes u might have to hit the punch to push in the button.

Oct 18, 2008 | 1997 Ford F350 Crew Cab

1 Answer

Only rear power window wont work, front are fine.


the window motors are most likely no good

Aug 15, 2008 | 2004 Chevrolet Colorado

Not finding what you are looking for?
2008 GMC Sierra 1500 Logo

Related Topics:

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...