Question about 1984 Chevrolet Chevy

1 Answer

Why wont my running lights on my 1984 Chevy truck work

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Your ground might be off at the lights or a fuse may be blowed hope it helps

Posted on Feb 20, 2012

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 383 Answers

SOURCE: i have 1995 chevy 3500 truck my flashers and my

does that have a third brake light ( one on back of cab) if that one don't work then it more than likely brake light switch (on brake pedal) or fuse.

if that one works but other ones dont more than likely bad ground

Posted on Feb 13, 2010

fixitriteman
  • 431 Answers

SOURCE: turn signals wont work

The element are serpent in the lights bulb the turn signal and brake usually share the same one but the running or park light are not shared with the turn . so if none of the light for the turn signal light then you will want to look for your flasher control it is ether in or near the fuse box or under dash by steering wheel shaft,,you should also check grounds at light socket if we can be of any further assistance please feel free to ask hope this gives you a place to start .Thank You..

Posted on Mar 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My brake lights work and head lights but no running lights on my 1991 chevy truck 4x4


Did you check the park fuse, or the orange wire going into the headlight switch for power ?

Feb 09, 2013 | 1991 Chevrolet C/K 2500

1 Answer

Engine dies after driving awhile have to wait for awhile then will start back up? 1984 chevy p/u two wheel drive


sounds like your fuel pump is going out- Happens after a while- the pump will operate and after it gets hot it wont pump the proper pressure and the engine will stall out and be impossible to start until the pump cools then it starts up again

Apr 05, 2010 | 1984 Chevrolet Chevy

1 Answer

Turn signals wont work, all other lights work. turn signals wont turn on. 1984 Military Chevy Blazer


The element are serpent in the lights bulb the turn signal and brake usually share the same one but the running or park light are not shared with the turn . so if none of the light for the turn signal light then you will want to look for your flasher control it is ether in or near the fuse box or under dash by steering wheel shaft,,you should also check grounds at light socket if we can be of any further assistance please feel free to ask hope this gives you a place to start .Thank You..

Mar 30, 2010 | 1984 Chevrolet Blazer

1 Answer

My head lights only work when i keep the starter ingaged, also not charging. new alt batt and starter. 1984 chevy 3/4 ton


Replace the ignition switch,it only has aux.out put power in start position,not in the run position.

Jan 03, 2010 | 1984 Chevrolet C1500

1 Answer

1984 K10 burns up coil..replaced several times won't start..was running


might need new spark plugs or wires. sounds like the coil is working too hard to keep it running.

Dec 30, 2009 | 1984 Chevrolet Chevy

1 Answer

We have a 1984 chevy silverado headlight power.


everything power usually runs through the fuse box

Sep 19, 2009 | Chevrolet Silverado 1500HD Cars & Trucks

1 Answer

Truck wont start lights work stero wont turn on when the key is turned on


Sounds like your fusible links are bad. There are two down at the starter. They look like a rubber plug in the middle of the wire, just cut them out and splice the wires back together. If they have been cut out, then check them for corrosion and clean them up. Use heat shrink tube instead of tape to cover the joints. It seals better.

Jul 12, 2009 | 1984 Chevrolet Chevy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...