Question about 1999 Oldsmobile Intrigue

1 Answer

What's your problem?where is the air bleeder valve on a 99 oldsmobile intrigue 3.5

I changed the water pump and thermostat but its still overheating

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

1999 oldmobile intrigue over heating. Heat not blowing hot

Posted on Feb 28, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76649 Answers

SOURCE: 2001 oldsmobile intrigue secondary air injection

get yourself a wiring diagram to see what powers up the relay, it is a fuse, have you checked the fuses? also these pumps short out and that is why it is not working and blown out the circuit, replace it before you do anthing, also remember that the pump is powered up by the PCM only during cold start, so 99% of the time it has no power to it.

Posted on Sep 15, 2009

Testimonial: "very helpful, the valves were the problem vacuum leak inside very small but your advice was appreciared and helped me, GM supplied me with bulletins t"

  • 119 Answers

SOURCE: 99 oldsmobile intrigue

The ambient temperature sensor going bad causes this exact problem. I've replaced many of them because when they show outside temp as being below 60 degrees, the A/C control module will shut the compressor off.

Posted on Aug 08, 2008

  • 651 Answers

SOURCE: 2000 oldsmobile intrigue overheating

usually just follow the upper radiator hose. it should be at the end of it.

Posted on Dec 01, 2008

  • 1779 Answers

SOURCE: 2000 Intrigue Oldsmobile over heating

It's probably something much easier and cheaper than that. Have you checked the cooling fan control? It reads the coolant temp, sends info to computer, which signals the cooling fan to go on and off as needed. So, is the fan going on as the temp goes up? If not , check the fan motor and the cooling fan control. Let me know how u make out.

Posted on Mar 21, 2009

johnjohn2
  • 5763 Answers

SOURCE: need to purchase secondary air injection check

i would, get them from dealer, this way you get the right parts, i checked a couple of places also and no luck also, dealer can order parts if they dont stock them, if you want try rock auto.com. i just checked and they can get it.there are two types of engines so make sure you select the right one, good luck hope this is helpful.

Posted on Dec 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I got a 98 Buick century I change the water pump. Thermostat hoses and top and bottom gaskets I put water on the radiator and spitsit right back would you toll me what could be the problem thanks


You have an air bubble inside the cooling system. There is a little bleeder valve by either the thermostat or where the hose goes into the motor. It should look like a bleeder valve on the brakes or just a thumb screw. Anyway you need to open that bleeder when the motor is cool while you are adding the antifreeze. Leave it open just until all air bubbles come out and it's straight antifreeze. Then close it and finish filling the resevior. Run the motor about 10 minutes. Let it cool and then recheck fluid level again.

May 22, 2012 | 1998 Buick Century

1 Answer

Where is the bleeder valve


bleeder valve for the fuel injection is on the fuel rail
for the anti-freeze it should be on top of the thermostat housing
if not there check the pipe above the water pump

Sep 19, 2011 | 2001 Oldsmobile Intrigue

1 Answer

Is there and, if so, where is there a bleeder valave on the cooling system? vehicle over heating after thermostat replacement, water pump replaced etc.


Check on the thermostat housing or the steel line near the thermostat housing. Does the heater blow hot air? If so you probably don't have any air in the system.

Aug 30, 2011 | 2000 Oldsmobile Intrigue

1 Answer

I need to know how much liquid my radiator holds for my 1995 Oldsmobile Achieva?


the rad holds about 1.5 gallons...but if u changed the rad u will need around 3 gallons since the coolant in the engine has also drained out....also open the bleeder valves for the cooling system before filling...these valves r located on the thermostat housing an on top of the water pump outlet pipe...they r brass in color an u will need a 7mm socket on a straight slot screwdrive to open them....u need to open them to allow the air to escape when fill or u can have the system air bound an the engine will over heat an cause damage the the cylinder heads....when coolant runs out of them at a steady stream close them an start the car..do not open them when engine is running....but some cars only have 1 bleeder

Jul 16, 2011 | 1995 Oldsmobile Achieva

1 Answer

I have a 2000 Oldsmobile Intrigue and I have changed the radiator,water pump and thermostat but, its still doing the same thing running hot. And i took it to get a test done on it to see if it's the...


did you try replacing the coolant temp sensor? because i have a 2000 intrigue and it does the same thing... im eliminating possiblities... next after that is the radiator and water pump... just changed the thermostat and flushed the system but does the same thing... so the sensor is next.

May 11, 2011 | 2000 Oldsmobile Intrigue

1 Answer

Where is the bleeder valve to burp cooling system on 99 intrigue with 3.5L


ok there is a 2 inch hose coming from the top of radiator follow it to where it connects to the engine it will look like a goose neck it should be right there

Dec 19, 2010 | 1999 Oldsmobile Intrigue

1 Answer

I've changed the water pump, thermostat and radiator in my 1998 oldsmobile aurora and it still runs hot and leaks. What might be the problem?


where is it leaking from? possible air is in the system you must bleed it on some model there is a bleeder valve on the thermostat housing. possible new thermostat is bad. but not likely, i quess my best advise woould be is to fix the leak and go from there.

Oct 23, 2010 | 1995 Oldsmobile Aurora

1 Answer

Replaced water pump and thermostat still over heats - 96 oldsmobile


you have a air pocket in your system you will need to get the air out of the line. if your thermostat housing has a bleeder valve on it start the car let it warm up to operating temps then crack the bleeder valve until it runs steady with coolant if you do not have a bleeder take the radiator cap off start the engine and let it run until you see the coolant flow through the radiator also do a pressure test on your coolant system to ensure that you dont have any leaks any where. or possibly even a bad head.

Jun 18, 2010 | 1996 Oldsmobile Cutlass Ciera

2 Answers

The temp gauge says the engine is hot but, in


I'm not certain if this engine has coolant bleeder valves, but if it does, make sure there aren't any pockets, particularly around the sending unit. Something is fooling the computer into thinking that things are really, really hot.

Nov 25, 2009 | 2000 Oldsmobile Intrigue

2 Answers

How to 'bleed' the coolant in a 99 Olds Intrigue?


where the top radiator hose goes into the top of the engine is where the bleeder is up on top of where the hose goes in. mine is a copper like flathead screw looking thing ! fill the radiator and loosen the bleeder a little and wait for the coolant to start spraying a straight stream of coolant out of the bleeder! hope this helps!

Jul 07, 2009 | 1999 Oldsmobile Intrigue

Not finding what you are looking for?
1999 Oldsmobile Intrigue Logo

370 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...