Question about Nissan Frontier

Open Question

Firing order for 2000 nissan frontier - Frontier Nissan Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dealt_soul
  • 296 Answers

SOURCE: 2000 NISSAN FRONTIER VIBRATION

Check tire balance, rear wheel bearings and i would replace u joints front and back, anyway if they have never been repaced.

Posted on Feb 15, 2009

Ad
polarcycle
  • 1392 Answers

SOURCE: replace seat belt on 2000 nissan frontier

Should be a T50 or T55. Should have a cover over the bolt. Remove the cover, and remove the bolt.

Posted on Jun 10, 2009

  • 2 Answers

SOURCE: change brake light bulb on a 2000 Nissan Frontier

The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.

Posted on May 04, 2010

  • 5 Answers

SOURCE: I need to remove fuel pump from 2000 nissan fronti...

the fuel pump is located in the gas tank.

Posted on Jun 14, 2010

  • 14585 Answers

SOURCE: 2000 nissan frontier knock sensor code & distributor

no but the knock sensor does send a signal the ecm and it will ****** or advance the distributor timing

Posted on Jun 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wirig diagram of nissan frontier 2000 meter automatic


This site will give you the factory service manual for your frontier. You will need to choose the specifics for your truck.
Nissan Frontier Factory Service Manuals

Apr 10, 2014 | 2000 Nissan Frontier

2 Answers

My nissan frontier 2000 v6 is not firing what can be the cause


Sparks plugs, spark plugs wires, coils, defective battery or fusible link.
Ignition swith faulty

Jun 26, 2010 | 2000 Nissan Frontier

1 Answer

2000 nissan frontier knock sensor code & distributor


no but the knock sensor does send a signal the ecm and it will ****** or advance the distributor timing

Jun 14, 2010 | 2000 Nissan Frontier

1 Answer

Replace valve cover gaskets on a 2000 frontier v 6


torque specs for the rocker cover (valve cover) screws:
9 - 26 inch lbs
step one- 9 in lbs step 2- 18 in lbs step 3- 26 in lbs
tightening order (see diagram below)


2aa1d8f9-c423-4221-bbed-38a4f9049ad6.png

May 27, 2010 | 2000 Nissan Frontier

1 Answer

2000 frontier. died while driving now getting no fire. wut do i do? fuses are good and fuel pump is fine. just imeditaly quit firing.


Scan for codes. How do you know the fuel pump is fine? Did you test it? Did you crank it and look for spark?

Feb 20, 2010 | 2000 Nissan Frontier

2 Answers

What is eng oil capacity for a nissan frontier 4 banger 2000 model


Including filter; the oil capacity for a 2WD, 2000, Nissan, Frontier, 4cyl (Ka24de) is 3-3/4 quarts. Straight out of the Haynes manual.

Nov 28, 2009 | 2000 Nissan Frontier

1 Answer

Seat belt height adjuster.


it simply snaps on and off but you have to remove the bolt in order to completely remove the cover itself just pry up from the bottom lip and it should open up like a hinge and expose the nut

Jun 14, 2009 | 2000 Nissan Frontier

1 Answer

Left and Right color coding for 2000 Nissan Frontier


Right turn - Green w/red stripe
Left turn - Green w/yellow stripe

Dec 21, 2008 | 2000 Nissan Frontier

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...