Question about 2004 Dodge Ram 1500

Open Question

2004 dodge ram 1500 4.7 shut off while driving and will not start. replaced battery and checked all fuses. still will not crank

Cut off while driving. will not crank. replaced battery, and checked all fuses(they are all good), replaced crankshaft positioning sensor. will still not crank but does turn over

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: brake pad replacment on 2004 Dodge Ram 1500

Remove two bolts holding caliper on and pull up as hard as you can on the caliper. Wiggling back and forth at the same time helps.

Posted on Aug 02, 2008

motor1258
  • 6674 Answers

SOURCE: belt diagram 2004 5.7 liter engine dodge ram 1500 1/2 ton 4x4

click on this link, and scroll down to 5.7L

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800ba71e

Posted on Dec 22, 2008

  • 840 Answers

SOURCE: passanger side mirror replacement on 04 dodge ram 1500?

very easy take the mirror inside cap off if you can not get to the 3 bolts then you will have to take trim panel off to take trim panel off look for plastic caps take them out and unscrew them then pop out the bottom of the door and pop the sides out then lift up and out should be loose enough for the bolts now/ 10mm bolts 3 Please rate my response thank you very much

Posted on Feb 02, 2009

  • 3 Answers

SOURCE: 2004 dodge ram 1500 rear brake light out how to replace?

Well once the tail gate is open and you take out the 2 screws on the light fixture . the light assembly shall pivot towards the outside of the box. some manipulating but the assembly shall come out.
The bulb needs a simple twist and pull .... Plug and play..

Posted on Apr 30, 2009

  • 14036 Answers

SOURCE: 2004 Dodge Ram wont start

yep its the ignition switch.check all fuses in power distribution center.if they ok.its the switch.

Posted on May 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

'04 Dodge Ram 1500 4.7L stalls while driving 40+ mph then restarts on its own.In my driveway now,won't start at all.Replaced fuel pump and there's no code coming up. Any suggestions of what's wrong?


Start with basic testing of electrical circuits ! Does it crank ? meaning when you turn the key to the start position does the engine spin but doesn't start and run or it doesn't do anything when you turn the key to the start position ? Battery good , cables an connections ?

Dec 16, 2016 | 2004 Dodge Ram 1500

1 Answer

2004 ram 1500 wont start


Could be coils,fuel filter,how old spark plugs.

Apr 24, 2013 | 2004 Dodge Ram 1500

1 Answer

2004 Dodge Ram 1500 won't start every other time...i have replaced the battery, starter, battery cables and ground.


Check the fuel pump, Check the fuel filter first though. Get under the car when it wont start hit the gass tank with a hammer while some one else trys to start it that will tell you if it's the fuel pump.

Jan 27, 2011 | 2004 Dodge Ram 1500

1 Answer

Where do I find the fuses under the instrument panel on my 2004 Dodge Ram 1500?


The 2004 1500 hemi does not have a fuse box inside the cab, they are all under the hood in the fuse box near the battery. Hope this helps

Dec 13, 2010 | 2004 Dodge Ram 1500

2 Answers

2004 Dodge Ram 1500 blown fuel pump fuse. 20 amp fuse keeps blowing to fuel pump. local mechanic put on scope drawing 10 amps. electrical waves look correct. followed wires from fuse panel to fuel pump,...


I DONT KNOW IF U ARE A MECHANIC BUT THE BEST WAY TO SOLVE THIS PROBLEM IS GETTING A WIRING SCHEMATIC. IT WILL HELP U SEE IF ANYTHING ELSE IS WIRED INTO THE CIRCUIT BESIDES THE FUEL PUMP

Jul 27, 2010 | 2004 Dodge Ram 1500

1 Answer

I have 2001 dodge ram 1500 with a 5.2. when i try to start it cranks slowly, once started it wont idle unless i hold down the gas pedal??


Hi I litoshop first you have to check battery voltage while starting and have your truck scanned it sounds like there's a sensor is failing western auto or pep boy usually give a free scan to there customer good luck

Sep 02, 2009 | 2004 Dodge Ram 1500

1 Answer

2004 Dodge 1500 blowing fuses


sound like a short try looking behind the radio for a burnt or bear wire

Sep 12, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...