Question about 1991 Lincoln Continental

1 Answer

Where do i find the dct plug for 1991 lincoln town car

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Lincoln dealer ship or junk yard

Posted on Feb 19, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 625 Answers

SOURCE: key pad code

what do you mean? with key code? do you ned it for the door
if you need it to unluck the door there is a module in the truk by the speakers and they have the code stamped on it

Posted on May 28, 2008

  • 6982 Answers

SOURCE: Fuse Box Diagram

Fuses usually are labeled. However, sometimes sub-systems are not labeled. The quickest way to find your fuse is to get a volt meter or test light and check the fuses. With the key on (to energize all circuts),and the meter or probe (-) end connected to a good ground, probe into the small spaces at each end, on the back of each fuse. (if you look at any fuse while removed, you can see how esch connector spade is open on the back side) You should have 12volts at each space. Any fuse that has no voltage should be replaced. If fuse blows immediately, there is a short in that system somewhere.

Posted on Dec 16, 2008

old marine
  • 1992 Answers

SOURCE: need routing diagram for 2000 lincoln town car serpentine belt

There's a diagram at this link.

Posted on May 11, 2009

heavymetal77
  • 721 Answers

SOURCE: changing spark plugs on lincoln town car

Remove the spark plug wires, remove the spark plugs,replace them. Do this one cylinder at a time if you never did it. On that year you may need to remove the upper intake to access the plugs on one side. In that case go to a shop. This would not be a novice job.

Posted on Jun 28, 2009

marty_gto
  • 14 Answers

SOURCE: 99 lincoln town car wont start?

make sure both plus amd minus turnimals are tight loss conection wont start the car you might get a clicking or just nothing

Posted on Oct 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacing Flasher Relay


it is a aluminum cylinder plugged in at the fuseblock

May 05, 2013 | 1991 Lincoln Town Car

1 Answer

1991 Lincoln town car window off track


Most likely a broken regulator. That's the part that attaches the motor to the glass. Ford/Lincoln use large rivets to hold everything together. Best left to a professional.

Apr 08, 2012 | 1991 Lincoln Town Car

1 Answer

Ignition timing on1991 lincoln town car


its electronic-controlled by sensors--get a haynes manual or search mitchell -for repair--if firing is off new plug wires distributer cap or ign module cud be problem

Sep 01, 2011 | 1991 Lincoln Town Car

1 Answer

1991 lincoln towncar freeze plugs leaking.


YOU WILL HAVE TO DRAIN THE COOLANT FROM THE VEHICLE, THEN POP OUT FROST PLUGS AND REPLACE THEM WITH NEW ONES AND RESEAL THEM.

Jan 24, 2011 | 1991 Lincoln Town Car

1 Answer

Need spark plug calbration for 1991 lincoln town car and firing order


For 1991 Lincoln Town Car 4.6 liter SOHC V-8 VIN "W" check Firing Order...

fda463b.gif

Make: LINCOLN
Model: TOWN CAR - CARTIER
Year: 1991
Engine: V8 - 4.6L - FI - - GAS
Spark Plug Champion:
Part Number RS14YC6 OE GAP .054" (Original Equipment Manufacturer and/or Original Equipment Equivalent)

Hope help with this (remember rated this post) Good luck.

Feb 22, 2010 | 1991 Lincoln Town Car

1 Answer

What is the problem with a 1991 Lincoln Town Car if it misses or jerks at a slow speed?


More than likely a fuel problem. Try the fuel filter or check pressure from the fuel pump. If it misses at higher rpm it coiuld be spark plug wires or plugs.

Jun 15, 2009 | 1992 Lincoln Town Car

1 Answer

1991 lincoln Continental Dash Board completely out


check ignition fuse and fuse link.if all is good.looks like ignition switch is bad.

Jun 02, 2009 | 1991 Lincoln Town Car

1 Answer

1991 lincoln town carTail lights and turn signals stopped working


One of the tail light bulbs can be shorted internally.  Replace the tail light bulbs first.  Try this cheap fix first.

Mar 06, 2009 | 1991 Lincoln Town Car

1 Answer

91 lincoln town car. does not idle for long goes dead


It sounds like a vacuum line off somewhere, does your engine light go on?

Feb 10, 2009 | 1991 Lincoln Town Car

1 Answer

1991 Lincoln Mark VII LSC spark plugs and wires


you don't have to worry about a special tool if you are replacing the wires but you will need a 5/8 socket with a rubber boot and an extension and maybe a swival to remove the plugs if there is an auto zone near by they will print you out a diagram for free

Jan 07, 2009 | 1991 Lincoln Town Car

Not finding what you are looking for?
1991 Lincoln Continental Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

fordexpert

Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...